Dimethyl sulfoxide ketones

Polarity Polarity is the ability to form two opposite centers in the molecule. The concept is used in solvents to describe their dissolving capabilities or the interactive forces between solvent and solute. Because it depends on dipole moment, hydrogen bonding, entropy, and enthalpy, it is a composite property without a physical definition. The dipole moment has the greatest influence on polar properties of solvents. Highly symmetrical molecules (e.g. benzene) and aliphatic hydrocarbons (e.g. hexane) have no dipole moment and are considered non-polar. Dimethyl sulfoxide, ketones, esters, alcohol are examples of compounds having dipole moments (from high to medium, sequentially) and they are polar, medium polar, and dipolar liquids. 

Phosphorus pent oxide] dimethyl sulfoxide Ketones from sec. alcohols Carbohydrate derivs. 

The widely used Moifatt-Pfltzner oxidation works with in situ formed adducts of dimethyl sulfoxide with dehydrating agents, e.g. DCC, AcjO, SO], P4O10, CCXTl] (K.E, Pfitzner, 1965 A.H. Fenselau, 1966 K.T. Joseph, 1967 J.G. Moffatt, 1971 D. Martin, 1971) or oxalyl dichloride (Swem oxidation M. Nakatsuka, 1990). A classical procedure is the Oppenauer oxidation with ketones and aluminum alkoxide catalysts (C. Djerassi, 1951 H. Lehmann, 1975). All of these reagents also oxidize secondary alcohols to ketones but do not attack C = C double bonds or activated C —H bonds. 

Trifluoromethanesulfonic acid is miscible in all proportions with water and is soluble in many polar organic solvents such as dimethylformamide, dimethyl sulfoxide, and acetonitrile. In addition, it is soluble in alcohols, ketones, ethers, and esters, but these generally are not suitably inert solvents. The acid reacts with ethyl ether to give a colorless, Hquid oxonium complex, which on further heating gives the ethyl ester and ethylene. Reaction with ethanol gives the ester, but in addition dehydration and ether formation occurs. 

Chemiluminescence is also obtained by anionic autooxidation of (41) with oxygen ia alkaline dimethyl sulfoxide (DMSO) (216). Qc has been reported to be 10% and ketone (43) and CO2 are obtained. Several analogues of luciferin have been prepared that are also chemiluminescent when they react with oxygen ia alkaline DMSO (62). 

Vinyl Pyrroles. Relatively new synthetic routes based on a one-pot reaction between ketoximes and acetjiene ia an alkaU metal hydroxide—dimethyl sulfoxide (DMSO) system have made vinyl pyrroles accessible. It requires no pyrrole precursors and uses cheap and readily available ketones (42). 

Zirconium tetrachloride is instantly hydrolyzed in water to zirconium oxide dichloride octahydrate [13520-92-8]. Zirconium tetrachloride exchanges chlorine for 0x0 bonds in the reaction with hydroxylic ligands, forming alkoxides from alcohols (see Alkoxides, METAl). Zirconium tetrachloride combines with many Lewis bases such as dimethyl sulfoxide, phosphoms oxychloride and amines including ammonia, ethers, and ketones. The zirconium organometalLic compounds ate all derived from zirconium tetrachloride. 

The procedure described is an example of a more general synthetic method for the direct conversion of ketones into cyanides. " The reaction has been carried out successfully with acyclic and cyclic aliphatic ketones, including numerous steroidal ketones and aryl-alkyl ketones. The conversion of diaryl or highly hindered ketones such as camphor and )3,j8-dimethyl-a-tetralone requires the use of a more polar solvent. The dimethoxyethane used in the present procedure should be replaced by dimethyl sulfoxide. ... 

The use of dimethyl sulfoxide-acetic anhydride as a reagent for the oxidation of unhindered steroidal alcohols does not appear to be as promising due to extensive formation of by-products. However, the reagent is sufficiently reactive to oxidize the hindered 11 j -hydroxyl group to the 11-ketone in moderate yield. The use of sulfur trioxide-pyridine complex in dimethyl sulfoxide has also been reported. The results parallel those using DCC-DMSO but reaction times are much shorter and the work-up is more facile since the separation of dicyclohexylurea is not necessary. Allylic alcohols can be oxidized by this procedure without significant side reactions. 

