Method dispersion

Two air-saturation systems suited for use in water treatment are shown in Figure 15 (31). Such mechanisms faciHtate the release of air that generates much finer bubbles than mechanical air dispersion methods used in mineral flotation practice. 

The Pasquill-Gifford-Holland dispersion method was used for the above example. Note that vinyl chloride monomer (VCM) constitutes the primary active ingredient in the reactor. It was therefore assumed that ... 

Popular methods for mutual diffusion measurements in fluid systems are the Taylor dispersion method and interferometric methods, such as Digital Image Holography [13, 14]. 

The PIA-investigations were carried out under dynamic vacuum (p< 10 5 mbar) and at 77 K with films cast from toluene solution onto KBr substrates. For the dispersive method [29, 30] the globar, the KBr-prism premonochromator, and the grating monochromator of a Perkin Elmer 125 lR-spcctrometer were used in the spectral range of 0.25 to 1.24 eV. The pump beam was chopped mechanically... 

Perhaps the simplest solvent dispersion method is that developed by Batzri and Korn (1973). Phospholipids and other lipids to be a part of the liposomal membrane are first dissolved in ethanol. This ethanolic solution then is rapidly injected into an aqueous solution of 0.16M KC1 using a syringe, resulting in a maximum concentration of no more than 7.5 percent ethanol. Using this method, single bilayer liposomes of about 25 nm diameter can be created that are... 

Pratihar SK, Baus RN, Mazumder S, and Maiti HS. Electrical conductivity and microstructure of Ni-YSZ anode prepared by liquid dispersion method. In Singhal SC, Dokiya M, editors. Proceedings of the Sixth International Symposium on Solid Oxide Fuel cells (SOFC-VI), Pennington, NJ The Electrochemical Society, 1999 99(19) 513-521. 

Fig. 7.17. Basic components of the apparatus used for the measurement of X-ray fluorescence by the wavelength and energy dispersive methods.WDX X-rays from the source (A) are allowed to impinge on the sample (B) the resulting XRF is discriminated by the crystal (C), and finally measured by the detector (D). EDX X-rays from the source (A) are allowed to impinge on the sample (B), and the resulting XRF is measured by the detector (D).

Ling Y-C, Huang I-P. 1995. Multiresidue matrix solid phase dispersion method for determining 16 organochlorine pesticides and polychlrinated biphenyls in fish. Chromatographia 40(5-6) 259-266. 

To achieve the goal of required performance, durability, and cost of plate materials, one approach is improvement of the control of the composition and microstructure of materials, particularly the composite, in the material designing and manufacturing process. For example, in the direction of development of thermoplastics-based composite plate, CEA (Le Ripault Center) and Atofina (Total Group) have jointly worked on an irmovative "microcomposite" material [33]. The small powders of the graphite platelet filler and the PVDF matrix were mixed homogeneously by the dispersion method. The filler and matrix had a certain ratio at the microlevel in the powder according to the optimized properties requirements. The microcomposite powders were thermocompressed into the composite plate. 

Garcia M, Rodriguez I, Cela R (2007) Optimisation of a matrix solid-phase dispersion method for the determination of organophosphate compounds in dust samples. Anal Chim Acta 590 17-25... 

---