Intramolecular polymerization

Polymeranalogous reactions considered above may be referred to as intramolecular condensation transformations since they are accompanied by elimination of low-molecular products. On the other hand, PCSs can be obtained via polymeranalogous transformations, principally intramolecular polymerization reactions . Thermal and chemical cyclization of poly(acrilonitrile) (PAN) is an example of processes of this type. It was demonstrated by a number of researchers216-225 that thermal transformations of PAN follow the scheme ... 

A terpolymer from a family of intramolecular polymeric complexes (i.e., polyampholytes), which are terpolymers of acrylamide-methyl styrene sulfonate-methacrylamido propyltrimethylammonium chloride [106,1418], has been reported. 

Peiffer, D.G., Lundberg, R.D., and Turner, S.R. "Intramolecular Polymeric Complexes viscosifiers for Acid, Base and Salt (Aqueous) Solutions," US Patent 4,461,884(1984). 

This paper is dedicated to Professor George B. Butler, who initiated all of the interest and research in the field of inter-intramolecular polymerization, on the occasion of his 65th birthday. 

Intramolecular polymerization n. Polymerization which occurs within an individual molecule. For example, drying oils consist of triglyceride esters, involving up to three unsaturated fatty acids attached to a single glycerol molecule. Under certain conditions, polymerization is believed to occur between neighboring fatty acid chains in a single molecule. 

Instead only the ladder polymer of the txa-/P(3-type can be formed. On the other hand, the authors believe that the higher reactivity of compounds 57-65 arises from the ability to undergo intramolecular polymerization in addition. 

Marvel, C. S. Stille, J. K. Intermolecular-intramolecular polymerization of a-diolefins by metal alkyl coordination catalysts. J. Am. Chem. Soc. 1958, 80, 1740-1744. 

In addition to the aforementioned transformations, the photo-induced Bergman cyclization was utilized by Zhu and coworkers to form intramolecular polymeric nanoparticles.The appropriate reactive diyne unit was incorporated into the polymer using both direct controlled radical polymerization and aHqme protection strategies. The resulting linear polymers were subjected to photochemical Bergman cyclization conditions using a continuous addition strategy, similar to the case previously discussed. ... 

If the concentration of monomer used is very low, below the critical concentration, and concentration of initiating radicals is rather high, one can expea intramolecular polymerization leading to the product with ladder-typ>e stiuctiue. 

Free-radical ring-closure polymerization has been a common phenomenon in polymer chemistry for some time. Inter-intramolecular polymerization dates from the publication of Butler and Angelo in 1957, in which diallyldi-methylammonium bromide was polymerized by a free radical mechanism to produce a soluble polymer with the formation of five-membered rings. Apparently the reaction is kineti-cally controlled since the formation of the five-membered... 

Fig. 42 Photocurable gelatin for application to femtosecond laser microfabrication, a Chemical structures of styrene-derived gelatin, b photogelation mechanism by formation of cross-linked gelatin networks via intermolecular crosslinking and intramolecular polymerization...

Carbanions stabilized by phosphorus and acyl substituents have also been frequently used in sophisticated cyclization reactions under mild reaction conditions. Perhaps the most spectacular case is the formation of an ylide from the >S-lactam given below using polymeric Hflnig base (diisopropylaminomethylated polystyrene) for removal of protons. The phosphorus ylide in hot toluene then underwent an intramolecular Wlttig reaction with an acetyl-thio group to yield the extremely acid-sensitive penicillin analogue (a penem I. Ernest, 1979). 

The synthesis of five-, six-, and seven-membered cyclic esters or timides uses intramolecular condensations under the same reaction condifions as described for intermolecular reactions. Yields are generally excellent. An example from the colchicine synthesis of E.E. van Ta-melen (1961) is given below. The synthesis of macrocyclic lactones (macrolides) and lactams (n > 8), however, which are of considerable biochemical and pharmacological interest, poses additional problems because of competing intermolecular polymerization reactions (see p. 246ff.). Inconveniently high dilution, which would be necessary to circumvent this side-... 

The cyclization reactions discussed here either involve the intramolecular reaction of a donor group D with an acceptor group A or a cyclizing dimerization of two molecules with two terminal acceptors and two donors. A polymerization reaction will always compete with cyclization. For macrolides see p. 146 and p. 319 — 329. 

Haward et al.t have reported some research in which a copolymer of styrene and hydroxyethylmethacrylate was cross-linked by hexamethylene diisocyanate. Draw the structural formula for a portion of this cross-linked polymer and indicate what part of the molecule is the result of a condensation reaction and what part results from addition polymerization. These authors indicate that the crosslinking reaction is carried out in sufficiently dilute solutions of copolymer that the crosslinking is primarily intramolecular rather than intermolecular. Explain the distinction between these two terms and why concentration affects the relative amounts of each. 

