Elution solution purification

The IgG purification procedure is repeated in order to ensure exclusive isolation of IgG from patient sera. We have found that with only one purification run, high-abundance proteins other than IgG may be present in the eluted solution. 

In the sugar industry, NF is used for concentration of dextrose symp originating from starch and for demineralization of colored brine from anion exchange resin elution solutions (Bargeman et al., 2005). The purification of alternative (low-calorie) sweeteners such as stevioside might also require a nanofiltration step (Zhang et al., 2000). 

Purification of anthracene. Dissolve 0-3 g. of crude anthracene (usually yellowish in colour) in 160-200 ml. of hexane, and pass the solution through a column of activated alumina (1 5-2 X 8-10 cm.). Develop the chromatogram with 100 ml. of hexane. Examine the column in the hght of an ultra-violet lamp. A narrow, deep blue fluorescent zone (due to carbazole, m.p. 238°) will be seen near the top of the column. Immediately below this there is a yellow, non-fluorescent zone, due to naphthacene (m.p. 337°). The anthracene forms a broad, blue-violet fluorescent zone in the lower part of the column. Continue the development with hexane until fluorescent material commences to pass into the filtrate. Reject the first runnings which contain soluble impurities and yield a paraffin-hke substance upon evaporation. Now elute the column with hexane-benzene (1 1) until the yellow zone reaches the bottom region of the column. Upon concentration of the filtrate, pure anthracene, m.p. 215-216°, which is fluorescent in dayhght, is obtained. The experiment may be repeated several times in order to obtain a moderate quantity of material. 

A solution of 6-bromoindole (O.lOmol) in toluene (200 ml) was treated with Pd(PPh3)4 (5mol%) and stirred for 30 min. A solution of 4-fluorophenyl-boronic acid (0.25 M, 0.15 mol) in abs. EtOH was added, followed immediately by sal aq. NaHCOj (10 eq.). The biphasic mixture was refluxed for several hours and then cooled to room temperature. The reaction mixture was poured into sat. aq. NaCl (200 ml) and the layers separated. The aq. layer was extracted with additional EtOAc (200 ml) and the combined organic layers dried (Na2S04), filtered and concentrated in vacuo. The solution was filtered through silica gel using hexane-CHjCl -hexanc for elution and evaporated. Final purification by recrystallization gave the product (19 g, 90%). 

The residue is leached to give cesium sulfate solution, which can be converted to cesium chloride by ion exchange on Dowex 50 resin and elution with 10% HCl, treatment using ammonia or lime, to precipitate the alurninum, or by solvent extraction, followed by purification at neutral pH using hydrogen peroxide or ammonia. 

A mixture of 50 g of betamethasone, 50 cc of dimethylformamide, 50 cc of methyl orthobenzoate and 1.5 g of p-toluenesulfonicacid Is heated for 24 hours on oil bath at 105°C while a slow stream of nitrogen is passed through the mixture and the methanol produced as a byproduct of the reaction is distilled off. After addition of 2 cc of pyridine to neutralize the acid catalyst the solvent and the excess of methyl orthobenzoate are almost completely eliminated under vacuum at moderate temperature. The residue Is chromatographed on a column of 1,500 g of neutral aluminum oxide. By elution with ether-petroleum ether 30 g of a crystalline mixture are obtained consisting of the epimeric mixture of 170 ,21 -methyl orthobenzoates. This mixture is dissolved without further purification, in 600 cc of methanol and 240 cc of methanol and 240 cc of aqueous 2 N oxalic acid are added to the solution. The reaction mixture is heated at 40°-50°C on water bath, then concentrated under vacuum. The residue, crystallized from acetone-ether, gives betamethasone 17-benzoate, MP 225°-231°C. 

C. Isolation and purification of XK-62-2 100 g of the white powder obtained in the above step B are placed to form a thin, uniform layer on the upper part of a 5 cm0X 150 cm column packed with about 3 kg of silica gel advancely suspended in a solvent of chloroform, isopropanol and 17% aqueous ammonia (2 1 1 by volume). Thereafter, elution is carried out with the same solvent at a flow rate of about 250 ml/hour. The eluate is separated in 100 ml portions. The active fraction is subjected to paper chromatography to examine the components eluted. XK-62-2 is eluted in fraction Nos. 53-75 and gentamicin Cja is eluted in fraction Nos. 85-120. The fraction Nos. 53-75 are combined and concentrated under reduced pressure to sufficiently remove the solvent. The concentrate Is then dissolved in a small amount of water. After freeze-drying the solution, about 38 g of a purified preparate of XK-62-2 (free base) is obtained. The preparate has an activity of 950 units/mg. Likewise, fraction Nos. 85-120 are combined and concentrated under reduced pressure to sufficiently remove the solvent. The concentrate is then dissolved in a small amount of water. After freeze-drying the solution, about 50 g of a purified preparate of gentamicin Cja (free base) is obtained. 

