Electron epoxides

As shown m Table 6 4 electron releasing alkyl groups on the double bond increase the rate of epoxidation This suggests that the peroxy acid acts as an electrophilic reagent toward the alkene... 

In general, the peilluoioepoxides have boiling points that are quite similar to those of the corresponding fluoroalkenes. They can be distinguished easily from the olefins by it spectroscopy, specifically by the lack of olefinic absorption and the presence of a characteristic band between 1440 and 1550 cm . The nmr spectra of most of the epoxides have been recorded. Litde physical property data concerning these compounds have been pubhshed (Table 1). The stmcture of HFPO by electron diffraction (13) as well as its solubility and heats of solution in some organic solvents have been measured (14,15). 

The majority of 2-methylphenol is used in the production of novolak phenoHc resins. High purity novolaks based on 2-methylphenol are used in photoresist appHcations (37). Novolaks based on 2-methylphenol are also epoxidized with epichlorohydrin, yielding epoxy resins after dehydrohalogenation, which are used as encapsulating resins in the electronics industry. Other uses of 2-methylphenol include its conversion to a dinitro compound, 4,6-dinitro-2-methylphenol [534-52-1] (DNOC), which is used as a herbicide (38). DNOC is also used to a limited extent as a polymerization inhibitor in the production of styrene, but this use is expected to decline because of concerns about the toxicity of the dinitro derivative. 

Polyesters. Polyester is used in embedding resins for electronic components because of its low cost compared to siUcones and epoxides. Polyesters (qv) are condensation products of dicarboxyhc acids and dihydroxy alcohols the reaction provides a wide range of viscosities for polyesters. 

Electron deficient carbon-carbon double bonds are resistant to attack by the electrophilic reagents of Section 5.05.4.2.2(t), and are usually converted to oxiranes by nucleophilic oxidants. The most widely used of these is the hydroperoxide ion (Scheme 79). Since epoxidation by hydroperoxide ion proceeds through an intermediate ct-carbonyl anion, the reaction of acyclic alkenes is not necessarily stereospecific (Scheme 80) (unlike the case of epoxidation with electrophilic agents (Section 5.05.4.2.2(f)) the stereochemical aspects of this and other epoxidations are reviewed at length in (B-73MI50500)). 

About half of epoxide resin production is used for surface coating applications, with the rest divided approximately equally between electronic applications (particularly for printed circuit boards and encapsulation), the building sector and miscellaneous uses. In tonnage terms consumption of epoxide-fibre laminates is only about one-tenth that of polyester laminates, but in terms of value it is much greater. 

Davidson, S.R. and Wilkinson, S.A., electron-beam-induced polymerization of epoxides. J. Photochem. Photobiol. A Chem.,SS, 123-134 (1991). 

Some instances of incomplete debromination of 5,6-dibromo compounds may be due to the presence of 5j5,6a-isomer of wrong stereochemistry for anti-coplanar elimination. The higher temperature afforded by replacing acetone with refluxing cyclohexanone has proved advantageous in some cases. There is evidence that both the zinc and lithium aluminum hydride reductions of vicinal dihalides also proceed faster with diaxial isomers (ref. 266, cf. ref. 215, p. 136, ref. 265). The chromous reduction of vicinal dihalides appears to involve free radical intermediates produced by one electron transfer, and is not stereospecific but favors tra 5-elimination in the case of vic-di-bromides. Chromous ion complexed with ethylene diamine is more reactive than the uncomplexed ion in reduction of -substituted halides and epoxides to olefins. ... 

In the case of the 3a-acetoxy-5a,6a-epoxide (33), the electronic and conformational factors are opposed to each other. Thus, the energy of the system is lowered when the axial 3a-acetoxy group is permitted to become... 

The NMR study of steroidal epoxides (discussed in section II-F) parallels that of the analogous thiiranes. It is possible to relate the location and configuration of the thiirane group with the angular methyl and thiirane proton resonances. The proton NMR relationships for the intermediate thiocyanatohydrins have been included inageneral NMR study of steroids. Electronic spectra may be used in the analysis of steroidal thiiranes. Spectroscopic measurements have shown the existence of a low intensity absorption in the 240-260 m region. The regular patterns of rotatory contributions of thiiranes which are comparable with those of ketones prompted an accumulation of ORD and CD data for steroidal thiiranes. 

