Vertical Rotors

A515 Spare rotor vertical storage SP R V S c 1 1 ryes prue) Or no (false)... 

Basically, rotors come in four varieties fixed-angle rotors, vertical tube rotors, swinging-bucket rotors, and zonal rotors. The first three rotors are discussed below. Zonal rotors will be discussed In a later section. 

Cup anemometers have shaped cups mounted on the spokes of a wheel. The cups, under the action of the fluid forces, spin in a horizontal plane about a vertical shaft mounted in bearings. Vane or propeller types use a multibladed rotor, the axis of which is parallel to the flow direction as the rotating member. Both designs are commonly used for wind speed measurement or similar appHcations such as the velocity in ventilation ducts. Because of inertia, anemometers are most accurate under steady conditions. Velocity fluctuations cause readings that are too high. 

A potential problem for rotary valve usage is that they tend to pull material preferentially from the upside of the valve, which can affect the mass flow pattern. Another problem is that once soHd drops from the vane, the air or gas that replaces it is often pumped back up into the bin. In addition, air can leak around the valve rotor. Such air flows can decrease the soflds flow rates and/or cause flooding problems. A vertical section shown in Figure 13 can alleviate the preferential flow problem because the flow channel expands in this area, usually opening up to the full outlet. To rectify the countercurrent air flow problem, a vent line helps to take the air away to a dust collector or at least back into the top of the bin. 

Figure 5-13. The Elliott TH expander is a single-stage hot gas expander with an axial inlet and vertical exhaust. The TH-line expanders range in horsepower from 4,000 to 50,000 and are of overhung rotor construction. The expander consists of four major components the inlet casing and its supports, the exhaust casing, the bearing housing and support system, and the rotor.

The three signals are fed into an oscilloscope as vertical-, horizontal-, and external-intensity marker input. The keyphazor appears as a bright spot on the screen. In cases where the orbit obtained is completely circular, the maximum amplitude of vibration occurs in the direction of the keyphazor. To estimate the magnitude of the correction mass, a trial-and-error process is initiated. With the rotor perfectly balanced, the orbit finally shrinks to a... 

If the turbine is not out of alignment, or the shaft bowed as determined by the vertical and horizontal clearance checks or the appearance of the bearing surfaces, it is not recommended that the rotor be removed. Some turbine designs, however, may require removal of the rotor to facilitate the removal of some bottom sections of the diaphragms or inlet vanes. If the rotor is... 

For horizontal shaft pumps and vertical shaft pumps having no thrust bearing (entire thrust load carried by the motor), the locked-rotor torque required is usually between 5 and 20%, and for vertical shaft machines having their own thrust bearing a locked-rotor torque as high as 40% is sometimes required. 

If there is no resonant condition to modify the resultant vibration phase, then the phase for both vertical and horizontal readings are essentially the same even though the vertical and horizontal amplitudes do not necessarily correspond. In actual practice, this may be slightly off due to other vibration sources such as misalignment. In performing the analysis, what counts is that when the source of the vibration is primarily from imbalance, then the vertical reading phase differences between one end of the rotor and the other will be very similar to the phase differences when measured horizontally. For example, vibrations 60° out of phase vertically would show 60° out of phase horizontally within 20 per cent. 

---