Methyl alcohol cycloaddition

The low yields, which are observed among styrenyl adducts, reflect a combination of the poor reactivity of the styrene at the low temperature of the reaction. For example, the combination of t-butyl Grignard with the 2,4-bis-OBoc-benzyl alcohol 15 affords the corresponding benzopyran 50 in only 50% yield even when carried out in the presence of 5-10 equivalents of the styrene (method H, Fig. 4.27).27 Yields for substituted benzopyran styrene adducts are still lower (method G, Fig. 4.27). For example, addition of methyl lithium to 2,4-bis-OBoc-benzylaldehyde 5 followed by the addition of the dienophile and magnesium bromide affords benzopyran 51 in a paltry 27% yield. Method F is entirely ineffective in these cases, because the methyl Grignard reagent competes with the enol ether and with styrene 1,4-addition of methyl supercedes cycloaddition. 

Bicyclic nitroso acetals were able to be synthesised by employing ethyl vinyl ether (dienophile), styrene (dipolarophile) and the previously discussed resin-bound ni-troalkenes in a one-pot tandem [4+2]/[3+2]. As illustrated in Scheme 7.30, several aromatic and aliphatic substituents could be introduced to the bicyclic scaffold. Reductive cleavage of the cycloadducts with lithium aluminium hydride (LLAIH4) gave rise to the 3a-methyl alcohol substituted nitroso acetals in moderate overall yields. All these examples demonstrate that resin-bound nitroalkenes can be readily synthesised by microwave synthesis and thereafter can be used as starting materials, in a variety of high pressure-promoted cycloadditions. 

Chiral boron(III) complexes can catalyze the cycloaddition reaction of glyoxy-lates with Danishefsky s diene (Scheme 4.18) [27]. Two classes of chiral boron catalyst were tested, the / -amino alcohol-derived complex 18 and bis-sulfonamide complexes. The former catalyst gave the best results for the reaction of methyl glyoxylate 4b with diene 2a the cycloaddition product 6b was isolated in 69% yield and 94% ee, while the chiral bis-sulfonamide boron complex resulted in only... 

Analogously, the 1,3-dipolar cycloaddition reaction of 2-diazopropane with propargyl alcohol 62b, performed at 0 °C in dichloromethane, was completed in less then 10 h and led to a monoadduct 63b with the same regioselective addition mode of 59 to the triple bond. The HMBC spectrum showed correlations between the ethylenic proton and the carbons C3 and C5 and between the methyl protons and the carbons C3 and C4. 

In 1987, Vaultier and coworkers [27] developed a combination of a [4+2] cycloaddition of a bora-1,3-diene to provide an allylborane, which then reacts with an aldehyde to give a highly functionalized alcohol. The Lallemand group, as well as Hall and colleagues, has recently used this procedure. In an approach for the synthesis of the antifeedant natural product clerodin (4-83), Lallemand and coworkers performed a three-component domino reaction of 4-80, 4-81 and methyl acrylate to give 4-82 (Scheme 4.18) [28]. 

Alkenes are scavengers that are able to differentiate between carbenes (cycloaddition) and carbocations (electrophilic addition). The reactions of phenyl-carbene (117) with equimolar mixtures of methanol and alkenes afforded phenylcyclopropanes (120) and benzyl methyl ether (121) as the major products (Scheme 24).51 Electrophilic addition of the benzyl cation (118) to alkenes, leading to 122 and 123 by way of 119, was a minor route (ca. 6%). Isobutene and enol ethers gave similar results. The overall contribution of 118 must be more than 6% as (part of) the ether 121 also originates from 118. Alcohols and enol ethers react with diarylcarbenium ions at about the same rates (ca. 109 M-1 s-1), somewhat faster than alkenes (ca. 108 M-1 s-1).52 By extrapolation, diffusion-controlled rates and indiscriminate reactions are expected for the free (solvated) benzyl cation (118). In support of this notion, the product distributions in Scheme 24 only respond slightly to the nature of the n bond (alkene vs. enol ether). The formation of free benzyl cations from phenylcarbene and methanol is thus estimated to be in the range of 10-15%. However, the major route to the benzyl ether 121, whether by ion-pair collapse or by way of an ylide, cannot be identified. 

Syntheses of Carbocyclic Compounds (1.V.2.V )-2 (.V )-Amino(4-metho-xyphenyl)methyl]cyclopropan-l-ol 392 (Scheme 1.45) has been prepared by a stepwise procedure involving a 1,3-dipolar nitrile oxide cycloaddition to allyl alcohol followed by a constmction of the cyclopropa d isoxazole system, and reduction of the bicycle (436). 

The cycloaddition of allenyl sulfoxide 135 and cydopentadiene occurred at room temperature, giving the single adduct 136. The initially formed allylic sulfoxide underwent a rapid [2,3]-sigmatropic rearrangement. Treatment of 136 with trimethyl phosphite furnished alcohol 137. It should be noted that the reaction of methyl 4-hydroxy-2-butynoate with cydopentadiene failed to give 137. Thus, the allene 135 is considered as a masked and more reactive alkyne equivalent. 