The polymerization of ethyleneimine (16,354—357) is started by a catalyticaHy active reagent (H or a Lewis acid), which converts the ethyleneimine into a highly electrophilic initiator molecule. The initiator then reacts with nitrogen nucleophiles, such as the ethyleneimine monomer and the subsequendy formed oligomers, to produce a branched polymer, which contains primary, secondary, and tertiary nitrogen atoms in random ratios. Termination takes place by intramolecular macrocycle formation. 

Aqueous hydrofluoric acid dissolved in acetonitrile is a good catalyst for intramolecular Diels-Alder reactions [9] This reagent promotes highly stereoselective cyclizations of different triene esters (equation 8) The use of other acids, such as hydrochloric, acetic, and trifluoroacetic acid, results in complete polymerization of the starting trienes [9] (equation 8)... 

Metal selenolates of the type M(SeAr)2 (M = Zn, Cd, Hg) are usually insoluble, polymeric compounds. Intramolecular Se N coordination has been employed to stabilize monomeric mercury selenolates, e.g., 15.27, but this approach was not successful for the zinc and cadmium derivatives. ... 

Acyclic diene molecules are capable of undergoing intramolecular and intermolec-ular reactions in the presence of certain transition metal catalysts molybdenum alkylidene and ruthenium carbene complexes, for example [50, 51]. The intramolecular reaction, called ring-closing olefin metathesis (RCM), affords cyclic compounds, while the intermolecular reaction, called acyclic diene metathesis (ADMET) polymerization, provides oligomers and polymers. Alteration of the dilution of the reaction mixture can to some extent control the intrinsic competition between RCM and ADMET. 

PE produced by a high-pressure polymerization process (pressure 1000-3000 atm) using a free radical initiator is a highly branched material that contains both LCBs and SCBs. The polymer so produced is a low-density material (density up to about 0.925 g/cc) and is known as high-pressure low-density PE (HP LDPE). The LCBs are formed via intermolecular hydrogen transfer [19], whereas SCBs are formed by intramolecular hydrogen abstraction [16]. 

The SCB distribution (SCBD) has been extensively studied by fractionation based on compositional difference as well as molecular size. The analysis by cross fractionation, which involves stepwise separation of the molecules on the basis of composition and molecular size, has provided information of inter- and intramolecular SCBD in much detail. The temperature-rising elution fractionation (TREE) method, which separates polymer molecules according to their composition, has been used for HP LDPE it has been found that SCB composition is more or less uniform [24,25]. It can be observed from the appearance of only one melt endotherm peak in the analysis by differential scanning calorimetry (DSC) (Fig. 1) [26]. Wild et al. [27] reported that HP LDPE prepared by tubular reactor exhibits broader SCBD than that prepared by an autoclave reactor. The SCBD can also be varied by changing the polymerization conditions. From the cross fractionation of commercial HP LDPE samples, it has been found that low-MW species generally have more SCBs [13,24]. 

If the grafting is carried out in air, the active sites on the polymeric backbone is attacked by atmospheric oxygen leading to the formation of macroperoxy radical, which might abstract the hydrogen atom from the backbone polymer by an inter- or intramolecular process to give hydroperoxide groups as shown. 

The structure of the chain, i.e., whether it is a helix or a random coil, might influence not only the rate but also the stereospecificity of the growing polymer. For example, it is plausible to expect that in normal vinyl polymerization helix formation might favor specific placement, say isotactic, while either placement would be approximately equally probable in a growing random coil. Formation of a helix requires interaction between polymer segments, and this intramolecular interaction is enhanced by bad solvents particularly those which precipitate the polymer. 

Acrylamides represent still another interesting class of monomers.6 Their anionic polymerization may be initiated by strong bases, like, e.g., amides. The growing chain contains the unit —CH2—CH —CO—NH2 and intramolecular proton transfer competes efficiently with its carbanionic growth. Since the rearrangement... 

Ideal localized adsorption, 5, 10 Infrared method, 373, 374 Initiators of polymerization, 148 Intramolecular London energies, 74, 78 Iodine molecule intramolecular London energy, 78... 

As has been described in Chapter 4, random copolymers of styrene (St) and 2-(acrylamido)-2-methylpropanesulfonic acid (AMPS) form a micelle-like microphase structure in aqueous solution [29]. The intramolecular hydrophobic aggregation of the St residues occurs when the St content in the copolymer is higher than ca. 50 mol%. When a small mole fraction of the phenanthrene (Phen) residues is covalently incorporated into such an amphiphilic polyelectrolyte, the Phen residues are hydrophobically encapsulated in the aggregate of the St residues. This kind of polymer system (poly(A/St/Phen), 29) can be prepared by free radical ter-polymerization of AMPS, St, and a small mole fraction of 9-vinylphenanthrene [119]. 

---