Deuteration with metal deuteride complexes reduction of steroidal ketones with lithium aluminum deuteride, 164 Dimethyl sulfoxide dicyclohexylcarbo-... 

Vicinal glycols may be oxidized to the corresponding 17a-hydroxy-20-ketones in reasonable yields by means of chromium trioxide in dimethylfor-mamide in the presence of manganese dichloride, or by treatment with dimethyl sulfoxide-acetic anhydride. ... 

This ester is converted in high yield to the y -ketosulfoxide by means of the dimethyl sulfoxide anion. Heating in acetic acid then produces a hemi-mercaptal acetate, which on treatment with Raney nickel gives the desired 21-acetoxy-20-ketone in a 50-70% overall yield from the -ketosulfoxide. A 17a-hydroxyl may also be present during the sequence. 

Both terminal and nonterminal acetylenes have been used. Activating groups oL to the acetylenic bond have included sulfone (131-135), sulfoxide (134), ester (28,133-139), and ketone (134,140). Whether adduct 183 Is designated as cis or trans depends on the investigators and the particular compound. If the addition reaction is carried out in aprotic solvents, the major isomer is 183 formed by cis addition (135,138,139). For example, the addition of aziridine to dimethyl acetylenedicarboxylate (182, X, Y = CO2CH3) in dimethyl sulfoxide (135) gave 75 % of a mixture containing 95 % of the Chester 185. Collapse of the intermediate zwitterion intermediate 186... 

The S >ern oxidation is a preparatively important reaction which allows for the oxidation of primary and secondary alcohols 1 to aldehydes and ketones 2, respectively, under mild conditions, using activated dimethyl sulfoxide (DMSO) as the oxidizing agent. 

The classical procedure for the Wolff-Kishner reduction—i.e. the decomposition of the hydrazone in an autoclave at 200 °C—has been replaced almost completely by the modified procedure after Huang-Minlon The isolation of the intermediate is not necessary with this variant instead the aldehyde or ketone is heated with excess hydrazine hydrate in diethyleneglycol as solvent and in the presence of alkali hydroxide for several hours under reflux. A further improvement of the reaction conditions is the use of potassium tcrt-butoxide as base and dimethyl sulfoxide (DMSO) as solvent the reaction can then proceed already at room temperature. ... 

On treatment with a strong base such as sodium hydride or sodium amide, dimethyl sulfoxide yields a proton to form the methylsulfinyl carbanion (dimsyl ion), a strongly basic reagent. Reaction of dimsyl ion with triphenylalkylphosphonium halides provides a convenient route to ylides (see Chapter 11, Section III), and with triphenylmethane the reagent affords a high concentration of triphenylmethyl carbanion. Of immediate interest, however, is the nucleophilic reaction of dimsyl ion with aldehydes, ketones, and particularly esters (//). The reaction of dimsyl ion with nonenolizable ketones and... 

Notable examples of general synthetic procedures in Volume 47 include the synthesis of aromatic aldehydes (from dichloro-methyl methyl ether), aliphatic aldehydes (from alkyl halides and trimethylamine oxide and by oxidation of alcohols using dimethyl sulfoxide, dicyclohexylcarbodiimide, and pyridinum trifluoro-acetate the latter method is particularly useful since the conditions are so mild), carbethoxycycloalkanones (from sodium hydride, diethyl carbonate, and the cycloalkanone), m-dialkylbenzenes (from the />-isomer by isomerization with hydrogen fluoride and boron trifluoride), and the deamination of amines (by conversion to the nitrosoamide and thermolysis to the ester). Other general methods are represented by the synthesis of 1 J-difluoroolefins (from sodium chlorodifluoroacetate, triphenyl phosphine, and an aldehyde or ketone), the nitration of aromatic rings (with ni-tronium tetrafluoroborate), the reductive methylation of aromatic nitro compounds (with formaldehyde and hydrogen), the synthesis of dialkyl ketones (from carboxylic acids and iron powder), and the preparation of 1-substituted cyclopropanols (from the condensation of a 1,3-dichloro-2-propanol derivative and ethyl-... 

