Injection molding liquid

Liquid-Injection Molding. In Hquid-injection mol ding (LIM), monomers and oligomers are injected into a mold cavity where a rapid polymerization takes place to produce a thermoset article. Advantages of these processes are low cost, low pressure requirement, and flexibiHty in mold configuration. Conventional systems, such as isocyanate with polyol, release Htfle or no volatiles. The generation of substantial volatiles in the mold is obviously undesirable and has represented a significant obstacle to the development of a phenoHc-based LIM system. A phenoHc LIM system based on an... 

The typical TP encapsulation process is an insert injection molding or liquid injection molding operation. The insert, a coil, or an integrated circuit, for example, is placed in a mold equipped with either fixed spider type supports or retractable pins or other features to support it when molten TP is injected. 

Latchup mode, 22 252 Latent acid catalysts, in liquid-injection molding, 18 795... 

Liquid-injection-molded (LIM) rubber, properties and applications of, 22 584-585... 

Liquid injection molding (LIM), 18 792 phenolic resins in, 13 794-795 Liquid inks, 14 315 Liquid iodine, viscosity of, 14 354 Liquid ion-exchange rhenium recovery process, 21 689... 

Liquid injection molding, for silicone rubbers, 3, 674—675 Liquid ligands, in metal vapor synthesis, 1, 229 Liquid-phase catalysis, supported, for green olefin hydroformylation, 12, 855 Lithiacarbaboranes, preparation, 3, 114 Lithiation, arene chromium tricarbonyls, 5, 236 Lithium aluminum amides, reactions, 3, 282 Lithium aluminum hydride, for alcohol reductions, 3, 279 Lithium borohydride, in hydroborations, 9, 158 Lithium gallium hydride, in reduction reactions, 9, 738 Lithium indium hydride, in carbonyl reductions, 9, 713—714... 

Figure 1. Liquid injection molding for a two component system...

Foamed casting is a simple non-mechanical version of pouring (Chapter 11), reaction injection molding (RIM) (Chapter 12) or liquid injection molding (LIM) (Chapter 16). Liquid components of the plastic with... 

Liquid injection molding (LIM) is a variation of the RIM process. The major difference is in the manner in which the liquid components are mixed. In the LIM process the entire shot is mixed in a chamber before injection into the mold, rather than being continuously mixed and injected, as in the RIM process (Chapter 16). 

Different casting processes are used. They tend to overlap and could be identified by other processing methods. An example is liquid injection molding that can be identified as injection molding (Chapter 4) or reaction injection molding (Chapter 12). Many decades ago the reaction injection molding process was initially called liquid injection molding. 

Figure 11.1 Example of a liquid injection molding casting process...

Liquid injection molding (LIM) is a variation of the reaction injection molding (RIM) process (Chapter 11). 

The latest trend in foamed composites is automotive structural parts produced by the SRIM (structural reaction-injection-molding) process. The SRIM process is a method of the reactive liquid injection molding (i.e., LIM). LIM includes RIM (reaction injection molding), RRIM (reinforced RIM) and RTM (resin transfer molding). IX M (Liquid Composite Molding) is a relatively new technical term which includes SRIM, RRIM and RTM (Resin Transfer Molding). 

---