Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Complexes redox potentials

The structures of many Nin complexes are very sensitive to steric effects these influences are also reflected in the redox potential. Complexes of the cyclam ligand (17-G-X) are particularly stable and may exist as 4-, 5-, or 6-coordinate compounds in the solid state, depending on R. If R = Me both square and sp structures exist in the same unit cell.5... [Pg.844]

Although there is no direct measurement of the oxidation state of plutonium in biological fluids, redox potentials, complexation and hydrolysis strongly favor Pu(IV) as the dominant specie. [Pg.163]

The amplitude of the waves, which is a measure of the amount of the catalyst involved in one oscillatory cycle, is substantially larger in case of the high-redox-potential metal catalysts, than when using the low-redox-potential complexes. [Pg.492]

In an aquo-complex, loss of protons from the coordinated water molecules can occur, as with hydrated non-transition metal ions (p. 45). To prevent proton loss by aquo complexes, therefore, acid must usually be added. It is for these conditions that redox potentials in Chapter 4 are usually quoted. Thus, in acid solutions, we have... [Pg.367]

Electron Transport Between Photosystem I and Photosystem II Inhibitors. The interaction between PSI and PSII reaction centers (Fig. 1) depends on the thermodynamically favored transfer of electrons from low redox potential carriers to carriers of higher redox potential. This process serves to communicate reducing equivalents between the two photosystem complexes. Photosynthetic and respiratory membranes of both eukaryotes and prokaryotes contain stmctures that serve to oxidize low potential quinols while reducing high potential metaHoproteins (40). In plant thylakoid membranes, this complex is usually referred to as the cytochrome b /f complex, or plastoquinolplastocyanin oxidoreductase, which oxidizes plastoquinol reduced in PSII and reduces plastocyanin oxidized in PSI (25,41). Some diphenyl ethers, eg, 2,4-dinitrophenyl 2 -iodo-3 -methyl-4 -nitro-6 -isopropylphenyl ether [69311-70-2] (DNP-INT), and the quinone analogues,... [Pg.40]

A.uxilia driers do not show catalytic activity themselves, but appear to enhance the activity of the active drier metals. It has been suggested that the auxihary metals improve the solubiUty of the active drier metal, can alter the redox potential of the metal, or function through the formation of complexes with the primary drier. Auxihary driers include barium, zirconium, calcium, bismuth, zinc, potassium, strontium, andhthium. [Pg.221]

As a result, the electromotive force (EMF) of the cell is zero In the presence of fluoride ions, cerium(IV) forms a complex with fluoride ions that lowers the cerium(IV)-cerium(IIl) redox potential The inner half-cell is smaller, and so only 5 mL of cerium(IV)-cenum (III) solution is added To the external half-cell, 50 mL of the solution is added, but the EMF of the cell is still zero When 10 mL of the unknown fluonde solution is added to the inner half-cell, 100 mL of distilled water IS added to the external half-cell The solution in the external half-cell is mixed thoroughly by turning on the stirrer, and 0 5 M sodium fluonde solution is added from the microburet until the null point is reached The quantity of known fluonde m the titrant will be 10 times the quantity of the unknown fluoride sample, and so the microburet readings must be corrected prior to actual calculations... [Pg.1026]

The effects of concentration, velocity and temperature are complex and it will become evident that these factors can frequently outweigh the thermodynamic and kinetic considerations detailed in Section 1.4. Thus it has been demonstrated in Chapter 1 that an increase in hydrogen ion concentration will raise the redox potential of the aqueous solution with a consequent increase in rate. On the other hand, an increase in the rate of the cathodic process may cause a decrease in rate when the metal shows an active/passive transition. However, in complex environmental situations these considerations do not always apply, particularly when the metals are subjected to certain conditions of high velocity and temperature. [Pg.307]

As may be seen from the potential-pH diagram " (Fig. 6.3) platinum is immune from attack at almost all pH levels. Only in very concentrated acid solutions at high redox potentials (i.e. under oxidising conditions) is there a zone of corrosion. This accounts for the solubility of platinum in aqua regia. Platinum is also prone to complex-ion formation, and this can lead... [Pg.930]

Environment (aqueous) Lower the redox potential of the solution, i.e. lower Increase the potential of the M /M equilibrium, i.e. increase, Lower a by raising pH, remove dissolved O2 or other oxidising species Increase / + by removing complexants (e.g. CN ions) from solution... [Pg.1459]

Variamine blue (C.I. 37255). The end point in an EDTA titration may sometimes be detected by changes in redox potential, and hence by the use of appropriate redox indicators. An excellent example is variamine blue (4-methoxy-4 -aminodiphenylamine), which may be employed in the complexometric titration of iron(III). When a mixture of iron(II) and (III) is titrated with EDTA the latter disappears first. As soon as an amount of the complexing agent equivalent to the concentration of iron(III) has been added, pFe(III) increases abruptly and consequently there is a sudden decrease in the redox potential (compare Section 2.33) the end point can therefore be detected either potentiometrically or with a redox indicator (10.91). The stability constant of the iron(III) complex FeY- (EDTA = Na2H2Y) is about 1025 and that of the iron(II) complex FeY2 - is 1014 approximate calculations show that the change of redox potential is about 600 millivolts at pH = 2 and that this will be almost independent of the concentration of iron(II) present. The jump in redox potential will also be obtained if no iron(II) salt is actually added, since the extremely minute amount of iron(II) necessary is always present in any pure iron(III) salt. [Pg.320]

