Of hydrochloric acid

Doebner-von Miller reaction Condensation of an aromatic amine with an aldehyde or ketone in the presence of hydrochloric acid to form a quinoline derivative. A general method, thus aniline and ethanal give 2-methyl-quinoline (quinaldine) and p-phenetidine. 

Hoesch synthesis A variation of the Gattermann synthesis of hydroxy-aldehydes, this reaction has been widely applied to the synthesis of anthocyanidins. It consists of the condensation of polyhydric phenols with nitriles by the action of hydrochloric acid (with or without ZnCl2 as a catalyst). This gives an iminehydrochloride which on hydrolysis with water gives the hydroxy-ketone. 

Colourless crystals m.p. 50 C, b.p. 301 C. Basic and forms sparingly soluble salts with mineral acids. Prepared by the reduction of 1-nitronaphthalene with iron and a trace of hydrochloric acid or by the action of ammonia upon l-naphlhol at a high temperature and pressure. 

N-phenylhydroxylamine, PhNHOH and further reduction can give azoxybenzene, azobenzene, hydrazobenzene and aniline. The most important outlet commercially for the nitro-compounds is the complete reduction to the amines for conversion to dyestufTs. This is usually done in one stage with iron and a small amount of hydrochloric acid. 

Hydrogen chloride released dissolves in water during condensation in the crude oil distillation column overhead or in the condenser, which cause corrosion of materials at these locations. The action of hydrochloric acid is favored and accelerated by the presence of hydrogen sulfide which results in the decomposition of sulfur-containing hydrocarbons this forces the refiner to inject a basic material like ammonia at the point where water condenses in the atmospheric distillation column. 

Figure Bl.16.19. (a) CIDEP spectrum observed in die photolysis of xanthone (1.0 x 10 M) in cyclohexanol at room temperature. The stick spectra of the ketyl and cyclohexanol radicals with RPM polarization are presented, (b) CIDEP spectrum after the addition of hydrochloric acid (4.1 vol% HCl 0.50 M) to the solution above. The stick spectra of the ketyl and cyclohexanol radicals with absorptive TM polarization are presented. The bold lines of the stick spectra of the cyclohexanol radical show the broadened lines due to ring motion of the radical. Reprinted from [62].

It reduces nitrobenzene (in the presence of hydrochloric acid) to phenylammonium hydrochloride ... 

This process goes on until (if alkali is added) the final product is [Sn(OH) ] . (If alkali is not added, hydrolysis ultimately gives the hydrated oxide in accordance with the equation above.) The hydrolysis can be suppressed by addition of hydrochloric acid, and with excess of this, hexachlorostannic(l V) acid is formed ... 

In presence of hydrochloric acid, tin(II) in aqueous solution (1) is precipitated by hydrogen sulphide as brown SnS, and (2) will reduce mercury(II) chloride first to mercury(I) chloride (white precipitate) and then to metallic mercury. 

Tin(ll) chloride, in presence of hydrochloric acid, is oxidised to tin(IV) chloride, the nitrate ion in this case being reduced to hydroxylamine and ammonia. 

The sulphate ion is detected by addition of barium chloride in the presence of hydrochloric acid a white precipitate of barium sulphate is obtained. The same test can be used to estimate sulphate, the barium sulphate being filtered off, dried and weighed. 

Electrolysis of hydrochloric acid yields hydrogen at the cathode and oxygen at the anode from the dilute acid, but chlorine at the anode (of carbon) from the concentrated acid. Electrolysis of the concentrated acid is used on the large scale to recover chlorine. 

Chlorine is also used in the manufacture of hydrochloric acid, the extraction of titanium, and the removing of tin from old tinplate ( de-tinning ). 

The characteristic property of aliphatic nitrocompounds of the type RCHiKOj and RjCHNO, is that they are pseiido cids, I. e., whereas they are neutral in the normal form (A), they are able by tautomeric change under the influence of alkali to give the acidic hydroxy form (B) which thus in turn gives the sodium salt (C). When this sodium salt is treated with one equivalent of hydrochloric acid, the acid form (B) is at once regenerated, and then more slowly reverts to the more stable normal form (A). 

A further crystallisation from 15 ml. of hydrochloric acid gives the sulphonic acid, 5 5 g., m.p. 105°, almost devoid of deliquescent properties. 

When diazoaminobenzene is added to a warm aqueous solution of hydrochloric acid, it tends to break up into its original components, i.e., to benzene-diazonium chloride and aniline, and an equilibrium is thus established. The diazonium chloride and the aniline, however, in addition to recombining to form diazoaminobenzene. also undergo direct condensation at the p-hydro-... 

When platinum is dissolved in aqua regia it is first converted to platinic chloride, PtCl, and the latter at once unites with the excess of hydrochloric acid to give the stable soluble dibasic chloroplatinic acid, HjPtCle.f... 

About 150 ml. of concentrated sulphuric acid is placed in the larger funnel and 100 ml. of concentrated hydrochloric acid in the smaller separatory funnel. The latter is raised until the capillary tube is above the sulphuric acid, the capillary tube is filled with concentrated hydrochloric acid, and the stopper replaced. The rate of evolution of hydrogen chloride is controlled by regulation of the supply of hydro chloric acid this will continue until a volume of hydrochloric acid equal to that of the concentrated sulphuric acid has been used. The diluted sulphuric acid should then be removed and the apparatus recharged. The yield is 31-33 g. of hydrogen chloride per 100 ml. of concentrated hydro chloric acid. If more than an equal volume of hydrochloric acid is employed, the yield of gas decreases and continues to be formed for a tune after the stopcock has been closed. 

