Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Quantitative Nuclear Magnetic Resonance Methods

NMR spectra. In such cases, chemometric techniques may help in data interpretation. To quantify a single component in solution, it is not necessary to know the nature of all the other compounds that are present or to identify all of them in the NMR spectrum. It suffices to identify a signal generated by the analyte of interest. [Pg.646]

Quantification in 1-NMR spectroscopy necessitates optimisation of experimental conditions, such as pulse width, recycle delay and decoupler gating, as well as determination of the inherent relaxation [Pg.646]


Liu SY, Hu CQ, A comparative uncertainty study of the calibration of macrolide antibiotic reference standards using quantitative nuclear magnetic resonance and mass balance methods. Anal. Chim. Acta 2007 602(1) 114-121. [Pg.326]

Instmmental methods of analysis provide information about the specific composition and purity of the amines. QuaUtative information about the identity of the product (functional groups present) and quantitative analysis (amount of various components such as nitrile, amide, acid, and deterruination of unsaturation) can be obtained by infrared analysis. Gas chromatography (gc), with a Hquid phase of either Apiezon grease or Carbowax, and high performance Hquid chromatography (hplc), using siHca columns and solvent systems such as isooctane, methyl tert-huty ether, tetrahydrofuran, and methanol, are used for quantitative analysis of fatty amine mixtures. Nuclear magnetic resonance spectroscopy (nmr), both proton ( H) and carbon-13 ( C), which can be used for quaHtative and quantitative analysis, is an important method used to analyze fatty amines (8,81). [Pg.223]

Nuclear magnetic resonance (NMR) spectrometry has seldom been used as a quantitative analytical method but can have some practical importance in the characterization of surfactants [296-298]. 13C-NMR spectrometry has been used for the qualitative and also quantitative analysis of dodecyl, tetradecyl, and cetyl sulfates [299]. H- and, 3C-NMR spectra of sodium dodecyl sulfate are given by Mazumdar [300]. [Pg.284]

Perhaps the most revolutionary development has been the application of on-line mass spectroscopic detection for compositional analysis. Polymer composition can be inferred from column retention time or from viscometric and other indirect detection methods, but mass spectroscopy has reduced much of the ambiguity associated with that process. Quantitation of end groups and of co-polymer composition can now be accomplished directly through mass spectroscopy. Mass spectroscopy is particularly well suited as an on-line GPC technique, since common GPC solvents interfere with other on-line detectors, including UV-VIS absorbance, nuclear magnetic resonance and infrared spectroscopic detectors. By contrast, common GPC solvents are readily adaptable to mass spectroscopic interfaces. No detection technique offers a combination of universality of analyte detection, specificity of information, and ease of use comparable to that of mass spectroscopy. [Pg.375]

Electron spin resonance, nuclear magnetic resonance, and neutron diffraction methods allow a quantitative determination of the degree of covalence. The reasonance methods utilize the hyperfine interaction between the spin of the transferred electrons and the nuclear spin of the ligands (Stevens, 1953), whereas the neutron diffraction methods use the reduction of spin of the metallic ion as well as the expansion of the form factor [Hubbard and Marshall, 1965). The Mossbauer isomer shift which depends on the total electron density of the nucleus (Walker et al., 1961 Danon, 1966) can be used in the case of Fe. It will be particularly influenced by transfer to the empty 4 s orbitals, but transfer to 3 d orbitals will indirectly influence the 1 s, 2 s, and 3 s electron density at the nucleus. [Pg.38]

Currently, there are no accurate methods available for quantifying the aliphatic bridges in the coal macromolecule. Quantitative nature of the application of infrared (IR) spectroscopy is limited to certain general types of functional groups or bond types. Nuclear magnetic resonance spectroscopy, despite the success of dipolar dephasing techniques to decipher the extent of substitution on carbon atoms, is still inadequate to distinguish distinct structural entities . [Pg.300]

Compared with chiroptical methods and nuclear magnetic resonance spectroscopy (NMR), only chiral chromatography by direct and indirect methods is suitable for the accurate determination of enantiomeric impurities of less than 1% and for quantitative stereochemical analyses of small sample amounts (for example, in vivo studies of the metabolic pathway or pharmacokinetic effects of chiral pharmaceuticals.)... [Pg.191]

