Perchlorates detection

Methods for the detectopm perchlorate have developed over the past century (Table 30.1). The nitrates obtained from salt deposits in the Chilean Desert for use as fertilizers, contained undesirable perchlorate impurities. These impurities led to the development of the first analytical methods for perchlorate detection in soils and resulting aqueous solutions. However, these early methods for detecting perchlorate were crude and insensitive. Some of the earliest measurement techniques were reported in a publication from 1908 (Dafert, 1908). These methods... 

Other methods for analyzing combustion products can be substituted for chromatography. Gravimetry can be used, for example, after a series of absorption on different beds, as in the case of water absorption in magnesium perchlorate or CO2 in soda lime infra-red spectrometry can be used for the detection of CO2 and water. 

For nitrations in sulphuric and perchloric acids an increase in the reactivity of the aromatic compound being nitrated beyond the level of about 38 times the reactivity of benzene cannot be detected. At this level, and with compounds which might be expected to surpass it, a roughly constant value of the second-order rate constant is found (table 2.6) because aromatic molecules and nitronium ions are reacting upon encounter. The encounter rate is measurable, and recognisable, because the concentration of the effective electrophile is so small. 

A similar circumstance is detectable for nitrations in organic solvents, and has been established for sulpholan, nitromethane, 7-5 % aqueous sulpholan, and 15 % aqueous nitromethane. Nitrations in the two organic solvents are, in some instances, zeroth order in the concentration of the aromatic compound (table 3.2). In these circumstances comparisons with benzene can only be made by the competitive method. In the aqueous organic solvents the reactions are first order in the concentration of the aromatic ( 3.2.3) and comparisons could be made either competitively or by directly measuring the second-order rate constants. Data are given in table 3.6, and compared there with data for nitration in perchloric and sulphuric acids (see table 2.6). Nitration at the encounter rate has been demonstrated in carbon tetrachloride, but less fully explored. ... 

A practical method for low level perchlorate analysis employs ion chromatography. The unsuppressed method using a conductivity detector has a lower detectable limit of about 10 ppm. A suppression technique, which suppresses the conductivity of the electrolyte but not the separated ions, can further improve sensitivity (110,111). Additionally, ion chromatography can be coupled with indirect photometric detection and appHed to the analysis of perchlorates (112). 

Highly sensitive iastmmental techniques, such as x-ray fluorescence, atomic absorption spectrometry, and iaductively coupled plasma optical emission spectrometry, have wide appHcation for the analysis of silver ia a multitude of materials. In order to minimize the effects of various matrices ia which silver may exist, samples are treated with perchloric or nitric acid. Direct-aspiration atomic absorption (25) and iaductively coupled plasma (26) have silver detection limits of 10 and 7 l-lg/L, respectively. The use of a graphic furnace ia an atomic absorption spectrograph lowers the silver detection limit to 0.2 l-ig/L. 

Magnesium, calcium, barium, and strontium can also be deterrnined by ion chromatography with y -phenylenediamine in perchloric acid as the eluent. Ion chromatography by conductimetric detection has been described, and appHcations to environmental waters have been discussed (1,22—23). 

Note The pre- and post-treatment of the chromatograms with the basic tri-ethylamine solution, which can be replaced by an alcoholic solution of sodium hydroxide [1,4] or a phosphate buffer solution pH = 8.0 (c = 0.2 mol/1) [5], serves to stabilize the fluorescence of the amino derivatives [2]. A final spraying with methanolic hydrochloric acid (chci = 5 mol/1) or 70% perchloric acid renders the detection reaction highly specific for histamine [4] and for catecholamines and indolamines [5]. 

Bile acids also yield fluorescence when an only 5% perchloric acid is employed as reagent and the chromatogram is only heated to 100°C until coloration commences [9]. Steroids can also be detected with 2% methanohc perchloric acid [4]. 

Heath and Majer (H3) have recently used a mass spectrometer to study the decomposition of ammonium perchlorate. Decomposition was detected in the range from 110° to 120°C. At this temperature, there were ions in the mass spectrum caused by NH3, HC104, Cl2, HC1, nitrogen oxides, and 02. The appearance of the species NO, N02,02, and Cl2 in the decomposition products under very low pressure (i.e., in the absence of gas-phase molecular collisions) indicates that the principal decomposition reactions take place in the crystal and not in the gas phase. 

A particle size effect has been detected by Chou and Olson [486] in the isothermal decomposition of isothiocyanatopentammine cobalt(III) perchlorate. Below a = 0.09, the larger crystals decompose relatively more rapidly than the smaller, whereas for a > 0.09, the reverse is true. This behaviour was attributed to enhanced nucleation in the larger particles due to strain, but this favourable factor was later offset by the inhibiting influence of the product ammonia which accumulated in the larger crystals. 

