Enolate examples

The Mannich reaction of an aldehyde enol (example Formula C in Figure 12.14) or a ketonic enol (example Formula C in Figure 12.15) often proceeds beyond the hydrochloride of a /l-aminocarbonyl compound or the Mannich base. The reason is that the secondary amine or its hydrochloride, which has previously been incorporated as part of the iminium ion, is relatively easy to eliminate from these two types of product. The elimination product is an a,fi-unsaturated aldehyde (example Formula E in Figure 12.14) or an a,/l-unsaturated ketone (example Formula D in Figure 12.15)—that is, an a,/l-unsaturated carbowyl compound. Figure 13.51 will show how the Mannich reaction of a carboxylated lactonic enol provides access to an a-methylene lactone, that is, an a,/l-unsaturated carboxyl compound. 

Preformed enolates are susceptible to further methods of oxygenation. For example treatment with LTA in benzene effects a-acetoxylation at lower temperature and more rapidly than the corresponding enol examples. Similarly a-benzoylation using benzoyl peroxide is possible for both lactones and 3-keto esters and presumably could be used for less-activated ketones. 

Stereoselective oxidation is possible. A notable synthetic exan ile involved hydroxylation of lactam (147) to produce a single diastereomer of the functionalized isoindoline — an intermediate required during work related to the cytochalasins. It should be noted that in all the amide enolate examples the tertiary amide is utilized. 

These enolates are usually generated by deprotonation below 0°C. At higher temperatures the enolate ejects the leaving group via path Ep to form a reactive heterocumulene (usually an undesirable side reaction). Enolization example ... 

The introduction of the foregoing bases opened the way for the preparation of structurally defined enolates examples are seen in equations (5) to (7). The first examples of the use of these regio-defined enolates in crossed aldol reactions were reported by Stork, Kraus and Garcia in 1974 representative examples are shown in equations (8) and (9). ... 

The best results are obtained when one of the esters is incapable of forming an enolate. Examples of esters of this type include ... 

Resolve tte dei enolization example presented in this chapter for the case when the two waste streams are allowed to mix. 

Figure 3.12 Palladium(ll) enolates examples of C-bound tautomers 44 and 0-bound tautomers 45. Molecular structures of 44 (R =r2 = h, R =4-MeCgl-l4, Ar = 2-MeCgH4) and 45 (R = Me, R = H, Ar = Ph). Copied from Ref [76a].

Figure 5-24. Query drawn for guidir g examples for the reduction of 3 -methylcyclohex-2-enoiie to 3-inethylcyclohex-2-enol.

Here we will illustrate the method using a single example. The aldol reaction between an enol boronate and an aldehyde can lead to four possible stereoisomers (Figure 11.32). Many of these reactions proceed with a high degree of diastereoselectivity (i.e. syn anti) and/or enantioselectivity (syn-l syn-Tl and anti-l anti-lT). Bernardi, Capelli, Gennari,... 

Acetoacetic ester is the classical example of a tautomeric substance, which at room temperature exists as an equilibrium mixture of the kelo and enol forms containing approximately 93 per cent, of the keto form ... 

The preparation of the sodium derivative of the phenol may be avoided by heating the enol and alkyl halide in the presence of potassium carbonate and acetone, for example ... 

Separations based upon differences in the chemical properties of the components. Thus a mixture of toluene and anihne may be separated by extraction with dilute hydrochloric acid the aniline passes into the aqueous layer in the form of the salt, anihne hydrochloride, and may be recovered by neutralisation. Similarly, a mixture of phenol and toluene may be separated by treatment with dilute sodium hydroxide. The above examples are, of comse, simple apphcations of the fact that the various components fah into different solubihty groups (compare Section XI,5). Another example is the separation of a mixture of di-n-butyl ether and chlorobenzene concentrated sulphuric acid dissolves only the w-butyl other and it may be recovered from solution by dilution with water. With some classes of compounds, e.g., unsaturated compounds, concentrated sulphuric acid leads to polymerisation, sulphona-tion, etc., so that the original component cannot be recovered unchanged this solvent, therefore, possesses hmited apphcation. Phenols may be separated from acids (for example, o-cresol from benzoic acid) by a dilute solution of sodium bicarbonate the weakly acidic phenols (and also enols) are not converted into salts by this reagent and may be removed by ether extraction or by other means the acids pass into solution as the sodium salts and may be recovered after acidification. Aldehydes, e.g., benzaldehyde, may be separated from liquid hydrocarbons and other neutral, water-insoluble hquid compounds by shaking with a solution of sodium bisulphite the aldehyde forms a sohd bisulphite compound, which may be filtered off and decomposed with dilute acid or with sodium bicarbonate solution in order to recover the aldehyde. 

