Resin transfer

Methacrylate monomers are most effective with derivatives of bisphenol A epoxy dimethacrylates, in which the methacrylate—methacrylate cross-linking reaction proceeds at a much faster pace than with styrene monomer. This proves beneficial in some fabrication processes requiring faster cure, such as pultmsion and resin-transfer mol ding (RTM). 

For some years there has been concern at the amount of styrene vapour in workshops preparing reinforced polyester laminates. More recently this has increased interest in polyester-polyurethane hybrids and in the further development of closed moulding and resin transfer moulding techniques as well as greater use of lower styrene levels. 

C. F. Johnson, Resin Transfer Molding and Structural Reaction Injection Molding in Engineering Materials Handbook, Vol. 2, ASM, International, USA (1988). 

Resin Transfer Molding Spray-up Hand Lay-up Mat-Preform Compound... 

Resin transfer molding With vacuum assisted RTM, this process can be called infusion molding. RTM usually uses liquid TS plastics that is transferred or injected into an enclosed mold usually at low pressures of about 60 psi (410 kPa) in which reinforcement... 

SCRIMP process This Seeman Composites Resin Infusion Process (SCRIMP) is described as a gas-assist resin transfer molding process. As an example glass fiber fabrics/ thermoset vinyl ester polyester plastic and polyurethane foam panels (for insulation) are placed in a segmented tool. A vacuum is pulled with a bag so that a huge amount of plastic can be drawn into the mold (Marco process approach). Its curved roof is made separately and bonded to the box with mechanical and adhesive fastening. It is similar to various reinforced plastics molding processes. 

Table 8-32 Comparison of resin transfer, compression, and injection molding RP processes...

Spray ing/bru shing/rolling Resin transfer molding Rotational casting Rotomolding Thermoforming Compounding/vulcani-zation... 

Conversion of cyclic oligomers to composite structures via Resin Transfer Molding (RTM) and Reaction Injection Molding (RIM) techniques has been demonstrated, and will be the subject of subsequent publications. Glass loadings... 

---