Nucleophilic additions to (cyclohexadienone)Fe(CO)3 complexes (218) occur in a dia-stereospecific fashion (Scheme 56)197. For example, the Reformatsky reaction of ketone (218a) affords a simple diasteromeric alcohol product19715. The reduction of (1-carbo-methoxycyclohexa-l,3-dien-5-one)Fe(CO)3 (218b) to give 219 has been utilized in the enantioselective synthesis of methyl shikimate. In a similar fashion, cycloadditions of (2-methoxy-5-methylenecyclohexa-l,3-diene)Fe(CO)3 (220) occur in a diastereospecific fashion198. 

A cation radical chain cycloaddition-polymerization catalysed by tris(4-bromophenyl)aminium hexachloroantimonate has been reported to afford polymers with an average molecular weight up to 150000. Both cyclobutanation and Diels-Alder polymers were obtained. " The reactivity of the phospine radical cation towards nucleophiles was studied. Tributylphosphine reacted with l,l-dimethyl-4,4-bipyridinium (methyl viologen, MV) in the presence of an alcohol or thiol (RXH X = O, S), which resulted in the gradual formation of the one-electron reduced form... 

Regioselective [4-1-2] cycloadditions to Cjq are also possible with 2,3-dimethyl-buta-1,3-diene (4) and with the monoterpene 7-methyl-3-methylideneocta-l,6-diene (5, myrcene) [22]. These monoadduct formations proceed under mild and controlled conditions. Most of these addition products of 1,3-butadiene derivatives (e.g. 4, 5, 8-12) are unstable against air and light [25]. The dihydrofuUerene moiety in the Diels-Alder adducts act as a 02-sensitizer and promotes the oxidation of the cyclohexene moiety to the hydroperoxide. Reduction of the hydroperoxide with PPhj yields the corresponding allylic alcohols [25]. 

Scheme 1.64). The Ag(I)-mediated cyclization afforded dipole 306 for 1,3-dipolar cycloaddition with methyl vinyl ketone to yield adducts 307 and the C(2) epimer as a 1 1 mixture (48%). Hydrogenolytic N—O cleavage and simultaneous intramolecular reductive amination of the pendant ketone of the former dipolarophile afforded a mixture of alcohol 308 and the C(6) epimer. Oxidation to a single ketone was followed by carbonyl removal by conversion to the dithiolane and desulfurization with Raney nickel to afford the target compound 305 (299). By this methodology, a seven-membered nitrone (309) was prepared for a dipolar cycloaddition reaction with Al-methyl maleimide or styrene (301). 

This cycloaddition-reduction-hydrolysis sequence was also used in an approach to butyrolactones related to ribonolactone (71). These compounds are inducing agents of hunger and satiety in mammalians. Here, a subsequent aldol 1,3-diol reduction was used, and the required carboxy function was established by oxidation of the aromatic ring with ruthenium tetroxide. Cycloaddition of benzonitrile oxide to allyl alcohol afforded an enantiomeric mixture of isoxazolines 55 and 56, which were treated with sodium hydride and methyl iodide to achieve separation by chromatography on cellulose triacetate (71). 0-Demethylation, followed by... 

The above azomethine ylide cycloadditions have been extended to an enantioselective version involving amino alcohols both as chiral ligands and amine bases. Thus, reactions of the N-metalated azomethine yhdes derived from achiral methyl 2-(arylmethyleneamino)acetates, cobalt(II) chloride [or manganese(II) bromide], and chiral amino alcohols, 1 and 2 equiv each, with methyl acrylate as solvent have been performed to provide the enantiomer-enriched pyrrolidine-2,4-dicarboxylates with the enantioselectivities of up to 96% enantiomeric excess (ee) (128,129). However, a large excess of the metal ions and the chiral source (ligand and base) have to be employed. 

N/L recorded was 16,000 for the reactions using the magnesium aUcoxide of 3-methyl-2-buten-l-ol as a multisubstituted internal allylic alcohol substrate, which is why regiocontrol is still effective in the reactions in a highly coordinating solvent such as THE. Rate enhancement is much lower in the nitrile oxide cycloaddition reactions using homoallylic alcohol substrates. 

Hydrolase-catalyzed domino reactions incorporating a resolution and a subsequent cycloaddition reaction have been described [95-97]. This constitutes an attractive approach to complex synthetic intermediates. For example, the l-(3-methyl-2-furyl)]propanol roc-93 reacts with ethoxyvinyl methyl fumarate (94) catalyzed by Lipase LIP (from Pseudomonas aeruginosa) to furnish a dienophilic fumarate ester, which spontaneously undergoes an intramolecular Diels-Alder reaction with the furan moiety furnishing exclusively the syn-adduct, the oxabicy-clohexene 95 in excellent along with the remaining alcohol S-96 (Scheme 4.31) [95]. A similar approach has been used for a procedure that includes a series of domino reactions that includes dynamic kinetic resolution of the 3-vinylcyclohex-... 

Another possible route to thienamycin (487) has utilized the dipolar cycloaddition of 1-pyrroline 1-oxide (482) with methyl crotonate (79TL4359). The reaction is highly stereoselective due to the operation of secondary orbital effects. The isoxazolidine (483), produced in 90% yield, was subjected to hydrogenolysis, and the resulting amino alcohol (484) was selectively blocked with hexamethyldisilazane to give (485). Treatment with ethylmagnesium bromide then gave /3-lactam (486 Scheme 107). 

---