Reactions of Cycloaddition

Another important aspect of the coordination chemistry of organopseudo-halides is that the reactions of cycloaddition and oligo(poly)merization may take place in conditions of complex formation (under interaction with Lewis acids) [112,713]. 

Cyclodimerization of fluorinated alkenes was observed as early as 1947 during the pyrolysis study of polytetrafluoroethylene (PTFE) [54]. The ability of fluorinated alkenes to dimerize with themselves has been attributed to the energy relief of fluorinated double bond strain [4]. In the same fashion, the aryl trifluorovinyl ether groups (Ar—O—CF=Cp2) underwent thermally activated [2-1-2] cycloaddition to form bisaryloxy-substituted PFCB rings. Scheme 14.9 depicts the model reaction of cycloaddition of aryl trifluorovinyl ethers. The thermal cyclodimerization of methyl... 

Alternatively, authors have repeatedly invoked the internal pressure of water as an explanation of the rate enhancements of Diels-Alder reactions in this solvent ". They were probably inspired by the well known large effects of the external pressure " on rates of cycloadditions. However, the internal pressure of water is very low and offers no valid explanation for its effect on the Diels-Alder reaction. The internal pressure is defined as the energy required to bring about an infinitesimal change in the volume of the solvents at constant temperature pi = (r)E / Due to the open and... 

Ulrich, H. (ed.) 1967, Cycloaddition Reactions of Heterocumulenes, Academic Press New York - London... 

The benzene derivative 401 by the intermolecular insertion of acrylate[278], A formal [2 + 2+2] cycloaddition takes place by the reaction of 2-iodonitroben-zene with the 1,6-enyne 402. The neopentylpalladium intermediate 403 undergoes 6-endo-lrig cyclization on to the aromatic ring to give 404[279],... 

In the presence of a double bond at a suitable position, the CO insertion is followed by alkene insertion. In the intramolecular reaction of 552, different products, 553 and 554, are obtained by the use of diflerent catalytic spe-cies[408,409]. Pd(dba)2 in the absence of Ph,P affords 554. PdCl2(Ph3P)3 affords the spiro p-keto ester 553. The carbonylation of o-methallylbenzyl chloride (555) produced the benzoannulated enol lactone 556 by CO, alkene. and CO insertions. In addition, the cyclobutanone derivative 558 was obtained as a byproduct via the cycloaddition of the ketene intermediate 557[4I0]. Another type of intramolecular enone formation is used for the formation of the heterocyclic compounds 559[4l I]. The carbonylation of the I-iodo-1,4-diene 560 produces the cyclopentenone 561 by CO. alkene. and CO insertions[409,4l2]. 

Aldehydes take part in the cycloaddition to give the methylenetetrahydrofuran 178 by the co-catalysis of Pd and Sn compounds[115]. A similar product 180 is obtained by the reaction of the allyl acetate 179, which has a tributyltin group instead of a TMS group, with aldehydesfl 16]. The pyrrolidine derivative 182 is formed by the addition of the tosylimine 181 to 154[117]. 

Cycloaddition of COj with the dimethyl-substituted methylenecyclopropane 75 proceeds smoothly above 100 °C under pressure, yielding the five-membered ring lactone 76. The regiocheraistry of this reaction is different from that of above-mentioned diphenyl-substituted methylenecyclopropanes 66 and 67[61], This allylic lactone 76 is another source of trimethylenemethane when it is treated with Pd(0) catalyst coordinated by dppe in refluxing toluene to generate 77, and its reaction with aldehydes or ketones affords the 3-methylenetetrahy-drofuran derivative 78 as expected for this intermediate. Also, the lactone 76 reacts with a, /3-unsaturated carbonyl compounds. The reaction of coumarin (79) with 76 to give the chroman-2-one derivative 80 is an example[62]. 

The reaction of cyclohexene with the diazopyruvate 25 gives unexpectedly ethyl 3-cyclohexenyl malonate (26), involving Wolff rearrangement. No cyclo-propanation takes place[28]. 1,3-Dipolar cycloaddition takes place by the reaction of acrylonitrile with diazoacetate to afford the oxazole derivative 27[29]. Bis(trimethylstannyl)diazomethane (28) undergoes Pd(0)-catalyzed rearrangement to give the A -stannylcarbodiimide 29 under mild conditions[30]. 

