Alkene acyclic

Stereochemical features in the oxidative addition and the elimination of /3-hydrogen of cyclic and acyclic alkenes are different. The insertion (palladation) is syn addition. The syn addition (carbopalladation) of R—Pd—X to an acyclic alkene is followed by the syn elimination of 3-hydrogen to give the trans-a ksne 6, because free rotation of 5 is possible with the acyclic alkene. On the other hand, no rotation of the intermediate 7 is possible with a cyclic alkene and the syn elimination of /3-hydrogen gives the allylic compound 8 rather than a substituted alkene. 

Electron deficient carbon-carbon double bonds are resistant to attack by the electrophilic reagents of Section 5.05.4.2.2(t), and are usually converted to oxiranes by nucleophilic oxidants. The most widely used of these is the hydroperoxide ion (Scheme 79). Since epoxidation by hydroperoxide ion proceeds through an intermediate ct-carbonyl anion, the reaction of acyclic alkenes is not necessarily stereospecific (Scheme 80) (unlike the case of epoxidation with electrophilic agents (Section 5.05.4.2.2(f)) the stereochemical aspects of this and other epoxidations are reviewed at length in (B-73MI50500)). 

Instead ef the name metathesis, the term disproportionation is frequently applied to the reaction, and sometimes the term dismutation. For historical reasons the name disproportionation is most commonly used for the heterogeneously catalyzed reaction, while the homogeneously catalyzed reaction is usually designated as metathesis. The name disproportionation is correct in the case of the conversion of acyclic alkenes according to Eq. (1) however, this name is inadequate in most other situations, such as the reaction between two different alkenes, and reactions involving cycloalkenes. Similar objections apply to the name dismutation. The name metathesis is not subject to these limitations and, therefore, is preferred. 

Both terminal and internal acyclic alkenes can be metathesized, corresponding to Eq. (4), where R is an alkyl group or a hydrogen atom. 

The metathesis of acyclic alkenes substituted with other hydrocarbon groups, such as cycloalkyl, cycloalkenyl, or aryl groups, has also been observed. For instance, styrene is converted into ethene and 1,2-diphenyl-ethene (stilbene) (9, 9a). 

It has been suggested that these polymers are mainly linear, which may be a consequence of intermolecular metathesis reactions with traces of acyclic alkenes, or of other consecutive reactions 19-22). 

Mutual metathesis of a cyclic and an acyclic alkene provides still more possibilities in synthesizing organic compounds. For instance, cycloalkenes are cleaved by ethene into a,co-dienes. The reaction of 1,5-cyclooctadiene with ethene gives 1,5,9-decatriene (18) norbornene reacts with 2-butene to yield 1,3-dipropenylcyclopentane (30) ... 

It can be concluded that the metathesis reaction of acyclic alkenes and cycloalkenes proceeds via the rupture and formation of carbon-carbon double bonds, i.e. that the metathesis of alkenes is a true transalkylidenation reaction. 

Of course, even in the case of acyclic alkenes reaction enthalpy is not exactly zero, and therefore the product distribution is never completely statistically determined. Table V gives equilibrium data for the metathesis of some lower alkenes, where deviations of the reaction enthalpy from zero are relatively large. In this table the ratio of the contributions of the reaction enthalpy and the reaction entropy to the free enthalpy of the reaction, expressed as AHr/TASr, is given together with the equilibrium distribution. It can be seen that for the metathesis of the lower linear alkenes the equilibrium distribution is determined predominantly by the reaction entropy, whereas in the case of the lower branched alkenes the reaction enthalpy dominates. If the reaction enthalpy deviates substantially from zero, the influence of the temperature on the equilibrium distribution will be considerable, since the high temperature limit will always be a 2 1 1 distribution. Typical examples of the influence of the temperature are given in Tables VI and VII. 

H risson and Chauvin (88) examined the metathesis between acyclic alkenes and cycloalkenes (telomerization) in the presence of two other tungsten-based catalysts, namely WOCl4-Sn(n-C4He)4 and WOCI4-... 

Fig. 5. Mechanism of H risson and Chauvin for the mutual metathesis of a cyclic and an acyclic alkene.

The preferred kinetic model for the metathesis of acyclic alkenes is a Langmuir type model, with a rate-determining reaction between two adsorbed (complexed) molecules. For the metathesis of cycloalkenes, the kinetic model of Calderon as depicted in Fig. 4 agrees well with the experimental results. A scheme involving carbene complexes (Fig. 5) is less likely, which is consistent with the conclusion drawn from mechanistic considerations (Section III). However, Calderon s model might also fit the experimental data in the case of acyclic alkenes. If, for instance, the concentration of the dialkene complex is independent of the concentration of free alkene, the reaction will be first order with respect to the alkene. This has in fact been observed (Section IV.C.2) but, within certain limits, a first-order relationship can also be obtained from many hyperbolic models. Moreover, it seems unreasonable to assume that one single kinetic model could represent the experimental results of all systems under consideration. Clearly, further experimental work is needed to arrive at more definite conclusions. Especially, it is necessary to investigate whether conclusions derived for a particular system are valid for all catalyst systems. 

Acyclic alkadienes, metathesis of, 134 Acyclic alkenes, metathesis reaction of, 133, 134... 

Alkenes. When the substrate molecule contains a double bond, treatment with chlorine or bromine usually leads to addition rather than substitution. However, for other radicals (and even for chlorine or bromine atoms when they do abstract a hydrogen) the position of attack is perfectly clear. Vinylic hydrogens are practically never abstracted, and allylic hydrogens are greatly preferred to other positions of the moleeule. Allylic hydrogen abstraction from a cyclic alkenes is usually faster than abstraction from an acyclic alkene. ... 

