Devices analysis

Nakamura H, Yamashita K, Rocha AR, Sanvito S (2008) Efficient ab initio method for inelastic transport in nanoscale devices analysis of inelastic electron tunneling spectroscopy. Phys Rev B 78(23) 235418-235420... 

Yoon, J. K. Kim, J. H. (1998). Device Analysis for a-Si H Thin-Film Transistors with Organic Passivation Layer, IEEE Electron Device Lett., Vol. 19, 335-337, ISSN 0741-3106... 

D Avanzo, P. C. Vanzi, M. Dutton, R. W. "One-Dimensional Semiconductor Device Analysis (SEDAN)" Stanford Electronics Laboratory, Technical Report No. G-201-5, Stanford, California 1979. 

FIGURE 46.19 Impedance spectroscopy, (a) Schematic diagram of the impedance measurement device analysis plots (b) Nyquist plot and (c) Bode plot. 

Potential Future Uses of Microfluidic Devices Analysis of Circulating Tumor Cells... 

Additional trials with more participants (of both sexes, and of varying weight) are required. To avoid possible bias, a change in role with respect to water and/or alcohol consumption, and a repeat measurement for both groups, should be taken into account. In case of a contactless device, analysis focusing on the signal-to-nose ration (SNR) is necessary because it is known that, for example, inductive bioimpedance measurements can achieve only low SNRs (between 20 dB and 50 dB) [9]. 

Ramos Garcia J.A., Sanchez Dominguez, F. and Alvarez Loranca, R. 2013. Structural road surveys using a Curviameter device. Analysis of the temperature effect on asphalt mixes properties. 9th International Conference on the Bearing Capacity of Roads, Railways and Airfields (BCRRA). Trondheim, Norway, June. 

In the case of combined device (i.e., filtration-flotation water treatment under recirculation conditions), it is important to know the values of integrated constants of the filtration process, bioflltration process, bubble-flhn extraction process, gas exchange absorption process, and ion separation process in the functional units of combined device, that is, in the filter and in the bubble-film extractor, operating separately. The initial parameters for the device analysis are the required purification degree and treating time. And the calculated parameters are the integrated rate constants of such processes as filtration, biofiltration, flotation, bubble absorption, and dimensions of reaction spaces. 

There are some standard testing methods for medical devices, which may be related to wound dressings in ASTM these include general practice for medical devices, analysis of medical materials, methods for medical packages, " fluid penetration,sterilisation, and disinfection. ... 

Purohit, G.P., Ellison, J.R., Jaekle, D.E., 1999. Propellant management device analysis for some off-design operational scenarios. In AIAA-99-2974, 35th Joint Propulsion Conference, Los Angeles, CA, June 20-23. 

---