The acid, if monobasic, can usually be distilled directly from the reaction mixture. If this procedure is not possible, the reaction mixture is poured into excess of crushed ice, and the acid is isolated by ether extraction or by other suitable means. The acid is then characterised (Section 111,85). The addition of hydrochloric acid (as sodium chloride say 5 per cent, of the weight of sulphuric acid) increases the rate of the reaction. 

In practice, however, the amount of hydrochloric acid employed is less than 5 per cent, of the amounts indicated by either of the above equations. Various explanations have been advanced to account for this one is that the following reaction is catalysed by acid or by hydroxonium ions ... 

Benzylatnine. Warm an alcoholic suspension of 118-5 g. of finely-powdered benzyl phthalimide with 25 g. of 100 per cent, hydrazine hydrate (CAUTION corrosive liquid) a white, gelatinous precipitate is produced rapidly. Decompose the latter (when its formation appears complete) by heating with excess of hydrochloric acid on a steam bath. Collect the phthalyl hydrazide which separates by suction filtration, and wash it with a little water. Concentrate the filtrate by distillation to remove alcohol, cool, filter from the small amount of precipitated phthalyl hydrazide, render alkaline with excess of sodium hydroxide solution, and extract the liberated benzylamine with ether. Dry the ethereal solution with potassium hydroxide pellets, remove the solvent (compare Fig. //, 13, 4) on a water bath and finally distil the residue. Collect the benzylamine at 185-187° the 3ueld is 50 g. 

The disadvantages attending the use of acetic anhydride alone are absent when the acetylation is conducted in aqueous solution according to the following procedure. The amine is dissolved in water containing one equivalent of hydrochloric acid, slightly more than one equivalent of acetic anhydride is added to the solution, followed by enough sodium acetate to neutralise the hydrochloric acid, and the mixture is shaken. The free amine which is liberated is at once acetylated. It must be pointed out that the hydrolysis of acetic anhydride at room temperature is extremely slow and that the free amine reacts much more readily with the anhydride than does the water this forms the experimental basis for the above excellent method of acetylation. 

The experimental conditions necessary for the preparation of a solution of a diazonium salt, diazotisation of a primary amine, are as follows. The amine is dissolved in a suitable volume of water containing 2 5-3 equivalents of hydrochloric acid (or of sulphuric acid) by the application of heat if necessary, and the solution is cooled in ice when the amine hydrochloride (or sulphate) usually crystallises. The temperature is maintained at 0-5°, an aqueous solution of sodium nitrite is added portion-wise until, after allowing 3-4 minutes for reaction, the solution gives an immediate positive test for excess of nitrous acid with an external indicator—moist potassium iodide - starch paper f ... 

Attention has previously (see Diazonium Sails) been drawn to the fact that unless an excess of hydrochloric (or mineral) acid is used in the diazotisation process, coupling occurs between the diazonium salt and the amine to give diazoamino compounds. Thus phenyldiazonium chloride and aniline yield diazoaminobenzene. This substance may be conveniently prepared by dissolving two equivalents of aniline in three equivalents of hydrochloric acid, and adding one equivalent of sodium nitrite in aqueous solution followed by two equivalents of sodium acetate ... 

If the benzoyl derivative is soluble in alkali, precipitate it together with the benzoic acid derived from the reagent by the addition of hydrochloric acid filter and extract the product with cold ether or light petroleum (b.p. 40-60°) to remove the benzoic acid. 

Methyl ethyl ketone is allowed to react with n-butyl or iso-amyl nitrite in the presence of hydrochloric acid to yield diacetyl monoxime (nitrosomethyl ethyl ketone) ... 

In addition to water and ether, the following reagents are employed as solvents for the characterisation of organic compounds 5 per cent, aqueous solutions of hydrochloric acid and of sodium hydroxide, and also concentrated sulphuric acid. 

At the end of this time, allow to cool then add enough 25% Sodium Hydroxide solution to to get the pH above 11. Heat on a water bath or with gentle electric heat to drive the Methylamine off as a gas into the same beaker of Hydrochloric acid used as a trap during the reaction. 

Mercapto-imida2oliuin inner salts have been reported to rearrange under the influence of hydrochloric acid, producing S-aminothiazolium chlorides (Scheme 25) (36). Their N-acylated derivatives are obtained by cyclization of N-thiobenzoyl alkylaminoacetonitriles, effected with acyl or sulfonyl halides (Scheme 26) (34, 35). 

Sulfuric acid is normally used instead of hydrochloric acid in the diazotization step so as to minimize the competition with water for capture of the cationic intermediate Hydrogen sulfate anion (HS04 ) is less nucleophilic than chloride... 

Swim, J. Earps, E. Reed, L. M. et al. Gonstant-Gurrent Goulometric Titration of Hydrochloric Acid, /. Chem. Educ. 1996, 73, 679-683. 

---