Hydrochloric acid species concentration

Exercise 1 A total of 10 mol of cadmium nitrate is dissolved in 1 L of hydrochloric acid of concentration 1 mol/L. Calculate the concentrations of the different species. The stability constants values are given in Table 24.1. 

The concentration of species in solution may range from very small to large. For example in a saturated aqueous solution of silver chloride, the concentration of silver ions is about 10 M, while for concentrated hydrochloric acid the concentration of hydrogen and chloride ions is about 10 M. For convenience, a logarithmic scale is often used ... 

The raw precious metal concentrate is totally dissolved in hydrochloric acid—chlorine solution to form the soluble chloride ions of each of the metals. Silver remains as insoluble silver chloride and can be filtered off. Gold, in the form of [AuClJ, is extracted with, eg, tributyl phosphite or methyl isobutyl ketone. Base metals are also extracted in this step, and are removed from the organic phase by scmbbing with dilute hydrochloric acid (HCl). Iron powder is then used to reduce the gold species and recover them from the organic phase. 

Hundreds of chemical species are present in urban atmospheres. The gaseous air pollutants most commonly monitored are CO, O3, NO2, SO2, and nonmethane volatile organic compounds (NMVOCs), Measurement of specific hydrocarbon compounds is becoming routine in the United States for two reasons (1) their potential role as air toxics and (2) the need for detailed hydrocarbon data for control of urban ozone concentrations. Hydrochloric acid (HCl), ammonia (NH3), and hydrogen fluoride (HF) are occasionally measured. Calibration standards and procedures are available for all of these analytic techniques, ensuring the quality of the analytical results... 

In this cell, the following independent phases must be considered platinum, silver, gaseous hydrogen, solid silver chloride electrolyte, and an aqueous solution of hydrogen chloride. In order to be able to determine the EMF of the cell, the leads must be made of the same material and thus, to simplify matters, a platinum lead must be connected to the silver electrode. It will be seen in the conclusion to this section that the electromotive force of a cell does not depend on the material from which the leads are made, so that the whole derivation could be carried out with different, e.g. copper, leads. In addition to Cl- and H30+ ions (further written as H+), the solution also contains Ag+ ions in a small concentration corresponding to a saturated solution of silver chloride in hydrochloric acid. Thus, the following scheme of the phases can be written (the parentheses enclose the species present in the given phase) ... 

Crystals of [Tc(tu)6]Cl3 or [TcCl(tu)5]Cl2 are often employed for the synthesis of technetium(III) complexes. However, since the direct reduction of pertechnetate with excess thiourea in a hydrochloric acid solution yields [Tc(tu)6]3+ in high yield [37], direct use of the aqueous solution of the thiourea complex would be preferable for the synthesis of the technetium(III) complex without isolation of the crystals of the thiourea complex. In fact, technetium could be extracted from the aqueous solution of the Tc-thiourea complex with acetylacetone-benzene solution in two steps [38]. More than 95% extraction of technetium was attained using the following procedure [39] First a pertechnetate solution was added to a 0.5 M thiourea solution in 1 M hydrochloric acid. The solution turned red-orange as the Tc(III)-thiourea complex formed. Next, a benzene solution containing a suitable concentration of acetylacetone was added. After the mixture was shaken for a sufficient time (preliminary extraction), the pH of the aqueous phase was adjusted to 4.3 and the aqueous solution was shaken with a freshly prepared acetylacetonebenzene solution (main extraction). The extraction behavior of the technetium complex is shown in Fig. 6. The chemical species extracted into the organic phase seemed to differ from tris(acetylacetonato)technetium(III). Kinetic analysis of the two step extraction mechanism showed that the formation of 4,6-dimethylpyrimidine-... 