Several methods are available in the literature for the measurement of aliphatic amines in biological samples [28]. Problems with specificity and separation and cumbersome derivatisation and/or extraction procedures have limited the use of these techniques on a larger scale in clinical practice. The lack of a simple analytical method may have led to an underestimation of the incidence of the fish odour syndrome. For diagnosing the syndrome, an analytical technique should be used that is able to simultaneously and quantitatively measure TMA and its N-oxide in the complex matrix of human urine. Two such methods are currently available for this purpose proton nuclear magnetic resonance (NMR) spectroscopy and head-space gas analysis with gas chromatography or direct mass spectrometry (see below). [Pg.784]

Comparisons of estimated diffusivity values on zeolites from sorption uptake measurements and those obtained from direct measurements by nuclear magnetic resonance field gradient techniques have indicated large discrepancies between the two for many systems [10]. In addition, the former method has often resulted in an adsorbate diffusivity directly proportional to the adsorbent crystal size [11]. This led some researchers to believe that the resistance to mass transfer may be confined in a skin at the surface of the adsorbent crystal or pellet (surface barrier) [10,11]. The isothermal surface barrier model, however, failed to describe experimental uptake data quantitatively [10,12]. [Pg.175]

In addition, this procedure was quite tedious and time consuming. Therefore, in recent years when physical methods for assaying molecules in mixtures—methods such as nuclear magnetic resonance (NMR), gas chromatography, and others—have become available, a renaissance in the study of redistribution reactions has taken place. These methods allowed a rapid, quantitative, and precise determination of all of the reaction products present in a mixture. Also, equilibrium reactions could be carried out in much smaller sample sizes, thus permitting the study of exotic, hard-to-obtain compounds. Redistribution reactions—the kinetics as well as the equilibria—can now be measured directly in sealed NMR tubes. Furthermore, the relatively recent widespread availability to chemists of high-speed computers, in addition to these modern analytical tools, has facilitated the use of the appropriate mathematics even when highly complicated. [Pg.173]

The formation of complex ions is an important problem for the study of the structure and properties of molten salts. Several physicochemical measurements give evidence of the presence of complex ions in melts. The most direct methods are the spectroscopic methods which obtain absorption, vibration and nuclear magnetic resonance spectra. Also, the formation of complex ions can be demonstrated, without establishing the quantitative formula of the complexes, by the variation of various physicochemical properties with the composition. These properties are electrical conductivity, viscosity, molecular refraction, diffusion and thermodynamic properties like molar volume, compressibility, heat of mixing, thermodynamic activity, surface tension. [Pg.474]

Infrared spectroscopy is an important technique for studying acidity. Acidic OH groups can be studied directly. Probe molecules such as pyridine may be used to study both Bronsted and Lewis acidity since two forms of adsorbed probes are easily distinguished by their infrared spectra. Quantitative infrared spectroscopy may be performed by measuring the spectrum of acidic OH or probes adsorbed on thin, self-supporting wafers of the acidic solid. Other spectroscopic methods which may provide information in specific cases include Fourier Transform Raman spectroscopy, electron spin resonance spectroscopy, ultraviolet spectroscopy, and nuclear magnetic resonance spectroscopy. [Pg.555]


See other pages where Quantitative Nuclear Magnetic Resonance Methods is mentioned: [Pg.597]    [Pg.646]    [Pg.597]    [Pg.646]    [Pg.394]    [Pg.173]    [Pg.132]    [Pg.102]    [Pg.398]    [Pg.340]    [Pg.268]    [Pg.194]    [Pg.1230]    [Pg.24]    [Pg.241]    [Pg.1230]    [Pg.323]    [Pg.142]    [Pg.335]    [Pg.76]    [Pg.2]    [Pg.45]    [Pg.313]    [Pg.554]    [Pg.14]    [Pg.172]    [Pg.199]    [Pg.239]    [Pg.349]    [Pg.414]    [Pg.209]    [Pg.46]    [Pg.174]    [Pg.353]    [Pg.153]    [Pg.26]    [Pg.445]    [Pg.208]    [Pg.62]    [Pg.55]    [Pg.4]   


SEARCH



Magnetic methods

Nuclear magnetic resonance quantitation

Nuclear methods

Quantitation methods

Quantitative methods

Quantitative nuclear magnetic

Quantitative nuclear magnetic resonance

Resonance methods

© 2024 chempedia.info