A more efficient agent than peroxy compounds for the epoxidation of fluoro-olefins with nonfluonnated double bond is the hypofluorous acid-acetomtrile complex [22] Perfluoroalkylethenes react with this agent at room temperature within 2-3 h with moderate yields (equation 13), whereas olefins with strongly electron-deficient double bond or electron-poor, sterically hindered olefins, for example l,2-bis(perfluorobutyl)ethene and perfluoro-(l-alkylethyl)ethenes, are practically inert [22] Epoxidation of a mixture of 3 perfluoroalkyl-1-propenes at 0 C IS finished after 10 mm in 80% yield [22] The trifluorovinyl group in partially fluorinated dienes is not affected by this agent [22] (equation 13)... 

The product of nucleophilic attack can be anticipated by examining the lowest-unoccupied molecular orbital (LUMO) on protonated cyclopentene oxide. From which direction (top or bottom) would a nucleophile be more likely to approach each epoxide carbon in order to transfer electrons into this orbital Explain. Does one carbon contribute more to the LUMO, or is the orbital evenly spread out over both epoxide carbons Assuming that LUMO shape dictates product stereochemistry, predict which stereoisomers will be obtained, and their approximate relative amounts. Is the anticipated kinetic product also the thermodynamic product (Compare energies of 1,2-cyclopentanediol stereoisomers to tell.)... 

The Jacobsen-Katsuki epoxidation reaction is an efficient and highly selective method for the preparation of a wide variety of structurally and electronically diverse chiral epoxides from olefins. The reaction involves the use of a catalytic amount of a chiral Mn(III)salen complex 1 (salen refers to ligands composed of the N,N -ethylenebis(salicylideneaminato) core), a stoichiometric amount of a terminal oxidant, and the substrate olefin 2 in the appropriate solvent (Scheme 1.4.1). The reaction protocol is straightforward and does not require any special handling techniques. 

The asymmetric epoxidation of electron-poor cinnamate ester derivatives was highlighted by Jacobsen in the synthesis of the Taxol side-chain. Asymmetric epoxidation of ethyl cinnamate provided the desired epoxide in 96% ee and in 56% yield. Epoxide ring opening with ammonia followed by saponification and protection provided the Taxol side-chain 46 (Scheme 1.4.12). 

As with i -substituted allyl alcohols, 2,i -substituted allyl alcohols are epoxidized in excellent enantioselectivity. Examples of AE reactions of this class of substrate are shown below. Epoxide 23 was utilized to prepare chiral allene oxides, which were ring opened with TBAF to provide chiral a-fluoroketones. Epoxide 24 was used to prepare 5,8-disubstituted indolizidines and epoxide 25 was utilized in the formal synthesis of macrosphelide A. Epoxide 26 represents an AE reaction on the very electron deficient 2-cyanoallylic alcohols and epoxide 27 was an intermediate in the total synthesis of (+)-varantmycin. 

Reductive ring opening of epoxides in radical reactions in presence of titanocenes as electron transfer catalysts 98SL801. 

Semiconducting devices, switches and miniaturised v.h.f. circuits are all particularly sensitive to the slightest reaction on critical surfaces, and in devices calling for the highest levels of reliability even the most inert of the phenolic, epoxide and silicone resins are not considered to be fully acceptablecorrosion of electronic assemblies may often be enhanced by migration of ions to sensitive areas under applied potentials, and by local heating effects associated with current flows. 

We saw in Section 7.8 that bromohydrins are converted into epoxides when treated with base. Propose a mechanism, using curved arrows to show the electron flow. 

The second part of lanosterol biosynthesis is catalyzed by oxidosqualene lanosterol cyclase and occurs as shown in Figure 27.14. Squalene is folded by the enzyme into a conformation that aligns the various double bonds for undergoing a cascade of successive intramolecular electrophilic additions, followed by a series of hydride and methyl migrations. Except for the initial epoxide protonation/cyclization, the process is probably stepwise and appears to involve discrete carbocation intermediates that are stabilized by electrostatic interactions with electron-rich aromatic amino acids in the enzyme. 

Sesquiterpenoid. 203, 1071 Sex hormone, 1082-1083 Sharpless, K. Barry. 734 Sharpless epoxidation, 735 Shell (electron), 5 capacity of, 5 Shielding (NMR). 442 Si prochirality, 315-316 Sialic acid. 997 Side chain (amino acid), 1020 Sigma (cr) bond, 11 symmetry of, 11 Sigmatropic rearrangement, 1191-1195... 

---