To test the validity of the extended Pitzer equation, correlations of vapor-liquid equilibrium data were carried out for three systems. Since the extended Pitzer equation reduces to the Pitzer equation for aqueous strong electrolyte systems, and is consistent with the Setschenow equation for molecular non-electrolytes in aqueous electrolyte systems, the main interest here is aqueous systems with weak electrolytes or partially dissociated electrolytes. The three systems considered are the hydrochloric acid aqueous solution at 298.15°K and concentrations up to 18 molal the NH3-CO2 aqueous solution at 293.15°K and the K2CO3-CO2 aqueous solution of the Hot Carbonate Process. In each case, the chemical equilibrium between all species has been taken into account directly as liquid phase constraints. Significant parameters in the model for each system were identified by a preliminary order of magnitude analysis and adjusted in the vapor-liquid equilibrium data correlation. Detailed discusions and values of physical constants, such as Henry s constants and chemical equilibrium constants, are given in Chen et al. (11). 

These elements are noble metals and, as such, can be dissolved only with great difficulty. The usual leaching agent is hydrochloric acid, with the addition of chlorine to increase the solution oxidation potential. This strong chloride medium results in the almost exclusive formation of aqueous chloroanions, with, under certain circumstances, the presence of some neutral species. Very seldom are cationic species formed in a chloride medium. However, these elements do possess a range of easily accessible oxidation states and, with the possibility of a number of different anionic complexes that are dependent on the total chloride concentration, this provides a very complicated chemistry. A summary of the most important chloro complexes found in these leach solutions is given in Table 11.6, from which the mixed aquochloro and polynuclear species have been omitted. The latter are found especially with the heavier elements. 

Neutralization of the strip solution with hydrochloric acid gives Pd(NH3)2-CI2 as product. One of the problems that has emerged is the formation of di- -hexylsulfoxide [34] by oxidation of the sulfide. This may cause several problems including extraction of iron(III) that is strongly dependent on the HCl concentration. The iron can easily be stripped by water. There have also been indications of a buildup of rhodium in the extract phase that again can be explained by the extraction of anionic rhodium species by the sulfoxide. One benefit from the presence of the sulfoxide is that the rate of palladium extraction is increased by the presence of the protonated sulfoxide at high acidities however, this kinetic enhancement is less that found with TOA HCl, which remains protonated even at low acidities. 

In order to preclude this problem and the necessary frequent regeneration of the anion system s suppressor column, an ion chromatography exclusion scheme was utilized. Samples collected in a mine environment were reliably concentrated by freeze-drying and then analyzed on an ICE system with dilute hydrochloric acid eluent. The precision of the ICE method was experimentally determined to be 2.5% in a concentration range of 1 to 10 yg/mL. The accuracy was not independently determined but good precision and recovery yield confidence that measured values are within 5% of the true value. No interferences were observed in the ICE system due to strong acids, carbonic acid or other water soluble species present in mine air subject to diesel emissions. 

Since the distribution of the chlorooxo-osmate species present in the hydrochloric acid solution that is loaded on the generator is affected by the acid concentration C5), a series of generators were prepared using a range of hydrochloric acid concentrations to dissolve the potassium osmate precipitate. The results obtained with these generators are included in Table... 

Scandium complexes with chloride ion in aqueous solution, and there is ion-exchange evidence for anionic species, presumably ScClJ aq, in concentrated hydrochloric acid,119 while values of K = 90 and K2 - 37 for the first two association constants have been reported.1211 Solid salts of the anions ScClt-, St Cll- and ScCl2- have been isolated with alkali metal cations.121,122 It seems likely that both the first two species are octahedral and bridged-octahedral respectively, in line with Cs2NaScCl6 which has an X-ray powder pattern in accord with a face-centred cubic structure.123... 

The reaction of Mo(CO)6 and acetic acid is still the most convenient preparative route known for condensing two monomeric units into a compound containing a quadruple bond. In fact, facile conversion of Mo2(02CCH3)4 to chloro species occurs in concentrated hydrochloric acid to form the Mo2 Clj ion (36), which is isostructural with the Re2Clg ion. The eclipsed configuration of Mo2Clg" and the molybdenum atom separation of 2.14 A are entirely consistent with a quadruple bond in the anion as expected (33). 

---