Reinforced thermosetting resin pipe

TABLE 10-21 Recommended Temperature Limits for Reinforced Thermosetting Resin Pipe ... [Pg.77]

D 5686 Standard Specification for Fiberglass (Glass Fiber Reinforced Thermosetting Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type Epoxy Resin, for Condensate Return Lines... [Pg.516]

Chemical resistance of reinforced thermosetting resin pipe in a deflected condition... [Pg.304]

ASTM E1118, Standard Practice for Acoustic Emission Examination of Reinforced Thermosetting Resin Pipe (RTRP), Annual Book of ASTM Standards, Vol. 03.03, American Society for Testing and Materials International, West Conshohocken, Pa., 2004. [Pg.5085]

Glass-Fiber-Reinforced Thermosetting-Resin) Pipe. Applicable for 1 in through 14 in. (25 nun through 350 mm) pipe of polyester or epoxy resins... [Pg.700]

The use and acceptance of buried large-diameter glass fiber, plastic reinforced, filament-wound pipe has increased steadily since the 1950s. Such RP was selected for its superior corrosion-resistance characteristics and installation-cost savings. ASTM standards use the term Reinforced Thermoset Resin Pipe (RTRP). Filament-wound pipe with a double helical angle of continuous-glass reinforcement (discussed later) is but one of several types of RTR pipe constructions. [Pg.326]

DESCRIPTION, CLASSIFICATION, AND TYPICAL USES Thermoplastic Pipe Reinforced Thermosetting Resin Pipe Resins Used for Piping Desirable Qualities of FRP Resins PROPERTIES Physical and Mechanical Flow Properties Chemical Resistance... [Pg.744]

Standard Classification for Machine-Made Reinforced Thermosetting Resin Pipe, ASTM D 2310. (The first three symbols following RTRP designate type, grade, and class the last symbol codes the HDB.)... [Pg.757]

Standard for Reinforced Thermosetting Resin Pipe, AWWA C-950, American Water Works Association, Denver. (Appendix to standards includes much design and installation information.)... [Pg.775]

Another method of manufacture of solid-wall pipe is to extrude and wrap molten sheets or strips of thermoplastic around the outside surface of a tubular mandrel. Where this method is used, this pipe is manufactured to a controlled inside diameter. Continuous fiberglass-reinforced thermosetting resin pipe is generally manufactured in this manner. Some types of spiral-strip-wound composite piping are manufactured by being formed against the inside surface of a tubular fixture. [Pg.705]

Pressure, describes how to test individual pipe specimens and is applicable to both thermoplastic and reinforced thermosetting/resin pipe materials. ASTM D2837 requires that a minimum of 18 failure points as well as a specific distribution of failure points be obtained to develop a full hydrostatic stress rupture curve for a material at a specific temperature. This distribution is shown in Table 32.1. [Pg.711]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...