Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Control, cis/trans

Polybutadiene (PB) and polyisoprene with cis-trans controlled microstructure (synthesis of "natural rubber"). [Pg.47]

One may conclude that the rate-determining step of the renaturation is at least partly influenced by the cis-trans isomerization of the peptide bond the secondary nitrogen atom of which arises from proline. Otherwise, only the entropy-controlled slow nuclea-tion should be observed kinetically. The covalent bridging through Lys-Lys, therefore, gives rise not only to thermodynamic stabilization of the triple helix but also to kinetic properties which have hitherto been observed in the case of type III procollagen146) and its aminoterminal fragment Col 1-3144). [Pg.185]

A recent study of Murov and co-workers<106) indicates that the activation energies for isomerization are not the controlling factors. Thus the fluorescence of naphthalene is quenched (5 x 108M-1sec-1) by cis-trans-1,3-cyclooctadiene with isomerization to form cis-cis-1,3-cyclooctadiene. However, the compound bicyclo[4,2.0]oct-7-ene is not formed despite the low activation energy for this process ... [Pg.158]

The hydrogenation of para-substituted anilines over rhodium catalysts has been investigated. An antipathetic metal crystallite size effect was observed for the hydrogenation of /Moluidinc suggesting that terrace sites favour the reaction. Limited evidence was found for catalyst deactivation by the product amines. Catalysts with pore diameters less than 13.2 nm showed evidence of diffusion control on the rate of reaction but not the cis trans ratio of the product. [Pg.77]

Double bond cis-trans isomerization occurs during hydrogenation with a relative rate dependent on structure. The less stable double bond isomerizes to the more stable one, but, of course, kinetics and thermodynamics control the extent of isomerization. In a linear carbon chain, one can expect the cis alkene to isomerize to trans and vice versa if the thermodynamics are favorable. However, in a strained cyclic system, trans will isomerize to cis (Fig. 2.13).117... [Pg.49]

Reaction of phenyl vinyl ketone with cyclopentanone under thermal conditions resulted in a diastereomeric mixture of 1,5,9-triketones 374 via a double Michael reaction. Treatment of this mixture with ammonium formate in polyethyleneglycol-200 under microwave irradiation conditions led to the very fast and efficient formation of a 2 1 diastereomeric mixture of cyclopental flquinolizidines 375 and 376 <2002T2189>. When this reductive amination-cyclization procedure was carried out starting from the purified /ra r-isomer of 374, the result was identical to that obtained from the cis-trans mixture, showing the operation of thermodynamic control (Scheme 86). [Pg.54]

By using a transition metal chloride catalyst and an iodine modified cocatalyst, ring-opening polymerization of C5 and C8 monocyclic olefins is controlled to prepare either cis polymers or trans products that are crystallizable. In copolymerization, the cis/trans units in the copolymers are regulated by adjusting the C5/C8 olefin monomer ratio. As the comonomer is increased, the copolymer becomes less crystalline and then completely amorphous at equal amounts of cis/trans units. Polymerization results are reported from WC16 and MoCl5 catalysts. [Pg.155]

Yoshida has studied anodic oxidations in methanol containing cyanide to elucidate the electrode processes themselves.288 He finds that, under controlled potential ( 1.2 V), 2,5-dimethylfuran gives a methoxynitrile as well as a dimethoxy compound (Scheme 57). Cyanide competes for the primary cation radical but not for the secondary cations so that the product always contains at least one methoxy group. On a platinum electrode the cis-trans ratio in the methoxynitrile fraction is affected by the substrate concentration and by the addition of aromatic substances suggesting that adsorption on the electrode helps determine the stereochemistry. On a vitreous carbon electrode, which does not strongly adsorb aromatic species, the ratio always approaches the equilibrium value. [Pg.228]

