Packed columns solid

Packed Columns A packed column is constructed from glass, stainless steel, copper or aluminum and is typically 2-6 m in length, with an internal diameter of 2-4 mm. The column is filled with a particulate solid support, with particle diameters ranging from 37-44 pm to 250-354 pm. 

Kovat s retention index (p. 575) liquid-solid adsorption chromatography (p. 590) longitudinal diffusion (p. 560) loop injector (p. 584) mass spectrum (p. 571) mass transfer (p. 561) micellar electrokinetic capillary chromatography (p. 606) micelle (p. 606) mobile phase (p. 546) normal-phase chromatography (p. 580) on-column injection (p. 568) open tubular column (p. 564) packed column (p. 564) peak capacity (p. 554)... 

Liquid Dispersion Spray columns are used with slurries or when the reaction product is a solid. The absorption of SO9 by a hme slurry is an example. In the treatment of phosphate rock with sulfuric acid, offgases contain HF and SiF4. In a spray column with water, solid particles of fluorosilic acid are formed but do not harm the spray operation. The coefficient /cl in spray columns is about the same as in packed columns, but the spray interfacial area is much lower. Considerable backmixing of the gas also takes place, which helps to make the spray volumetri-caUy inefficient. Deentrainment at the outlet usually is needed. 

Of the three categories, the packed column is by far the most commonly used for the absorption of gaseous pollutants. Miscellaneous gas-absorption equipment could include acid gas scrubbers that are commonly classified as either wet or diy. In wet scrubber systems, the absorption tower uses a hme-based sorbent liquor that reacts with the acid gases to form a wet/solid by-product. Diy scrubbers can be grouped into three catagories (1) spray diyers (2) circulating spray diyers and (3) dry injection. Each of these systems yields a diy product that can be captured with a fabric filter baghouse downstream and... 

Also purified by dissolving in CHCI3, adding solid K2CO3 and Drierite, filtering and fractionally distilling through an Sin helix packed column. The sulfate has m 205°, and the picrate (from hot H2O) has m 155-156°. [Frank and Meikle J Am Chem Soc 72 4184 1950.]... 

The material is filtered and the residual solid washed twice with 50-ml. portions of low-boiling petroleum ether. The combined filtrates are concentrated and distilled through a short packed column to yield 190-205 g. (76-82%) of 2,2,5,5-tetra-methyltetrahydro-3-ketofuran b.p. 149-151°, d 1-4180. 

Gas-liquid contactors may be operated either by way of gas bubble dispersion into liquid or droplet dispersion in gas phase, while thin film reactors, i.e. packed columns and trickle beds are not suitable for solid formation due... 

Direct contact heal exchangers should be considered whenever the process stream and the coolant are compatible. The equipment used is basically simple and cheap and is suitable for use with heavily fouling fluids. For liquids containing solids, spray chambers, spray columns, and plate and packed columns are used. 

A number of analytical techniques such as FTIR spectroscopy,65-66 13C NMR,67,68 solid-state 13 C NMR,69 GPC or size exclusion chromatography (SEC),67-72 HPLC,73 mass spectrometric analysis,74 differential scanning calorimetry (DSC),67 75 76 and dynamic mechanical analysis (DMA)77 78 have been utilized to characterize resole syntheses and crosslinking reactions. Packed-column supercritical fluid chromatography with a negative-ion atmospheric pressure chemical ionization mass spectrometric detector has also been used to separate and characterize resoles resins.79 This section provides some examples of how these techniques are used in practical applications. 

Table 11.4 lists reactors used for systems with two fluid phases. The gas-liquid case is typical, but most of these reactors can be used for liquid-liquid systems as well. Stirred tanks and packed columns are also used for three-phase systems where the third phase is a catal5hic solid. The equipment listed in Table 11.4 is also used for separation processes, but our interest is on reactions and on steady-state, continuous flow. 

Miller and Hawthorne [416] have developed a chromatographic method that allows subcritical (hot/liquid) water to be used as a mobile phase for packed-column RPLC with solute detection by FID, UV or F also PHWE-LC-GC-FTD couplings are used. Before LC elution the extract is dried in a solid-phase trap to remove the water. In analogy to SFE-SFC, on-line coupled superheated water extraction-superheated water chromatography (SWE-SWC) has been proposed [417]. On-line sample extraction, clean-up and fractionation increases sensitivity, avoids contamination and minimises sources of error. 

Also, subcritical (hot/liquid) water can be used as a mobile phase for packed-column RPLC with solute detection by means of FID [942]. In the multidimensional on-line PHWE-LC-GC-FTD/MS scheme, the solid sample is extracted with hot pressurised water (without the need for sample pretreatment), and the analytes are trapped in a solid-phase trap [943]. The trap is eluted with a nitrogen flow, and the analytes are carried on to a LC column for cleanup, and separated on a GC column using the on-column interface. The closed PHWE-LC-GC system is suitable for many kinds of sample matrices and analytes. The main benefit of the system is that the concentration step is highly efficient, so that the sensitivity is about 800 times better than that obtained with traditional methods [944]. Because small sample amounts are required (10 mg), special attention has to be paid to the homogeneity of the sample. The system is... 

Continuous benzene alkylation was conducted in a reactive distillation column of the type illustrated in Figure 1. The process unit comprises the following principal elements a double column of solid catalyst 32, packing columns above and below the catalyst bed, a liquid reboiler 42 fitted with a liquid bottoms product takeoff 44, a condenser 21 fitted with a water collection and takeoff, and a feed inlet... 

---