Talc, purified

Purified Talc When preparing solution A in the test for Calcium, add 1 M. H2S04. No effervescence produced. 

Glidants (e.g., colloidal silicon dioxide, talc) may need to be added to achieve desired flow properties, especially when the drug/filler ratio is relatively high. Usually, there is an optimum concentration of glidant for best flow, often less than 1% for the colloidal silicas (14,15). The following order of effectiveness of glidants has been reported for two powder systems fine silica > magnesium stearate > purified talc (16). 

Glidants To improve the flow of granules from the hopper to the die cavity to ensure uniform fill for each tablet Fine silica, magnesium stearate, purified talc... 

BP Purified talc JP Talc PhEur Talcum USP Talc... 

SterlLine. [M< itana Talc] Platy talcs high purify talcs meeting USP, CTFA, ai Eurtqwan Pharmacopeia specs. for cosmetics, antiperspirants, dusting powders, pharmaceutical excq>ients. 

Three dusting powders containing boric acid are included in the B.P.C., ue. Boric Talc, 5 per cent of boric acid and 10 per cent of starch in talc Compound Salicylic Acid Dusting Powder, 3 per cent of salicylic acid and 5 per cent of boric acid in talc and Compound Zinc Dusting Powder, containing 5 per cent boric acid, 25 per cent zinc oxide, 35 per cent starch and 35 per cent purified talc. Boric Acid and Starch Dusting Powder, containing 25 per cent of boric acid is official in the B. Vet,C,... 

The hydrogenation step talces place in the conventional way in vessel packed with catalyst where the aldehydes and hydrogen are admixed at 200-300°F and 600-1200 psi. The catalyst is usually nickel or copper chromite on an inert carrier such as kieselguhr, silica gel, or alumina. The crude butyl alcohols are finally separated and purified by distillation. 

Uses. In addn to its uses as an expl, Yoshin-aga(Ref 24) patented the use of 2,4,6-TNBAc, a-lone or mixed with a fatty acid, lithophone, talc pine tar as an aide in the vulcanization of rubber compds. Smith Wilkins(Ref 26) proposed the use of highly purified 2,4,6-TNBAc as a primary std in acidimetry... 

Tarka Trandolapril/ verapamil HC1 1 mg/240 mg 2mg/180mg 2 mg/240 mg 4 mg/240 mg Extended release tablet Hypertension ACE inhibitor Com starch, dioctyl sodium sulfosuccinate, ethanol, HPC, HPMC, lactose, magnesium stearate, MCC, polyethylene glycol, povidone, purified water, silicon dioxide, sodium alginate, sodium stearyl fumarate, talc, sytnetic iron oxides, titanium dioxide Abbott Laboratories... 

Waste-treatment processes commonly result in the production of solid wastes that must be disposed of safely. Enzymatic treatment is no exception. For example, although enzymatic treatment may not produce as large a quantity of solid products as does biological treatment, some solid residues may be formed, e.g., the polymer precipitates formed during the treatment of phenols with peroxidases, spent adsorbents such as talc, chitin, or activated carbon that are used to eliminate the soluble products of enzymatic reactions, or residues of plant materials such as raw soybean hulls when they are used in place of purified enzymes during treatment. Perhaps, the polymers and adsorbents could be incinerated to recover some energy if the emission of dangerous combustion by-products can be controlled or prevented. The residues of plant materials could potentially be composted and used as soil conditioners, provided that pollutants do not leach from them at substantial rates. To date, none of these disposal problems have been addressed adequately. 

The various types of compounds which have been purified with peroxygens and which will be discussed here are petroleum products, miscellaneous organic chemicals, surfactants, natural oils, waxes and gums, natural sugars and starches, synthetic polymers, inorganic acids and salts, clays, talc and minerals. 

Talc is purified from its impurities (iron and other soluble impurities) by boiling in diluted hydrochloric acid, then washed with water and dried. Thermal analysis reveals that it exhibits an endothermic peak at 950-975 °C. 

Talc will adsorb the iodohormone, and it has been used in RIA to separate bound from free hormone and to purify iodohormones.Hormonal aggregates will easily dissociate from talc, and thus more than 90% of the labeled hormone should remain adsorbed to talc. Less than 90% talc adsorption indicates the formation of either free iodide or basic aggregates. Since acidic aggregates also may adsorb to talc, the talc and TCA percentages should agree within 3%. 

Fig. 2. Gel filtration profile of I-labeled human prolactin, [ I]hPRL (VLS No. 3) io-dinated by the chloramine-T method and purified on a 1.5 x 30 cm Sephadex G-100 column, precoated with bovine serum albumin. Elution solvent was 10 mM phosphate buffer, pH 7.5, containing 0.15 M NaCl and 1 10,000 Merthiolate. The labeled hormone was purified just prior to use. The talc-resin-trichloroacetic acid (TCA) test results showed that peak III material was suitable for use in radioimmunoassay (Tower et al. ).

Fig. 4. Elution pattern of I-labeled rat prolactin, [ I]rPRL (AFP 1-2), prepared by the glucose oxidase-lactoperoxidase iodination method and purified as described in Fig. 1 for human PRL. Before this material was labeled, it had been diluted in phosphate buffer to 100 /xg/ml, aliquoted into separate reaction vials, and stored at -20° for 1 month. During storage, the unlabeled hormone apparently converted to aggregate, as the talc-resin-(TCA) test indicated that no usable monomeric hormone remained available for iodination (cf. Fig. 3) (Tower et al. ).

Bentonite magma kaolin magnesium aluminum silicate magnesium trisilicate purified bentonite talc. 

Altaic-, E553b hydrous magnesium calcium silicate hydrous magnesium silicate Luzenac Pharma magnesium hydrogen metasilicate Magsil Osmanthus Magsil Star powdered talc purified Erench chalk Purtalc soapstone steatite Superiore. 

Talc is a purified, hydrated, magnesium silicate, approximating to the formula Mgg(Si205)4(0H)4. It may contain small, variable amounts of aluminum silicate and iron. 

The sunblocking 4% cream contains 40 mg hydroquinone USP in a tinted sunblocking-cream base of purified water USP, stearic acid NF, talc USP, polyoxyl 40 stearate NF, polyoxyethylene (25) propylene glycol stearate, propylene glycol USP, glycerol monostearate, iron oxides, light mineral oil NF, squalane NF, edetate disodium USP, sodium metabisulfite NF, and potassium sorbate NF. 

This particle is naturally occurring and found around the world. It is easily mined and purified. The reactor for the particle was a volcano. The ash from many volcanoes was spread around the earth during an intense period of activity many millions of years ago. This ash was transformed into clay (montmorillonoids or smectites) by natural processes, into uncharged species (talc and pyrophyllite) and charged species through isomorphic substitution of the crystal structure (hectorite, montmorillon-ite, saponite, suconite, volchonskoite, vermiculite, and nontronite). 

Hectorite is the isomorphic substitution of Li for Mg (from talc). Some isomorphic substitution is observed in the tetrahedral silica dioxide layer with A1 substituting for Si. These particles are found in nature in stacked arrays similar to a pad of paper. They can be easily mined and purified by dispersing the montmorillonite into water and removing the larger, heavier particles (sand, gravel, etc.) by centrifugation. 

---