Space does not permit any further detailed discussion except for a brief account of two interesting subjects. The first is concerned with keto-enol tautomerism. The classical example is ethyl acetoacetate, which can exist in the keto form (I) and the enol form (II) ... 

The formation of the above anions ("enolate type) depend on equilibria between the carbon compounds, the base, and the solvent. To ensure a substantial concentration of the anionic synthons in solution the pA" of both the conjugated acid of the base and of the solvent must be higher than the pAT -value of the carbon compound. Alkali hydroxides in water (p/T, 16), alkoxides in the corresponding alcohols (pAT, 20), sodium amide in liquid ammonia (pATj 35), dimsyl sodium in dimethyl sulfoxide (pAT, = 35), sodium hydride, lithium amides, or lithium alkyls in ether or hydrocarbon solvents (pAT, > 40) are common combinations used in synthesis. Sometimes the bases (e.g. methoxides, amides, lithium alkyls) react as nucleophiles, in other words they do not abstract a proton, but their anion undergoes addition and substitution reactions with the carbon compound. If such is the case, sterically hindered bases are employed. A few examples are given below (H.O. House, 1972 I. Kuwajima, 1976). 

Reagents with carbonyl type groupings exhibit a or (if n. S-unsaturated) a properties. In the presence of acidic or basic catalysts they may react as enol type electron donors (d or d reagents). This reactivity pattern is considered as normal . It allows, for example, syntheses of 1,3- and 1,5-difunctionaI systems via aldol type (a -H d or Michael type (a + d additions. 

We begin with the discussion of intramolecular reactions. An example of a regioselec-tive Dieckmann condensation (J.P. Schaefer, 1967) used an educt with two ester groups, of which only one could form an enolate. Regioselectivity was dictated by the structure of the educt. 

An example of an intermolecular aldol type condensation, which works only under acidic catalysis is the Knoevenagel condensation of a sterically hindered aldehyde group in a formyl-porphyrin with a malonic ester (J.-H. Fuhrhop, 1976). Self-condensations of the components do not occur, because the ester groups of malonic esters are not electrophilic enough, and because the porphyrin-carboxaldehyde cannot form enolates. 

The selective intermolecular addition of two different ketones or aldehydes can sometimes be achieved without protection of the enol, because different carbonyl compounds behave differently. For example, attempts to condense acetaldehyde with benzophenone fail. Only self-condensation of acetaldehyde is observed, because the carbonyl group of benzophenone is not sufficiently electrophilic. With acetone instead of benzophenone only fi-hydroxyketones are formed in good yield, if the aldehyde is slowly added to the basic ketone solution. Aldols are not produced. This result can be generalized in the following way aldehydes have more reactive carbonyl groups than ketones, but enolates from ketones have a more nucleophilic carbon atom than enolates from aldehydes (G. Wittig, 1968). 

A classical way to achieve regioselectivity in an (a -i- d -reaction is to start with a-carbanions of carboxylic acid derivatives and electrophilic ketones. Most successful are condensations with 1,3-dicarbonyl carbanions, e.g. with malonic acid derivatives, since they can be produced at low pH, where ketones do not enolize. Succinic acid derivatives can also be de-protonated and added to ketones (Stobbe condensation). In the first example given below a Dieckmann condensation on a nitrile follows a Stobbe condensation, and selectivity is dictated by the tricyclic educt neither the nitrile group nor the ketone is enolizable (W.S. Johnson, 1945, 1947). 

A classical reaction leading to 1,4-difunctional compounds is the nucleophilic substitution of the bromine of cf-bromo carbonyl compounds (a -synthons) with enolate type anions (d -synthons). Regio- and stereoselectivities, which can be achieved by an appropiate choice of the enol component, are similar to those described in the previous section. Just one example of a highly functionalized product (W.L. Meyer, 1963) is given. 