Indoles are usually constructed from aromatic nitrogen compounds by formation of the pyrrole ring as has been the case for all of the synthetic methods discussed in the preceding chapters. Recently, methods for construction of the carbocyclic ring from pyrrole derivatives have received more attention. Scheme 8.1 illustrates some of the potential disconnections. In paths a and b, the syntheses involve construction of a mono-substituted pyrrole with a substituent at C2 or C3 which is capable of cyclization, usually by electrophilic substitution. Paths c and d involve Diels-Alder reactions of 2- or 3-vinyl-pyrroles. While such reactions lead to tetrahydro or dihydroindoles (the latter from acetylenic dienophiles) the adducts can be readily aromatized. Path e represents a category Iley cyclization based on 2 -I- 4 cycloadditions of pyrrole-2,3-quinodimcthane intermediates. 

Two types of cycloaddition reactions have found application for the Synthetic elaboration of indoles. One is Diels-Alder reactions of 2- and 3-vinylindoles which yield partially hydrogenated carbazoles. The second is cycloaddition reactions of 2,3-indolequinodimethane intermediates which also construct the carbazole framework. These reactions arc discussed in the following sections. 

The reaction of dihalocarbenes with isoprene yields exclusively the 1,2- (or 3,4-) addition product, eg, dichlorocarbene CI2C and isoprene react to give l,l-dichloro-2-methyl-2-vinylcyclopropane (63). The evidence for the presence of any 1,4 or much 3,4 addition is inconclusive (64). The cycloaddition reaction of l,l-dichloro-2,2-difluoroethylene to isoprene yields 1,2- and 3,4-cycloaddition products in a ratio of 5.4 1 (65). The main product is l,l-dichloro-2,2-difluoro-3-isopropenylcyclobutane, and the side product is l,l-dichloro-2,2-difluoro-3-methyl-3-vinylcyclobutane. When the dichlorocarbene is generated from CHCl plus aqueous base with a tertiary amine as a phase-transfer catalyst, the addition has a high selectivity that increases (for a series of diolefins) with a decrease in activity (66) (see Catalysis, phase-TRANSFEr). For isoprene, both mono-(l,2-) and diadducts (1,2- and 3,4-) could be obtained in various ratios depending on which amine is used. 

The chemistry of ketenes is dominated by their high reactivity most of them are not stable under normal conditions, many exist only as transient Species. Nucleophilic attack at the j -carbon, [2 + 2] cycloadditions, and ketene iasertion iato single bonds are the most important and widely used reactions of such compounds. 

Chemical Properties. The chemistry of ketenes is dominated by the strongly electrophilic j/)-hybridi2ed carbon atom and alow energy lowest unoccupied molecular orbital (LUMO). Therefore, ketenes are especially prone to nucleophilic attack at Cl and to [2 + 2] cycloadditions. Less frequent reactions are the so-called ketene iasertion, a special case of addition to substances with strongly polarized or polarizable single bonds (37), and the addition of electrophiles at C2. For a review of addition reactions of ketenes see Reference 8. 

Simple olefins do not usually add well to ketenes except to ketoketenes and halogenated ketenes. Mild Lewis acids as well as bases often increase the rate of the cyclo addition. The cycloaddition of ketenes to acetylenes yields cyclobutenones. The cycloaddition of ketenes to aldehydes and ketones yields oxetanones. The reaction can also be base-cataly2ed if the reactant contains electron-poor carbonyl bonds. Optically active bases lead to chiral lactones (41—43). The dimerization of the ketene itself is the main competing reaction. This process precludes the parent compound ketene from many [2 + 2] cyclo additions. Intramolecular cycloaddition reactions of ketenes are known and have been reviewed (7). 

The success of the cycloaddition reaction of maleic anhydride varies gready depending on which heterocyclic diene is used. The cycloaddition of maleic anhydride to furan [110-00-9] occurs ia a few seconds under ambient conditions (42,43). Although the endo adduct (14) is favored kiaeticaHy, the exo adduct (13) is isolated. 