Ordinary ketones are generally much more difficult to cleave than trihalo ketones or p-diketones, because the carbanion intermediates in these cases are more stable than simple carbanions. However, nonenolizable ketones can be cleaved by treatment with a 10 3 mixture of t-BuOK—H2O in an aprotic solvent such as ether, dimethyl sulfoxide, 1,2-dimethoxyethane (glyme), and so on, or with sohd t-BuOK in the absence of a solvent. When the reaction is applied to monosubstituted diaryl ketones, that aryl group preferentially cleaves that comes off as the more stable carbanion, except that aryl groups substituted in the ortho position are more readily cleaved than otherwise because of the steric effect (relief of stain). In certain cases, cyclic ketones can be cleaved by base treatment, even if they are enolizable. " OS VI, 625. See also OS VH, 297. 

Alkyltriphenylphosphonium halides are only weakly acidic, and a strong base must be used for deprotonation. Possibilities include organolithium reagents, the anion of dimethyl sulfoxide, and amide ion or substituted amide anions, such as LDA or NaHMDS. The ylides are not normally isolated, so the reaction is carried out either with the carbonyl compound present or with it added immediately after ylide formation. Ylides with nonpolar substituents, e.g., R = H, alkyl, aryl, are quite reactive toward both ketones and aldehydes. Ylides having an a-EWG substituent, such as alkoxycarbonyl or acyl, are less reactive and are called stabilized ylides. 

Oxidations for oxidation of alcohols to ketones employs dimethyl sulfoxide (DMSO) and any... 

The red and orange forms of RhCl[P(C6H5)3]3 have apparently identical chemical properties the difference is presumably due to different crystalline forms, and possibly bonding in the solid. The complex is soluble in chloroform and methylene chloride (dichloromethane) to about 20 g./l. at 25°. The solubility in benzene or toluene is about 2 g./l. at 25° but is very much lower in acetic acid, acetone, and other ketones, methanol, and lower aliphatic alcohols. In paraffins and cyclohexane, the complex is virtually insoluble. Donor solvents such as pyridine, dimethyl sulfoxide, or acetonitrile dissolve the complex with reaction, initially to give complexes of the type RhCl[P(C6H6)3]2L, but further reaction with displacement of phosphine may occur. 

The Bohlmann-Rahtz synthesis of trisubstituted pyridines from /3-aminocrotonates and an ethynyl ketone has found application in the preparation of a variety of heterocycles based on the substituted pyridine motif. Bagley and coworkers have developed a microwave-assisted modification of this one-pot heteroannulation method that is best conducted in dimethyl sulfoxide at 170 °C for 20 min, providing the desired pyridines in 24—94% yield (Scheme 6.227) [406, 407]. Typically, 2 equivalents of the /3-aminocrotonates were employed. 

The procedure goes over 6 days of which on days 1-3 the verum or just the vehicle (typical vehicles are acetone/olive oil mixtures, N,N-dimethylformamide, methyl ethyl ketone, propylene glycol, or dimethyl sulfoxide) are applied onto the ears of the animals, whereas the fourth and the fifth day are without treatment. On the sixth day, a suspension of lymph node cells is prepared for each mouse. 

Pentadienone (divinyl ketone) was epoxidized55 by means of hydrogen peroxide in alkaline solution, to give a mixture of DL- and me.so-l,2 4,5-dianhydro-3-pentanones in the ratio of 13 7. Reduction of the ketone group in the DL-diepoxide with sodium horohvdride, followed by alkaline hydrolysis in dimethyl sulfoxide, was fully stereo-specific, and afforded DL-arabinitol. The same reaction-sequence performed on the meso-diepoxide led to a mixture of ribitol and xylitol. 

---