Dimethyl ammonium halides

Tertiary amines do not react with nitrous acid, acetyl chloride, benzoyl chloride, benzenesulfonyl chloride, but react with alkyl halides to form quaternary ammonium halides, which are converted by silver hydroxide to quaternary ammonium hydroxides. Quaternary ammonium hydroxides upon heating yield (1) tertiary amine pins alcohol (or, for higher members, olefin plus water). Tertiary amines may also be formed (2) by alkylation of secondary amines, e.g., by dimethyl sulfate, (3) from amino acids by living organisms, e g, decomposition of fish in the case of trimethylamine. 

The dimethyl amine derivative produced was quaternized directly by methyl iodide, added slowly to a chilled solution of the ternary amine in ethyl acetate. When other ring substituents are present, the reductive eunination leads to isomeric configurations, as noted in Table I. Quaternary ammonium halide salts were characterized by melting point, TLC, or microanalytical data and and NMR. 

CMCs of these polyfluorinated surfactants are of the order of 10 5 m.47 Plots of the observed H chemical shifts versus surfactant concentration of cetyl trimethyl ammonium chloride, cetyl pyridinium chloride, cetyl dimethyl phenyl ammonium chloride, cetyl dimethyl benzyl ammonium chloride, cetyl dimethy 1-2-phenyl ethyl ammonium chloride, and cetyl dimethyl-3-phenyl propyl ammonium chloride, are sigmoidal and were fitted to a model based on the mass action. The H chemical shift-based CMC values are in excellent agreement with those determined by the surface tension method.48 The micellization processes of dodecyl trimethyl ammonium halides (chloride and bromide) studied by calorimetric titration show different behaviors at 298 K. However, these disappear at 313 K, while the results measured by the chemical shift versus surfactant concentration do not show this difference.49 The CMC of 3-aminopropyl triethoxy silane in toluene is ca. 0.47m, measured by H and l3C chemical shifts.50 The CMC of optically active potassium A -n-dodecanoyl alaminate measured by H and l3C chemical shifts is lower (11-15 him) in D20 than that in a mixed solvent of 1,4-dioxane and D20 (19mM).-51 The H chemical shift shows that the CMC of resorcinol-type calix[4] phosphoric esters having four alkyl side-chains, [4]Ar 5P-R-n, is insensitive to the length of the side-chains, n.52 The CMC values of a family of surfactants, the sodium cyclohexyl alkanoates, with different lengths of the alkanoate side-chains, were obtained from 13C chemical-shift measurements. The results show that these amphiphiles have high CMCs (0.12-1.02 m).-53... 

The produced quinone makes black complexes within the original hydroquinone very easily. As shown in Figure 4.48, when the crystals of hydroquinone and quinone are placed separately, the dark-violet crystals of the complex, which are called quinhydron, appear between the two crystalline samples. We tried to stabilize hydroquinone by making complexes with various surfactant molecules containing quaternary ammonium salts, such as alkyltrimethylammonium halides, benzyl(alkyl)dimethyl-ammonium chloride, and ethyl(hexadecyl)dimethylammonium bromide (ECDAB). After many trials, complex crystals suitable for X-ray analysis were formed with benzyl(hexadecyl)dimethylammonium chloride (BCDAC) and ECDAB, as shown in Figure 4.49. 

F1EA-16-X A -Dimethyl-A-acetyl-A-(2-hydroxyethyl)ammonium halides... 

Tetrasubstituted phosphonium halides are just as effective as their ammonium counterparts. A combination of tetraphenylphosphonium bromide and either 18-crown-6 or polyethylene glycol dimethyl ether with spray-dried potassium fluoride converts 4-chlorobenzaldehyde to 4-fluorobenzaldehyde in 74% yield [67] In addition, the halogen of a primary alkyl chloride or bromide is easily displaced by fluorine in aqueous saturated potassium fluoride and a catalytic amount of hexadecyltributylphosphonium bromide [68] (Table 7 Procedure 4, p 194)... 

Typical synthetic procedures include the reaction of alkyl halides with the silver salts of carboxylic acids, the reaction of carboxylate anions in alkali with an excess of a dialkyl sulphate, (especially dimethyl sulphate), and heating tertiary184 or quaternary ammonium salts of carboxylic acids. These routes are particularly valuable for the preparation of esters of seriously sterically hindered acids. For example, Fuson et al.iK made the methyl ester of 2,4,6-triethylbenzoic acid by heating the tetramethyl ammonium salt to 200-250°C, viz. 

There has been a review of die effects of high pressure on the substitution reactions of amines witii haloaromatic compounds, including polyhalobenzenes.17 Nucleophilic substiditions by amines often proceed readily hi dimethyl sulfoxide (DMSO). The pKa values, hi DMSO, have been reported for some ammonium ions derived from amines widely used as nucleophiles in 5nAt reactions.18 Correlations have been established19 between die oxidation potentials and the basicities of some arylamhie and diarylamine anions and die rate constants for dieir reactions with aiyl halides in DMSO. 

Further alkylation of tertiary amines yields quaternary ammonium salts. These compounds are numerous and are readily prepared by heating the alkyl halide and tertiary amine in the absence of a solvent or in the presence of alcohol. Methylation of tertiary amines to quaternary ammonium salts can be accomplished with methyl halides or dimethyl sulfate. ... 

Chlorobenzene is employed in the synthesis of certain amino-containing vat dye intermediates. When reacted with phthalic anhydride, the product is 2-chloroanthraquinone, which, with ammonia, is converted readily into 2-aminoanthraquinone (61). Other routes include replacement of halogen by amino groups, with ammonia or ammonium salts of urea, and alkyl- and aryl amines to afford secondary amines. Modification of the amino group by alkylation, with dimethyl sulfate, alkyl halides or esters of toluenesul-fonic acids, is of synthetic value. Arylation of the amino groups is of importance only in the reaction between aminoanthraquinones and nitro- or chloroanthraquinones to yield dianthraquinonylamines, or anthrimides48. For example, the reaction between 62 and 63 yields 64, which can then be converted into carbazole 65, Cl Vat Brown R (Scheme 14). Amination of haloanthraquinones such as l-amino-4-bromoanthraquinone-2-sulfonic acid (bromamine acid) (66), prepared from 1-aminoanthraquinone, is of industrial use. 

The palladium-catalysed arylation of olefins with aryl halides, the Heck reaction, is usually performed in polar solvents such as acetonitrile or dimethyl sulfoxide, in combination with a base and a Pd(ii) pre-catalyst that may or may not be associated with a phosphorus ligand. Given that quaternary ammonium or phosphonium salts are known to increase reaction rates, ILs emerged as promising solvents for this reaction.In the case of imidazolium-based ionic liquids, the solvent, beside providing an unusual coulombic environment. 

---