3-Aminopropyl triethoxy silane

Glass microscope slides that have been coated with 3-aminopropyl-triethoxy-silane (APES) (see Note 1)... 

CMCs of these polyfluorinated surfactants are of the order of 10 5 m.47 Plots of the observed H chemical shifts versus surfactant concentration of cetyl trimethyl ammonium chloride, cetyl pyridinium chloride, cetyl dimethyl phenyl ammonium chloride, cetyl dimethyl benzyl ammonium chloride, cetyl dimethy 1-2-phenyl ethyl ammonium chloride, and cetyl dimethyl-3-phenyl propyl ammonium chloride, are sigmoidal and were fitted to a model based on the mass action. The H chemical shift-based CMC values are in excellent agreement with those determined by the surface tension method.48 The micellization processes of dodecyl trimethyl ammonium halides (chloride and bromide) studied by calorimetric titration show different behaviors at 298 K. However, these disappear at 313 K, while the results measured by the chemical shift versus surfactant concentration do not show this difference.49 The CMC of 3-aminopropyl triethoxy silane in toluene is ca. 0.47m, measured by H and l3C chemical shifts.50 The CMC of optically active potassium A -n-dodecanoyl alaminate measured by H and l3C chemical shifts is lower (11-15 him) in D20 than that in a mixed solvent of 1,4-dioxane and D20 (19mM).-51 The H chemical shift shows that the CMC of resorcinol-type calix[4] phosphoric esters having four alkyl side-chains, [4]Ar 5P-R-n, is insensitive to the length of the side-chains, n.52 The CMC values of a family of surfactants, the sodium cyclohexyl alkanoates, with different lengths of the alkanoate side-chains, were obtained from 13C chemical-shift measurements. The results show that these amphiphiles have high CMCs (0.12-1.02 m).-53... 

CAS 919-30-2 EINECS/ELINCS 213-048-4 Synonyms (3-Aminopropyl) triethoxysilane y-Aminopropyl triethoxysilane Propylamine, 3-(triethoxysilyl)- Silane, (3-aminopropyl) triethoxy- Silane, y-aminopropyltriethoxy- Triethoxy (3-aminopropyl) silane 3-(Triethoxysilyl)-I -propanamine 3-(Triethoxysilyl) propylamine Empirical CgHjsNOsSi Formula NH2(CH2),Si(OC2H5),... 

A better control of the morphology of imprinted composite materials is obtained if the imprinted polymer is grown from a substrate that has been modified with an initiator. A free radical initiator can be attached to a surface either chemically or by adsorption. Schweitz [34] attached 4,4 -azobis(4-cyanopentanoic acid) (6a) using carbodiimide coupling to a fused capillary wall which had been treated with 3-aminopropyl triethoxy silane. 

Noninvasive label-free biosensor using (3-aminopropyl) triethoxy silane and Glucose Chronoamperom- etry 0.6 nM/5 pM—50mM Balakrishnan et al. (2014)... 

APTES 3-aminopropyl(triethoxy)silane (also referred to as APS, APT or APTS) APTMS (3-aminopropyl)trimethoxysilane... 

---