Liquid injection molding plastics used

There are many different types of molding processes for plastic. Injection molding is one of the most common processes (Figure 16-14). The plastic starts out in the form of small pellets. After being melted to a liquid state, the plastic is forced into a mold, known as a die, under pressure. Injection molding is used to form game pieces, dice, and similar products. 

Urethanes are processed as rubber-like elastomers, cast systems, or thermoplastic elastomers. The elastomer form is mixed and processed on conventional mbber mills and internal mixers, and can be compression, transfer, or injection molded. The liquid prepolymers are cast using automatic metered casting machines, and the thermoplastic pellets are processed like all thermoplastic materials on traditional plastic equipment. The unique property of the urethanes is ultrahigh abrasion resistance in moderately high Shore A (75—95) durometers. In addition, tear, tensile, and resistance to many oils is very high. The main deficiencies of the urethanes are their resistance to heat over 100°C and that shear and sliding abrasion tend to make the polymers soft and gummy. 

Because PTFE melts at such a high temperature and the melt is very viscous, it is difficult to work by conventional plastics techniques such as injection molding or extrusion. It is usually formed into useful shapes by sintering at about 380 °C sometimes liquid alkanes are used as a carrier, but the product then tends to be porous (this emerges as a serious problem when thin-walled objects are machined out of PTFE stock). Accordingly, several fluorocarbon thermoplastics have been developed that have lower melt viscosities, at the expense of somewhat poorer thermal and mechanical properties than PTFE. For example, the thermoplastic FEP (fluori-nated ethylene propylene), made by copolymerization of F2C=CF2 and... 

Substitute for Conventional Vulcanized Rubbers, For this application, the products are processed by techniques and equipment developed for conventional thermoplastics, ie, injection molding, extrusion, etc. The S—B—S and S—EB—S polymers are preferred (small amounts of S—EP—S are also used). To obtain a satisfactory balance of properties, they must be compounded with oils, fillers, or other polymers compounding reduces costs. Compounding ingredients and their effects on properties are given in Table 8. Oils with high aromatic content should be avoided because they plasticize the polystyrene domains. Polystyrene is often used as an ingredient in S—B—S-based compounds it makes the products harder and improves their processibility. In S—EB—S-based compounds, crystalline polyolefins such as polypropylene and polyethylene are preferred. Some work has been reported on blends of liquid polysiloxanes with S—EB—S block copolymers. The products are primarily intended for medical and pharmaceutical-type applications and hardnesses as low as 5 on the Shore A scale have been reported (53). 

Fibers, films, and bristles are examples of extruded forms. Plastics may be shaped by either compression molding (direct pressure on solid material in a hydraulic press) or injection molding (injection of a measured amount of material into a mold in liquid form). The latter process is most generally used, and... 

Coiorquid. [Colotco] Liquid coltx dispersions for use in injection molding, blow molding, and extrusion of plastic resins. 

Obtained forms of foamed plastics are blocks, sheets, slabs, boards, molded products, and extruded shapes. These plastics can also be sprayed onto substrates to form coatings, foamed in place between walls (i.e., poured into the empty space in liquid form and allowed to foam), or used as a core in mechanical structures. It has also become possible to process foamed plastics by conventional processing machines like extruders and injection-molding machines. 

---