The standard redox potential is 1.14 volts the formal potential is 1.06 volts in 1M hydrochloric acid solution. The colour change, however, occurs at about 1.12 volts, because the colour of the reduced form (deep red) is so much more intense than that of the oxidised form (pale blue). The indicator is of great value in the titration of iron(II) salts and other substances with cerium(IV) sulphate solutions. It is prepared by dissolving 1,10-phenanthroline hydrate (relative molecular mass= 198.1) in the calculated quantity of 0.02M acid-free iron(II) sulphate, and is therefore l,10-phenanthroline-iron(II) complex sulphate (known as ferroin). One drop is usually sufficient in a titration this is equivalent to less than 0.01 mL of 0.05 M oxidising agent, and hence the indicator blank is negligible at this or higher concentrations. [Pg.365]

The absolute rate constants for attack of carbon-centered radicals on p-benzoquinone (38) and other quinones have been determined to be in the range I0M08 M 1 s 1.1 -04 This rate shows a strong dependence on the electrophilicity of the attacking radical and there is some correlation between the efficiency of various quinones as inhibitors of polymerization and the redox potential of the quinone. The complexity of the mechanism means that the stoichiometry of inhibition by these compounds is often not straightforward. Measurements of moles of inhibitor consumed for each chain terminated for common inhibitors of this class give values in the range 0.05-2.0.176... [Pg.271]

Chelant corrosion (chelant attack) Complexing of soluble Fe, Cu, and CU alloy ions. (Excess chelant and oxygen leads to change in redox potential and corrosion develops.)... [Pg.272]

In principle it should be possible to predict quantitatively the reactivity of such species containing nucleophilic homolytic leaving groups towards diazonium ions, by using a dual parameter equation. One parameter serves as a measure of the donor property of the particle the other parameter is the redox potential. However, the complex nature of kinetics of homolytic dediazoniations is likely to be a great obstacle in attempts to calculate rate constants referring only to the radical-generation step. [Pg.195]

Ultraviolet spectroscopy metal in water complexes, 2, 309 redox potentials and, 1,498 Ultraviolet-visible spectroscopy, 1, 243 Umbellicomplexone metallofluorescent indicator, 1. 558 Undecametallic complexes, 1, 167 Uni thiol chelating agent heavy metal poisoning, 6. 767 Unsaturated compounds hydrogenation... [Pg.241]

The Table shows a great spread in Kd-values even at the same location. This is due to the fact that the environmental conditions influence the partition of plutonium species between different valency states and complexes. For the different actinides, it is found that the Kd-values under otherwise identical conditions (e.g. for the uptake of plutonium on geologic materials or in organisms) decrease in the order Pu>Am>U>Np (15). Because neptunium is usually pentavalent, uranium hexavalent and americium trivalent, while plutonium in natural systems is mainly tetravalent, it is clear from the actinide homologue properties that the oxidation state of plutonium will affect the observed Kd-value. The oxidation state of plutonium depends on the redox potential (Eh-value) of the ground water and its content of oxidants or reductants. It is also found that natural ligands like C032- and fulvic acids, which complex plutonium (see next section), also influence the Kd-value. [Pg.278]

In Figure 2 the solubility and speciation of plutonium have been calculated, using stability data for the hydroxy and carbonate complexes in Table III and standard potentials from Table IV, for the waters indicted in Figure 2. Here, the various carbonate concentrations would correspond to an open system in equilibrium with air (b) and closed systems with a total carbonate concentration of 30 mg/liter (c,e) and 485 mg/liter (d,f), respectively. The two redox potentials would roughly correspond to water in equilibrium wit air (a-d cf 50) and systems buffered by an Fe(III)(s)/Fe(II)(s)-equilibrium (e,f), respectively. Thus, the natural span of carbonate concentrations and redox conditions is illustrated. [Pg.284]


See other pages where Complexes redox potentials is mentioned: [Pg.445]    [Pg.458]    [Pg.445]    [Pg.458]    [Pg.223]    [Pg.417]    [Pg.368]    [Pg.395]    [Pg.443]    [Pg.88]    [Pg.169]    [Pg.390]    [Pg.37]    [Pg.394]    [Pg.405]    [Pg.63]    [Pg.929]    [Pg.353]    [Pg.70]    [Pg.493]    [Pg.196]    [Pg.367]    [Pg.51]    [Pg.118]    [Pg.129]    [Pg.144]    [Pg.156]    [Pg.180]    [Pg.224]    [Pg.225]    [Pg.42]    [Pg.283]    [Pg.301]    [Pg.448]   
See also in sourсe #XX -- [ Pg.381 , Pg.382 , Pg.383 ]

See also in sourсe #XX -- [ Pg.161 , Pg.163 ]




SEARCH



Complex potential

Effect of complexing agents on redox potential

Molybdenum complexes redox potentials

Osmium complexes redox potentials

Redox potential transition metal complexes

Redox potentials

Redox potentials chromium complexes

Redox potentials cobalt complexes

Redox potentials copper complexes

Redox potentials iron complexes

Redox potentials manganese complexes

Redox potentials of metal complexes

Redox potentials vanadium complexes

Redox potentials, stabilization complex formation

Rhodium complexes redox potential

© 2024 chempedia.info