Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Real compliance

In January 2008, Walmart announced its first real compliance penalties for failure to tag products, specifically for shipments to its Sam s Club chain. Walmart said in a letter to suppliers that a failure to tag pallets sent to its distribution center (DC) in DeSoto, Texas, or directly to one of its stores served by that DC after January 31 would be charged a service fee, starting at 2 per untagged pallet on February 1, 2008, and capping at 3 per pallet on January 1, 2009. [Pg.97]

In this equation is the high-frequency limiting value of the real compliance and is the counterpart of = 1 in the corresponding electrostatic equations. The ratio of relaxation times by analogy with the dielectric case is given by... [Pg.267]

Figure C2.1.14. (a) Real part and (b) imaginary part of tire dynamic shear compliance of a system whose mechanical response results from tire transition between two different states characterized by a single relaxation time X. Figure C2.1.14. (a) Real part and (b) imaginary part of tire dynamic shear compliance of a system whose mechanical response results from tire transition between two different states characterized by a single relaxation time X.
In these kind of facilities, the DO level is measured very frequently to ensure compliance and may often be measured periodically in real time, with the results automatically forwarded to a system management monitor located in a central control room. [Pg.104]

A distribution obtained by the use of equation (13) is only a first approximation to the real distribution. The corresponding distribution of retardation times is designated as L(T). It may be estimated from the slope of a compliance curve D(0 or J(t), for tensile or shear creep, respectively, plotted on a logarithmic time scale according to the equation (for shear creep)-... [Pg.71]

In fact, there exists a great difference between the two types of needs in terms of traceability. On the one hand, the regulation compliance need and more often the scientific need require us to be as confident as possible about the trueness of the results (or at least the closeness between the results and true values) and to store the data for further exploitation. On the other hand, process control and hazards prevention are based on the real-time exploitation of the results. [Pg.249]

Aside from the Premanufacture Notification (PMN) requirements. Section 5 rules have not been used to a great extent. Nearly all of the compliance activity since July of 1979 has been geared toward meeting PMN requirements. Whether the agency s failure to use the subsections of 5 that are designed to restrict potentially harmful substances from reaching the marketplace has resulted from lack of real necessity, a failure in the Agency s risk assessment process, or an inherent non-workability in the Law itself, remains to be seen. [Pg.143]

Third, voluntary compliance is more efficient than regulation, but voluntary compliance will not be achieved unless the possibility of regulatory action is real. Any law is dependent for its effectiveness on voluntary compliance, and during the Carter Administration we had continuous... [Pg.221]

We can separate out the real and imaginary parts by multiplying by (a — ib), as appropriate. This demonstrates the more sophisticated relationship between the complex compliances and the complex moduli ... [Pg.134]

Although changes in instrumentation and laboratory compliance will continue to drive the evolution of CDS products, the real challenge is related to globalization and its impact on information accessibility and information management. [Pg.608]

In explanatory studies, there is a tendency to compare a new treatment to placebo and to rigidly adhere to single doses of the new treatment in anticipation of maximising treatment compliance. On the other hand, pragmatic studies are more likely to compare the new treatment with the best available alternative and to use a more flexible attitude to dosing, for example, including the possibility of individual dose titration. The delivery of treatment is likely to mimic real-life usage. [Pg.291]

Compliance with the FDA guidance can be considered a minimum requirement to test the performance of a bioanalytical method. Due to the fact that the validation process should simulate closely sample analysis, the real and decisive final test for a validated method will always be the sample analysis itself. It is possible that even if it passes all the validation criteria, a bioanalytical method may not be reliable for the analysis of actual samples. This undesirable situation could happen when actual samples (in vivo samples) contain new interferences not present in the spiked samples (in vitro samples) due to a metabolic process and/or other biotransformations. For this reason, bioanalytical laboratories could decide to use more stringent criteria and procedures and/or use actual sample during the method development to further guarantee the validity of the validated methods. [Pg.107]

Were virtually certain to be registrants or exempt from the order form requirement, compliance with the transfer tax provisions would have required petitioner as one not registered but obliged to obtain an order form unmistakably to identify himself as a member of a selective group inherently suspect of criminal activities, and thus those provisions created a real and appreciable hazard of incrimination. [Pg.56]

Real operational amplifier (compliance limitations, offset current and voltage) Voltage follower Follower with gain Inverter Integrator Differentiator Comparators... [Pg.173]

The purpose of this chapter is to remind the reader of the basis of the theory of elasticity, to outline some of its principal results and to discuss to what extent the classical theory can be applied to polymeric systems. We shall begin by reviewing the definitions of stress and strain and the compliance and stiffness matrices for linear elastic bodies at small strains. We shall then state several important exact solutions of these equations under idealised loading conditions and briefly discuss the changes introduced if realistic loading conditions are considered. We shall then move on to a discussion of viscoelasticity and its application to real materials. [Pg.71]


See other pages where Real compliance is mentioned: [Pg.250]    [Pg.292]    [Pg.364]    [Pg.444]    [Pg.543]    [Pg.250]    [Pg.292]    [Pg.364]    [Pg.444]    [Pg.543]    [Pg.2531]    [Pg.2531]    [Pg.549]    [Pg.512]    [Pg.396]    [Pg.166]    [Pg.651]    [Pg.11]    [Pg.42]    [Pg.109]    [Pg.877]    [Pg.150]    [Pg.5]    [Pg.372]    [Pg.597]    [Pg.38]    [Pg.225]    [Pg.693]    [Pg.72]    [Pg.271]    [Pg.64]    [Pg.63]    [Pg.117]    [Pg.183]    [Pg.143]    [Pg.151]    [Pg.497]    [Pg.24]    [Pg.28]   
See also in sourсe #XX -- [ Pg.443 ]




SEARCH



Real compliance function

© 2024 chempedia.info