Phase measured

Bohme D K and Raksit A B 1984 Gas phase measurements of the influence of stepwise soivation on the kinetics of nucieophiiic dispiacement reactions with CHjCi and CHjBr at room temperature J. Am. Ghem. Soc. 106 3447-52... 

Stolle R, Marowsky G, Schwarzberg E and Berkovic G 1996 Phase measurements in nonlinear optics Appl. Phys. B 63 491 -8... 

Unlike in the case of the gas-phase measurements, no tunneling has been detected in the IR spectra of the malonaldehyde molecule in the noble matrices at 15-30K [Firth et al. 1989], The lack of tunneling is caused by detuning of the potential as a result of weak antisymmetric coupling to the environment. 

Since a comprehensive program will include trending and projected time-to-failure, multiple readings are required on all machinery to provide sufficient data for the microprocessor to develop trend statistics. Normally during this phase, measurements are acquired every two weeks. 

The solid is polymorphic, with a cubic structure above 1.4°C. A bond length of 1.816 A has been obtained from EXAFS measurements at 10K, while vapour phase measurements give Os-F of 1.831 A [22],... 

While electron or ion beam techniques can only be applied under ultra-high vacuum, optical techniques have no specific requirements concerning sample environment and are generally easier to use. The surface information which can be obtained is, however, quite different and mostly does not contain direct chemical information. While with infra-red attenuated total reflection spectroscopy (IR-ATR) a deep surface area with a typical depth of some micrometers is investigated, other techniques like phase-measurement interference microscopy (PMIM) have, due to interference effects, a much better surface sensitivity. PMIM is a very quick technique for surface roughness and homogeneity inspection with subnanometer resolution. 

The application of interference techniques overcomes the limitations exerted by the large optical wavelengths. With commercial phase-measurement interference microscopes (PMIM), a surface resolution of the order of 0.6 nm can be achieved [33, 34]. In a microscope a laser beam is both reflected from the sample surface and from a semitransparent smooth reference surface (Fig. 3). The interference pattern is recorded on an area detector and modulated via the piezo-electric driven reference surface. The modulated interference pattern is fed into a computer to generate a two-dimensional phase map which is converted into a height level contour map of the sample surface. While the lateral resolution (typically of the... 

Fig. 3. Schematic beam path of a phase-measurement interference microscope (PMIM, Fizeau optics). The beam partially reflected at the reference plane and at the sample surface interfere with each other while the reference plane is moved by the piezoelectric transducer for automatic phase determination. A reflectivity of at least 1% is required for the sample surface...

The accuracy with which a wavefront sensor measures phase errors will be limited by noise in the measurement. The main sources of noise are photon noise, readout noise (see Ch. 11) and background noise. The general form of the phase measurement error (in square radians) on an aperture of size d due to photon noise is... 

Adaptive optics requires a reference source to measure the phase error distribution over the whole telescope pupil, in order to properly control DMs. The sampling of phase measurements depends on the coherence length tq of the wavefront and of its coherence time tq. Both vary with the wavelength A as A / (see Ch. 1). Of course the residual error in the correction of the incoming wavefront depends on the signal to noise ratio of the phase measurements, and in particular of the photon noise, i.e. of the flux from the reference. This residual error in the phase results in the Strehl ratio following S = exp —a ). 

Reliable information on the thermodynamic stability of group 13/15 adducts is usually obtained by gas phase measurements. However, due to the lability of stibine and bismuthine adducts in the gas phase toward dissociation, temperature-dependent H-NMR studies are also useful for the determination of their dissociation enthalpies in solution [41b], We focussed on analogously substituted adducts t-BusAl—E(f-Pr)3 (E = P 9, As 10, Sb 11, Bi 12) since they have been fully characterized by single crystal X-ray diffraction, allowing comparisons of their thermodynamic stability in solution with structural trends as found in their solid state structures. 

The lag-phase measurement at 234 nm of the development of conjugated dienes on copper-stimulated LDL oxidation is used to define the oxidation resistance of different LDL samples (Esterbauer et al., 1992). During the lag phase, the antioxidants in LDL (vitamin E, carotenoids, ubiquinol-10) are consumed in a distinct sequence with a-tocopherol as the first followed by 7-tocopherol, thereafter the carotenoids cryptoxanthin, lycopene and finally /3-carotene. a-Tocopherol is the most prominent antioxidant of LDL (6.4 1.8 mol/mol LDL), whereas the concentration of the others 7-tocopherol, /3-carotene, lycopene, cryptoxanthin, zea-xanthin, lutein and phytofluene is only 1/10 to 1/300 of a-tocopherol. Since the tocopherols reside in the outer layer of the LDL molecule, protecting the monolayer of phospholipids and the carotenoids are in the inner core protecting the cholesterylesters, and the progression of oxidation is likely to occur from the aqueous interface inwards, it seems reasonable to assign to a-tocopherol the rank of the front-line antioxidant. In vivo, the LDL will also interact with the plasma water-soluble antioxidants in the circulation, not in the artery wall, as mentioned above. 

Relative Amplitude of Burst Phase Measured by Time-Resolved Far-UV CD Spectroscopy for Various Globular Proteins a... 

Koliopoulos, C.L. Interferometric Optical Phase Measurement Techniques, Ph.D. Thesis, 1983, The University of Arizona, University Microfilms International, Ann Arbor, Michigan. 

Byeon et al. [23] described a fluorimetric method for (z>)-penicillamine using 9-fluorenylmethyl pentafluorophenyl carbonate and acetonitrile. Capsules containing penicillamine were extracted with water and then filtered. The solution was incubated at 70 °C for 40 min with borate buffer solution. After cooling, the mixture was extracted with diethyl ether and the fluorescence of the aqueous phase measured at (excitation = 260 nm, emission = 313 nm). The calibration graph was linear for 0.4-5.0 pM of penicillamine with a coefficient of variation of 0.4%. 

Acknowledgment The authors express their thanks for financial support from the DFG grants JE 267/2-1 and 436 RUS 113/788/0-1 and the Program N 1 of the Russian Academy of Sciences. Jutta Krohnert is acknowledged for propene gas phase measurements. 

---