Endo adducts are usually favored by iateractions between the double bonds of the diene and the carbonyl groups of the dienophile. As was mentioned ia the section on alkylation, the reaction of pyrrole compounds and maleic anhydride results ia a substitution at the 2-position of the pyrrole ring (34,44). Thiophene [110-02-1] forms a cycloaddition adduct with maleic anhydride but only under severe pressures and around 100°C (45). Addition of electron-withdrawiag substituents about the double bond of maleic anhydride increases rates of cycloaddition. Both a-(carbomethoxy)maleic anhydride [69327-00-0] and a-(phenylsulfonyl) maleic anhydride [120789-76-6] react with 1,3-dienes, styrenes, and vinyl ethers much faster than tetracyanoethylene [670-54-2] (46). 

CycIoa.ddltlons. Cyclobutene adducts are formed from the reaction of acetylenic derivatives and maleic anhydride through a 2 + 2 cycloaddition (48). The reaction is photochemicaHy cataly2ed (see Photochemical technology). 

Methacryhc acid and its ester derivatives are Ctfjy -unsaturated carbonyl compounds and exhibit the reactivity typical of this class of compounds, ie, Michael and Michael-type conjugate addition reactions and a variety of cycloaddition and related reactions. Although less reactive than the corresponding acrylates as the result of the electron-donating effect and the steric hindrance of the a-methyl group, methacrylates readily undergo a wide variety of reactions and are valuable intermediates in many synthetic procedures. 

Most ozonolysis reaction products are postulated to form by the reaction of the 1,3-zwitterion with the extmded carbonyl compound in a 1,3-dipolar cycloaddition reaction to produce stable 1,2,4-trioxanes (ozonides) (17) as shown with itself (dimerization) to form cycHc diperoxides (4) or with protic solvents, such as alcohols, carboxyUc acids, etc, to form a-substituted alkyl hydroperoxides. The latter can form other peroxidic products, depending on reactants, reaction conditions, and solvent. 

From Diazo Compounds via 1,3-Dipolar Cycloaddition. This method has been utilized widely in heterocychc chemistry. Pyrazohne (57) has been synthesized by reaction of ethyl diazoacetate (58) with a,P-unsaturated ester in the presence of pyridine (eq. 12) (42). 

Reaction of arninoacetonitrile hydrochloride with sodium nitrite provides diazoacetonittile (62). The product undergoes a 1,3-dipolar cycloaddition with diethyl fumarate to yield a pyrazoline intermediate, which without isolation reacts with ammonia in water to furnish the pyrazole [119741-54-7] (63) (eq. 14) (43). 

The synthesis of natural products containing the quinonoid stmcture has led to intensive and extensive study of the classic diene synthesis (77). The Diels-Alder cycloaddition of quinonoid dienophiles has been reported for a wide range of dienes (78—80). Reaction of (2) with cyclopentadiene yields (79) [1200-89-1] and (80) [5439-22-5]. The analogous 1,3-cyclohexadiene adducts have been the subject of C-nmr and x-ray studies, which indicate the endo—anti—endo stereostmcture (81). 

The current paradigm for B syntheses came from the first report in 1957 of a synthesis of pyridines by cycloaddition reactions of oxazoles (36) (Fig. 5). This was adapted for production of pyridoxine shordy thereafter. Intensive research by Ajinomoto, BASF, Daiichi, Merck, Roche, Takeda, and other companies has resulted in numerous pubHcations and patents describing variations. These routes are convergent, shorter, and of reasonably high throughput. 

Characteristic reactions of singlet oxygen lead to 1,2-dioxetane (addition to olefins), hydroperoxides (reaction with aHyhc hydrogen atom), and endoperoxides (Diels-Alder "4 -H 2" cycloaddition). Many specific examples of these spectrally sensitized reactions are found iu reviews (45—48), earlier texts (15), and elsewhere iu the Engchpedia. 

Although the most general cycloaddition reaction of diazo compounds is that they react as 1,3-dipoles, recently some reactions have been reported in which they react as 1,2-dipoles,... 

More recently, Cheeseman and coworkers have investigated cycloaddition reactions of 2,6-dioxypyrazines (80jCS(Pl)1603). 2,6-Dihydroxy-3,5-diphenylpyrazine (77) reacts with electron deficient dienophiles such as iV-phenylmaleimide, diethyl maleate and diethyl fumarate (Scheme 26) to yield adducts of the 3,8-diazabicyclo[3.2.1]octane class such as (78). This reaction is believed to proceed by way of the betaine (79) and has precedent (69AG(E)604) in that photolysis of the bicyclic aziridine (80) generates analogous betaines which have been trapped in cycloaddition reactions. 

---