Wiberg and Koch 167) also disagreed with Littler s results, and found that the major product (75%) obtained on treatment of cyclohexanone with aqueous thallium(III) perchlorate was cyclopentanecarboxylic acid (XL). 2-Hydroxycyclohexanone was isolated in only 3 % yield unchanged starting material accounted for the remainder of the product. Wiberg and Koch were unable to detect any cyclohexane-1,2-dione in the product mixture, but did prove that 2-hydroxycyclohexanone did not function as the precursor to the ring-contracted acid. From the results obtained from a study of the oxidation of 2,2,6,6-[Pg.196]

Sutin et a/. have found iron(If) to catalyse the aquation of the iron(III) ions, FeCl (refs. 1,2) and FeNCS (ref. 3), in perchlorate media. A flow technique, with spectrophotometric detection at 336 m.fi (disappearance of FeCl ) and 460 m/f (disappearance of FeNCS " ), was used to obtain rate data. The rate law... 

Transient concentrations of Ag(II) were detected spectrophotometrically, and by electron spin resonance. The thermal decomposition of Ag(II) perchlorate, the subject of a separate studytakes place by... 

The very fast oxidation of the radical precludes its detection and identification by esr however, reacting mixtures are capable of initiating polymerisation of acrylonitrile. The oxidations of allylic alcohols by V(V) perchlorate are ca. thirty times faster than those of saturated alcohols. This is supporting evidence for radical intermediates in view of the expected delocalisation of the free electron... 

Products detected or isolated from these oxidations include the corresponding a-hydroxy ketone and a-diketone and also adipic acid (from cyclohexanone) in up to 95 % yield. However, IrCI gives a-chloroketone in quantitative yield . Evidently when the rate of oxidation exceeds enolisation attack is on the keto form, probably via a complex, although this is definite only for Ce(IV) perchlorate, to give a radical, e.g. 

As in aqueous solution, the lanthanide contraction favors a change from nine-coordination for the light lanthanides to eight-coordination for the light lanthanides such that [Ln(DMF)8]3+ is the major species when Ln3+ = Ce3+-Nd3+, and that this becomes the only detected species when Ln3+ = Tb3+-Lu3+ in dimethylformamide perchlorate solution (11, 92, 93, 321-323). Thus, Nd3+ is characterized by AH° = -14.9 kJ mol-1, AS0 = -69.1 J K"1 mol-1, and AV° = - 9.8 cm3 mol-1 for the equilibrium shown in Eq. (25) (93). The molar volume of DMF is 72 cm3 mol- and it therefore appears that the substantially smaller magnitude of AV° is a consequence of significant... 

Figure 9 A synthetic mixture of water-soluble carboxylic acids separated by anion-exchange chromatography. Column 0.3 cm x 300 cm Diaoion CA 08, 16-20 p (Mitsubishi Kasei Kogyo). Eluant 200 mM HC1. Detection reaction with Fe3-benzohy-droxamic acid-dicyclohexy carbodiimide-hydroxylamine perchlorate-triethyl amine with absorbance at 536 nm. Analytes (1) aspartate, (2) gluconate, (3) glucuronate, (4) pyroglutamate, (5) lactate, (6) acetate, (7) tartrate, (8) malate, (9) citrate, (10) succinate, (11) isocitrate, (12) w-butyrate, (13) a-ketoglutarate. (Reprinted with permission from Kasai, Y., Tanimura, T., and Tamura, Z., Anal. Chem., 49, 655, 1977. 1977 Analytical Chemistry).

Tran [391,392] has reported ng detection of dyes on filter paper by SERS. Silver colloidal hydrosols stabilised by filter supports enhance the Raman scattering of adsorbed dyes. Typical detection limits are 500 pg (crystal violet), 7 ng (l,l,9-trimethyl-2,2 -cyanine perchlorate), 15 ng (3,3 -diethylthiacarbocyanine chloride) and 240 ng (methyl red) using a 3 mW He-Ne laser. 

Gagliardi et al. [72] developed a simple high performance liquid chromatographic method for the determination of miconazole and other antimycotics in cosmetic antidandruff formulations. This high performance liquid chromatographic method was carried out on a Discovery RP Amide Ci6 column and spectrophotometric detection was performed at 220 nm. The initial mobile phase was a mixture of acetonitrile and aqueous 0.001 M sodium perchlorate (pH 3) in the ratio of 15 85 (v/ v) then a linear gradient less than 46% acetonitrile in 70 min, and less than 50% in 80 min. The extraction procedure was validated by analyzing samples of shampoo... 

---