The examples we have seen so far have been acyclic alkenes (not containing a ring). When we add across cyclic alkenes, the products are easier to draw because we don t have to rotate and redraw the alkene before starting. Let s see an... 

A more practical, atom-economic and environmentally benign aziridination protocol is the use of chloramine-T or bromamine-T as nitrene source, which leads to NaCl or NaBr as the sole reaction by-product. In 2001, Gross reported an iron corrole catalyzed aziridination of styrenes with chloramine-T [83]. With iron corrole as catalyst, the aziridination can be performed rmder air atmosphere conditions, affording aziridines in moderate product yields (48-60%). In 2004, Zhang described an aziridination with bromamine-T as nitrene source and [Fe(TTP)Cl] as catalyst [84]. This catalytic system is effective for a variety of alkenes, including aromatic, aliphatic, cyclic, and acyclic alkenes, as well as cx,p-unsaturated esters (Scheme 28). Moderate to low stereoselectivities for 1,2-disubstituted alkenes were observed indicating the involvement of radical intermediate. 

Some hydrometalation reactions have been shown to be catalyzed by zirconocene. For instance, CpiZrCf-catalyzed hydroaluminations of alkenes [238] and alkynes [239] with BU3AI have been observed (Scheme 8-34). With alkyl-substituted internal alkynes the process is complicated by double bond migration, and with terminal alkynes double hydrometalation is observed. The reaction with "PrjAl and Cp2ZrCl2 gives simultaneously hydrometalation and C-H activation. Cp2ZrCl2/ BuIi-cat-alyzed hydrosilation of acyclic alkenes [64, 240] was also reported to involve hydrogen transfer via hydrozirconation. 

Reactions with Acylium Ions. Alkenes react with acyl halides or acid anhydrides in the presence of a Lewis acid catalyst to give (3,y-unsaturated ketones. The reactions generally work better with cyclic than acyclic alkenes. 

It is found in practice with (5), and with other simple acyclic alkenes, that the addition is almost completely stereoselective, i.e. 100% ANTI addition. This result also is incompatible with a one-step pathway, as the atoms in a bromine molecule are too close to each other to be able to add, simultaneously, ANTI. 

The orientation of addition of an unsymmetrical adduct, HY or XY, to an unsymmetrically substituted alkene will be defined by the preferential formation of the more stabilised carbanion, as seen above (cf. preferential formation of the more stabilised carbocation in electrophilic addition, p. 184). There is little evidence available about stereoselectivity in such nucleophilic additions to acyclic alkenes. Nucleophilic addition also occurs with suitable alkynes, generally more readily than with the corresponding alkenes. 

C/H-insertions have been reported to occur in copper-catalyzed reactions between diazomalonates and cyclohexene as well as some alkylated derivatives 9,57. Some acyclic alkenes behave similarly9, but not so 1,1-dicyclopropylethylene150), An abstraction/recombination mechanism via intermediates of type 103 has been proposed53 which would account not only for the three insertion products 104-106... 

Reactions with alkenes and nonconjugated dienes have been described in many publications (101, 103, 106-111). Various alkenes, such as cycloalkenes as well as acyclic alkenes, up to tetrasubstituted derivatives, can react with nitroalkenes (42) (110). Only one double bond is involved in the reactions of heterodienes (42) with nonconjugated dienes (111), whereas the second double bond can be used in subsequent transformations of target nitronates (35). The reactions of heterodienes (42) with inactivated alkenes require the presence of LA as catalyst. 

Asymmetric Hydrosilylation of Alkyl-Substituted Acyclic Alkenes 828... 

The first published report on the use of this catalyst for the cross-metathesis of functionalised acyclic alkenes was by Blechert and co-workers towards the end of 1996 [37]. This report was also noteworthy for its use of polymer-bound alkenes in the cross-metathesis reaction. Tritylpolystyrene-bound AT-Boc N-al-lylglycinol 18 was successfully cross-metathesised with both unfunctionalised alkenes and unsaturated esters (Eq. 17) (Table 1). 

The ring-opening cross-metathesis reaction is similar to the acyclic cross-metathesis reaction discussed above, except that one of the acyclic alkenes is replaced with a strained cyclic alkene (Scheme 5). 

In this case, the use of ethene as the acyclic alkene means that the diene 38 and polymeric compounds are the only possible products that can be formed from metathesis. 

Optimal yields were obtained by slow addition of the alkene substrates to a solution of the ruthenium vinylalkylidene and this allowed just two equivalents of the acyclic alkene to be used without significant formation of polymeric products. Unlike the acyclic cross-metathesis reactions, which generally favour the formation of tram products, the above ring-opening metathesis reactions yielded products in which the cis stereoisomer is predominant. Particularly noteworthy was the absence of significant amounts of products of type 31, formed from metathesis of one cyclic and two acyclic alkenes. In fact, considering the number of possible ring-opened products that could have been formed, these reactions showed remarkable selectivity (GC yields > 80%). 

When analogous reactions were performed using symmetrical internal acyclic alkenes only polymerisation of the cyclobutene substrate was observed. 

The sterically bulky ruthenium alkylidene 42, formed via ring-opening of the cyclobutene, should react more rapidly with the terminal alkene than with a second molecule of the cyclobutene. This preference for reacting with the acyclic alkene is probably due to a combination of the greater steric hindrance of the cyclic alkene and the ability of the reaction with the terminal alkene to proceed... 

---