Purification of photoprotein. The dialyzed photoprotein solution was centrifuged to remove precipitates, and then subjected to fractional precipitation by ammonium sulfate, taking a fraction precipitated between 30% and 50% saturation. The protein precipitate was dissolved in 50 ml of 10 mM sodium phosphate, pH 6.0, containing 0.1 mM oxine ( pH 6.0 buffer ), dialyzed against the same buffer, and the dialyzed solution was adsorbed on a column of DEAE-cellulose (2.5 x 13 cm) prepared with the pH 6.0 buffer. The elution was done by a stepwise increase of NaCl concentration. The photoprotein was eluted at 0.2-0.25 M NaCl and a cloudy substance (cofactor 1) was eluted at about 0.5 M NaCl. The photoprotein fraction was further purified on a column of Sephadex G-200 or Ultrogel AcA 34 (1.6 x 80 cm) using the pH 6.0 buffer that contained 0.5 M NaCl. 

Purification of luciferin (Rudie etal., 1976). The luciferin fractions from the DEAE-cellulose chromatography of luciferase were combined and concentrated in a freeze-dryer. The concentrated solution was saturated with ammonium sulfate, and extracted with methyl acetate. The methyl acetate layer was dried with anhydrous sodium sulfate, concentrated to a small volume, then applied on a column of silica gel (2 x 18 cm). The luciferin adsorbed on the column was eluted with methyl acetate. Peak fractions of luciferin were combined, flash evaporated, and the residue was extracted with methanol. The methanol extract was concentrated (1 ml), then chromatographed on a column of SephadexLH-20 (2 x 80 cm) usingmethanol asthe solvent. The luciferin fractions eluted were combined and flash evaporated. The residue was... 

The reddish yellow solution is diluted with 4-5 volumes of cold water containing 5 mM 2-mercaptoethanol to reduce the conductivity to 0.7 m 2 1 or less, and applied to a column of DEAE-cellulose (coarse grade 5 x 15 cm) equilibrated with 2mM potassium phosphate, pH 8.0, containing 5mM 2-mercaptoethanol. The column is first washed with the cold equilibration buffer, then luciferin is eluted with a linear increase of potassium phosphate from 2 mM to 0.3 M, monitoring the effluent by fluorescence and the absorption at 390 nm. The rest of the purification method described below is adapted from the... 

A solution of 4.5 g (19.9 mmol) 4-(fm-butyldimethylsilyloxy)-2-cyclohexenone and 452 mg (1 mmol) of mercury(II) iodide is stirred at r.t. for 15 min and then cooled to — 78 °C. 5.03 g (24.8 mmol) of 1-ethoxy-1-(tm-bulyl(iimethylsilyloxy)ethene are added dropwise during 15 min. The mixture is stirred at — 78 °C for 2 h, quenched with 302 mg (3 mmol) of triethylamine and allowed to warm to r.t. The mixture is filtered through a short (3 cm) column of silica gel (deactivated with a 5% triethylamine solution in hexane/ethyl acetate, 10 1) eluting with hexane/ethyl acetate (10 1) and concentrated in vacuo. Purification of the crude material by flash chromatography (silica gel, hcxanc/cthyl acetate 30 1) gave the adduct as a colorless oil yield 7.98 g (18.7 mmol, 94%) d.r. (cisjtrans) 95.2 4.8. 

Dimethylphenylsilyl lithium (1 mmol, above THF solution) was added to copper(i) iodide (0.5 mmol) at — 23 °C, and the mixture was stirred at this temperature for 4h. The enone (0.75-0.5mmol) was then added, and stirring was continued at —23 °C for 0.5 h. The mixture was then poured on to ice(25 g)/HCl(5 ml), and extracted with chloroform (3 x 25 ml). The combined extracts were filtered, washed with HCI (25ml, 3m), water (25 ml), saturated sodium hydrogen carbonate solution (25 ml) and water (25 ml), and dried. Concentration and purification by preparative t.l.c. (eluting solvent 3 7 ether petrol) gave the /J-silylketone (40-99%). 

The submitters purified the product by the following procedure. The residual pale yellow solid is dissolved in 50 ml of diethyl ether and the remaining solid is filtered off (Note 16). The filtrate is concentrated to a volume of ca. 25 mL, and the solution is allowed to crystallize at 0°C. Once crystallization begins, 50 mL of petroleum ether is added in two portions over 10 hr, and then crystallization is allowed to proceed overnight at 0°C. The white solid is collected by filtration and washed with a mixture of 3 1 petroleum ether-diethyl ether to afford 3.8 g of 4. Chromatographic purification of the mother liquor (5.5 x 18 cm of DSH silica gel 40-63 mm, elution with 1 L of petroleum ether/ethyl acetate 4 1 followed by 1.5 L of 3 1 petroleum ether-ethyl acetate) gives 2.5 g of 4 as a pale yellow solid. All the material is combined and recrystallized from diethyl ether/petrol as above to yield 5.2 g (47%) of 4 in two crops. 

---