Octane preparation

C. W. Tullock, U.S.P. 3 714 273/1973 (Chem. Abs., 1973, 78, 110 713c). These products, and l,4-bis(trifluoromethyl)bicyclo[2,2,2]octane prepared similarly, are claimed to be good working fluids for an air-cooled turbine operating in a closed Rankine cycle. 

Figure 5.5 can be used to place the different product streams with respect to the objectives required for commercial octane numbers for Eurosuper and Superplus. It is clearly evident that the preparation of Superplus (RON 98, MON 88) will require careful screening of its components. 

As a complementary process to reforming, isomerization converts normal paraffins to iso-paraffins, either to prepare streams for other conversions nCi —> /C4 destined for alkylation or to increase the motor and research octane numbers of iight components in the gasoiine pooi, i.e., the C5 or Cs-Ce fractions from primary distillation of the crude, or light gasoline from conversion processes, having low octane numbers. 

Write a series of equations showing how you could prepare octane from acetylene and any necessary organic and inorganic reagents J... 

Di- and Triisobutylcncs. Diisobutylene [18923-87-0] and tnisobutylenes are prepared by heating the sulfuric acid extract of isobutylene from a separation process to about 90°C. A 90% yield containing 80% dimers and 20% trimers results. Use centers on the dimer, CgH, a mixture of 2,4,4-trimethylpentene-1 and -2. Most of the dimer-trimer mixture is added to the gasoline pool as an octane improver. The balance is used for alkylation of phenols to yield octylphenol, which in turn is ethoxylated or condensed with formaldehyde. The water-soluble ethoxylated phenols are used as surface-active agents in textiles, paints, caulks, and sealants (see Alkylphenols). 

Neo acids are prepared from selected olefins using carbon monoxide and acid catalyst (4) (see Carboxylic Acids, trialkylacetic acids). 2-EthyIhexanoic acid is manufactured by an aldol condensation of butyraldehyde followed by an oxidation of the resulting aldehyde (5). Isopalmitic acid [4669-02-7] is probably made by an aldol reaction of octanal. 

Monochloramine is also used in organic synthesis for preparation of amines, substituted hydrazines, etc. For example, reaction of NH2CI with 3-azabicyclo [3.3.0]octane [5661-03-0] yields A/-amino-3-azabicyclo[3.3.0]octane [54528-00-6] a pharmaceutical intermediate (38). 

There are only few reactions known introducing substituents to the H-bearing nitrogen of oxaziridines. (V-Alkylation of l-oxa-2-azaspiro[2.5]octane (3,3-pentamethylene-oxaziridine 52) with r-butyl chloride to give (53) was carried out for structure proof of (52). This reaction is of no preparative importance, since N-alkylated oxaziridines are easily obtained by ring synthesis. 

The reactions are carried out under first-order conditions, i.e., the stoichiometric concentration of the antioxidant, a-tocopherol, is in large excess over that of 16-ArN, such that the concentration of a-tocopherol does not change significantly throughout the time course of the reaction. The emulsion employed was prepared by mixing the non-ionic emulsifier Brij 30, octane and HCl (3 mM, pH = 2.5). The resulting emulsion is opaque, thus values were obtained electrochemically by employing Linear Sweep Voltammetry (LSV). 

A useful self-terminating catalyst system (77), employs a Pd catalyst [prepared from Pd(OAc)2, NaH, and r-AmOH in THF]. The solvent required for the hydrogenation depends on the acetylene structure monosubslituted acetylenes require solvents such as hexane or octane, whereas disubstituted acetylenes need ethanol, ethanol-hydrocarbon, or ethanol-THF mixtures. In all cases it was necessary to use quinoline as a catalyst modifier. The authors consider this system one of the best for achieving both high yield and stereoselectivity. 

Benziloyloxy-1-azabicyclo[2.2.2] octane methobromide was prepared by adding 20 cc of a 30% solution of methyl bromide in ether to a solution of 2.5 g of 3-benziloyloxy-1-azabicyclo[2.2.2] octane in 20 cc of chloroform. After standing for 3 hours at room temperature and 15 hours at -i-5°C, a crystalline precipitate had formed. This was filtered off and recrystallized from a mixture of methanol, acetone, and ether prisms melting at 240° to 241°C. 

Because the Williamson synthesis is an S 2 reaction, it is subject to all the usual constraints, as discussed in Section 11.2. Primary halides and tosylates work best because competitive E2 elimination can occur with more hindered substrates. Unsymmetrical ethers should therefore be synthesized by reaction between the more hindered alkoxide partner and less hindered halide partner rather than vice versa. For example, terf-butyl methyl ether, a substance used in the 1990s as an octane booster in gasoline, is best prepared by reaction of tert-butoxide ion. with iodomethane rather than by reaction of methoxide ion with 2-chloro-2-methylpropane. 

This two step procedure appears to be by far the most convenient one for preparing exo-ch-bicyclo[3 3 0]octane-2-car-boxylic acid from the readily available starting materials The first step of the procedure is also illustrative of the method of obtaining 2-substituted bicyclo[3 3 Ojoctanes4,6 from cis cn-1,5-cyclooctadiene. 

Octanal has been prepared by the reduction of caprylonitrile with hydrogen chloride and stannous chloride,2 by the passage of a mixture of caprylic acid and formic acid over titanium dioxide3 or manganous oxide,4 by dehydrogenation of 1-octanol over copper,6 and by oxidation of 1-octanol.6... 

Alkali-metal phthalocyanines 1 are commonly prepared in situ by the reaction of the appropriate phthalocyanine with lithium in an alcohol like pentan-l-ol. If higher temperatures are required during the synthesis, octan-1-ol with its substantially higher boiling point is used. The reaction mixture is then refluxed with a compound containing the desired metal atom to yield the appropriate metal phthalocyanine 2. 

Finally, by a diastereoselective intramolecular double Michael reaction of a lithium dieno-late to an a,j6-unsaturated ester moiety, a spiro-fused bicyclo[2.2.2]octane may be prepared. These MIMIRC form the key step in the synthesis of ( )-atisine361 and (-t-)-alisirene362-365. 

A solution of phenyl trimethylsilylethyne (2.3 mmol) and octanal (2mmol) in THF (2.5 ml) was treated at 0°C with TBAF (0.06 mmol) for 1.5 h. The reaction mixture was diluted with hexane (25 ml), filtered through Celite, and concentrated. Purification by preparative t.l.c., followed by distillation, gave the product (1.4 mmol, 70%), b.p. 140-142 °C/15mmHg. 

A bicyclo[3.3.0]octane ring system 164 can be conveniently prepared by refluxing an acetonitrile solution of the azo compound 163 in the presence of excess of phenyl vinyl... 

---