Methylsulfinyl enolates are more recently developed d -reagents. They are readily prepared from carboxylic esters and dimsyl anion. Methanesulfenic acid can be eliminated thermally after the condensation has taken place. An example is found in Bartlett s Brefeldin synthesis (P.A. Bartlett. 1978). 

The Michael reaction is of central importance here. This reaction is a vinylogous aldol addition, and most facts, which have been discussed in section 1.10, also apply here the reaction is catalyzed by acids and by bases, and it may be made regioselective by the choice of appropriate enol derivatives. Stereoselectivity is also observed in reactions with cyclic educts. An important difference to the aldol addition is, that the Michael addition is usually less prone to sterical hindrance. This is evidenced by the two examples given below, in which cyclic 1,3-diketones add to o, -unsaturated carbonyl compounds (K. Hiroi, 1975 H, Smith, 1964). 

Only relatively few examples of interesting target molecules containing rings are known. These include caryophyllene (E.J. Corey, 1963 A, 1964) and cubane (J.C. Barborak, 1966). The photochemical [2 + 2]-cycloaddition applied by Corey yielded mainly the /ranr-fused isomer, but isomerization with base leads via enolate to formation of the more stable civ-fused ring system. 

The hydrogenolyaia of cyclopropane rings (C—C bond cleavage) has been described on p, 105. In syntheses of complex molecules reductive cleavage of alcohols, epoxides, and enol ethers of 5-keto esters are the most important examples, and some selectivity rules will be given. Primary alcohols are converted into tosylates much faster than secondary alcohols. The tosylate group is substituted by hydrogen upon treatment with LiAlH (W. Zorbach, 1961). Epoxides are also easily opened by LiAlH. The hydride ion attacks the less hindered carbon atom of the epoxide (H.B. Henhest, 1956). The reduction of sterically hindered enol ethers of 9-keto esters with lithium in ammonia leads to the a,/S-unsaturated ester and subsequently to the saturated ester in reasonable yields (R.M. Coates, 1970). Tributyltin hydride reduces halides to hydrocarbons stereoselectively in a free-radical chain reaction (L.W. Menapace, 1964) and reacts only slowly with C 0 and C—C double bonds (W.T. Brady, 1970 H.G. Kuivila, 1968). 

Difunctional target molecules are generally easily disconnected in a re/ro-Michael type transform. As an example we have chosen a simple symmetrical molecule, namely 4-(4-methoxyphenyl)-2,6-heptanedione. Only p-anisaldehyde and two acetone equivalents are needed as starting materials. The antithesis scheme given helow is self-explanatory. The aldol condensation product must be synthesized first and then be reacted under controlled conditions with a second enolate (e.g. a silyl enolate plus TiCl4 or a lithium enolate), enamine (M. Pfau, 1979), or best with acetoacetic ester anion as acetone equivalents. 

Diene carboxylates can be prepared by the reaction of alkenyl halides with acrylates[34]. For example, pellitorine (30) is prepared by the reaction of I-heptenyl iodide (29) with an acrylate[35]. Enol triflates are reactive pseudo-halides derived from carbonyl compounds, and are utilized extensively for novel transformations. The 3,5-dien-3-ol triflate 31 derived from a 4,5-unsaturated 3-keto steroid is converted into the triene 32 by the reaction of methyl acrylate[36]. 

Allenes also react with aryl and alkenyl halides, or triflates, and the 7r-allyl-palladium intermediates are trapped with carbon nucleophiles. The formation of 283 with malonate is an example[186]. The steroid skeleton 287 has been constructed by two-step reactions of allene with the enol trillate 284, followed by trapping with 2-methyl-l,3-cyclopentanedione (285) to give 286[187]. The inter- and intramolecular reactions of dimethyl 2,3-butenylmalonate (288) with iodobenzene afford the 3-cyclopentenedicarboxylate 289 as a main product) 188]. 

Chlorobenzenes activated by coordination of Cr(CO)3 react with terminal alkynes[253). The 1-bromo-1,2-alkadiene 346 reacts with a terminal alkyne to afford the alka-l,2-dien-4-yne 347[254], Enol tritlates are used for the coupling with terminal alkynes. Formation of 348 in the syntheses of ginkgolide[255] and of vitamin D are examples[256] Aryl and alkenyl fluorides are inert. Only bromide or iodide is attacked when the fluoroiodoalkene 349 or fluoroiodoar-ene is subjected to the Pd-catalyzed coupling with alkynes[257-259]. 

---