Initiation rapid

Treating a benzene suspension of sodium borohydride (4 equiv.) With glacial acetic acid (3.25 equiv.) And refluxing the mixture for 15 min under nitrogen, after the initial rapid gas evolution subsided (ca. 3 mol of Hz liberated) [No Smoking ], gave a clear solution of NaBH(OAc)3. ... 

Catalytic reactor. The role of the catalyst was described earlier it must burn enough of the incoming fuel to generate an outlet gas temperature high enough to initiate rapid homogeneous combustion just past the catalyst exit. 

A competing reaction in any Birch reduction is reaction of the alkali metal with the proton donor. The more acidic the proton donor, the more rapid IS the rate of this side reaction. Alcohols possess the optimum degree of acidity (pKa ca. 16-19) for use in Birch reductions and react sufficiently slowly with alkali metals in ammonia so that efficient reductions are possible with them. Eastham has studied the kinetics of reaction of ethanol with lithium and sodium in ammonia and found that the reaction is initially rapid, but it slows up markedly as the concentration of alkoxide ion in the mixture... 

Dimethyl sulfate (16 g) is added to a mixture of dimethyl carbonate (400 g) and deuterium oxide (1(X) g) in a 1 liter flask. Two reflux condensers and a drying tube are attached in series (initial rapid evolution of carbon dioxide may entrain some liquid), and the reaction mixture is heated under reflux for 72 hr. The methanol-OD is distilled directly from the reaction flask through a 30 cm Vigreux column. Redistillation from a small amount of sodium yields 275 g of pure methanol-OD bp 66-66.5° isotopic purity, 98.6%. ... 

CIO2 dissolves exothermically in water and the dark-green solutions, containing up to 8g/l, decompose only very slowly in the dark. At low temperatures crystalline clathrate hydrates, C102.nH20, separate (n 6-10). Illumination of neutral aqueous solutions initiates rapid photodecomposition to a mixture of chloric and hydrochloric acids ... 

The initial rapid uptake of more than three molar equivalents of... 

As a plastic is subjected to a fixed stress or strain, the deformation versus time curve will show an initial rapid deformation followed by a continuous action. Examples of the standard type tests are included in Fig. 2-1. Details on using these type specimens under static and dynamic loads will be reviewed throughout this chapter. (Review also Fig. 8-9 that relates elasticity to strain under different conditions.)... 

When an aqueous solution of an arenediazonium salt is added to an alkaline buffer solution, an initial rapid reaction occurs. All experimental evidence is consistent with the hypothesis that only the (Z)-diazoate is formed. Theoretically, however, the competitive formation of the (ii)-isomer in very small quantities cannot be excluded... 

Rapid and dense nucleation, or initial rapid surface growth, followed by advance of interface from all, or certain specific, surfaces into the bulk of crystallites... 

The sulfanes are soluble in carbon disulfide, benzene, tetrachloromethane, and dry diethylether (decreasingly so in that order) while alcohols and aqueous systems initiate rapid decomposition. For this reason a report on the chromatographic separation of the sulfanes H2S by reversed-phase HPLC using methanol as an eluent [35] was shown to be in error The peaks observed in the chromatogram have to be assigned to bismethoxy oligosulfanes... 

The increase in Ca is initiated rapidly and begins to recover after 1 min. The order of potency correlates fairly well with the solubilities of these compounds in organic solvents (37) and their abilities to accumulate in phospholipid vesicles (38), i.e., 6>y>a>p, but not with their insecticidal activity (y 6>a p 39). At these concentrations, crystals of p-, a-, and y-HCH were evident in the cell suspensions when we made simultaneous measurements of the right-angle light scatter, indicating that the order of aqueous solubilities is 6>y>a>p. However, stimulation by 6-HCH at concentrations below its aqueous solubility limit shows a typical dose dependency of the response (Figure 10). 

From the evidence currently available it appears that the mechanism of oxythallation is similar to that of oxymercuration. That is, initial rapid formation of a 7r-complex—a thallinium ion—followed by rearrangement of this species to give a o-bonded organothallium derivative (54). Decomposition of this latter intermediate by one or more of the processes shown in Scheme 8 then leads to products. The results obtained from a number of kinetic studies are in broad general agreement with this interpretation (52,79). 

The influence of polymer composition and molecular weight on the estrus-suppressing activity of the microspheres in female rats was determined. A triphasic release pattern was observed. An initial rapid release over the first few days was attributed to diffusion from superficial areas of the microspheres. A second phase of lower release levels then occurs and continues until the onset of the third, major phase of release. This phase is facilitated by the onset of erosion of the polymer matrix. 

The time evolution of the mean size of CdS and ZnS nanoparticles in water/AOT/ -heptane microemulsions has been investigated by UV-vis spectrophotometry. It was shown that the initial rapid formation of fractal-hke nanoparticles is followed by a slow-growing process accompanied by superficial structural changes. The marked protective action of the surfactant monolayer adsorbed on the nanoparticle surface has been also emphasized [230,231],... 

Mechanical Response. PTX (5 x 10" to 3 x 10 M) caused a concentration-dependent contraction of the guinea pig vas deferens. The configuration of contractile response indicated the presence of two components, an initial rapid component followed by a second slow component. The first component of the response to PTX was abolished after treatment with Mg (10 mM), Ca -free medium, or ouabain (10 M), but remained almost unaffected by phentolamine (10 M), reserpine, 6-OHDA, atropine, or mecamylamine (10" M). The second component of the response to PTX was also completely inhibited after the incubation in the high or Ca -free medium. Phentolamine, reserpine, or 6-... 

As the mechanism for the reaction between H2 and Br2 shows, the observation of an order other than first or second indicates that some step beyond the first one in the mechanism is rate-determining. The one-half-order rate dependence for Bf2 comes about because of the initial rapid cleavage reaction in which each Bf2 molecule produces two Br atoms. 

Hydrazine reduction of ferric ethylenediaminetetraacetate (denoted FeY ) gives nitrogen in high yield" In the absence of added phenanthroline the reaction, initially rapid, slows down and becomes second order in FeY . When ferrous ethylenediaminetetraacetate (FeY ) is initially present, the reaction is second-order in FeY throughout. In the presence of phenanthroline the order in FeY is one throughout. Under both sets of conditions the reaction is first-order in hydrazine. 

The long-term stability of the Ru/Ti02 catalyst was studied under various reaction conditions and the spent catalysts were characterized for assessing the reasons of deactivation. It was observed that the rate exhibits a rapid reduction at the initial several hours of reaction, followed by a slow and continuous deactivation. Analysis of the spent catalyst, by H2 adsorption after removing surface carbon, showed that the initial rapid reduction of activity is mainly due to metal sintering, while the continuous and slow deactivation is related to the occurrence of the SMSl phenomenon at the later part of the catalyst bed, where reducing conditions prevail. In order to avoid these processes which lead to catalyst deactivation, Ti02... 

---