We have reported the first example of a ring-opening metathesis polymerization in C02 [144,145]. In this work, bicyclo[2.2.1]hept-2-ene (norbornene) was polymerized in C02 and C02/methanol mixtures using a Ru(H20)6(tos)2 initiator (see Scheme 6). These reactions were carried out at 65 °C and pressure was varied from 60 to 345 bar they resulted in poly(norbornene) with similar conversions and molecular weights as those obtained in other solvent systems. JH NMR spectroscopy of the poly(norbornene) showed that the product from a polymerization in pure methanol had the same structure as the product from the polymerization in pure C02. More interestingly, it was shown that the cis/trans ratio of the polymer microstructure can be controlled by the addition of a methanol cosolvent to the polymerization medium (see Fig. 12). The poly(norbornene) prepared in pure methanol or in methanol/C02 mixtures had a very high trans-vinylene content, while the polymer prepared in pure C02 had very high ds-vinylene content. These results can be explained by the solvent effects on relative populations of the two different possible metal... [Pg.133]

The isomer distribution of the nickel catalyst system in general is similar qualitatively to that of the Rh catalyst system described earlier. However, quantitatively it is quite different. In the Rh system the 1,2-adduct, i.e., 3-methyl-1,4-hexadiene is about 1-3% of the total C6 products formed, while in the Ni system it varies from 6 to 17% depending on the phosphine used. There is a distinct trend that the amount of this isomer increases with increasing donor property of the phosphine ligands (see Table X). The quantity of 3-methyl-1,4-pentadiene produced is not affected by butadiene conversion. On the other hand the formation of 2,4-hexadienes which consists of three geometric isomers—trans-trans, trans-cis, and cis-cis—is controlled by butadiene conversion. However, the double-bond isomerization reaction of 1,4-hexadiene to 2,4-hexadiene by the nickel catalyst is significantly slower than that by the Rh catalyst. Thus at the same level of butadiene conversion, the nickel catalyst produces significantly less 2,4-hexadiene (see Fig. 2). [Pg.308]

Under analogous conditions, carbonylation of chloral affords cis or trans 2,5-bis(trichloromethyl)-l,3-dioxolan-4-ones. The stereochemical outcome of the reactions can be controlled by the concentration of the employed sulfuric acid (90-99%) and the reaction time. The cis isomer is predominantly formed under more acidic conditions after 10 min (cis/trans 95/5 48% yield), whereas complete isomerization to the trans isomer (cisltrans 0/100 65% yield) takes place at lower acidity (90%) and prolonged reaction time (7 h) [63]. [Pg.225]

Anodic oxidation of 2-t-butylindan in acetic acid led predominantly to side-chain acetoxylation at a Pt or Pb02 anode. The cis/trans ratio of the two acetates is significantly higher in the anodic process than in the related homogeneous reactions, indicating that adsorption at least partially controls the anodic reaction [206, 207]. Menthyl 4-methoxyarylacetate (5) could be... [Pg.424]

Using this system, (Z)-hinokiresinol isolated from cultured cells of A. officinalis was determined to be the optically pure (75 )-isomer, while ( )-hinokiresinol isolated from cultured cells of C. japonica had 83.3% e.e. in favor of the (7S)-enantiomer (Table 12.1). The enzymatically formed (Z)-hinokiresinol obtained following incubation of p-coumaryl p-coumarate with a mixture of equal amounts of recZHRSa and recZHRSf) was found to be the optically pure (75)-isomer, which is identical to that isolated from A. officinalis cells (Table 12.1). A similar result was obtained with the crude plant protein from A. officinalis cultured cells, where the formed (Z)-hinokiresinol was almost optically pure, 97.2% e.e. in favor of the (75)-isomer (Table 12.1). In sharp contrast, when each subunit protein, recZHRSa or recZHRSP, was individually incubated with p-coumaryl p-coumarate, ( )-hinokiresinol was formed (Table 12.1). The enantiomeric compositions of ( )-hinokiresinol thus formed were 20.6% e.e. (with recZHRSa) and 9.0% e.e. (with recZHRSP) in favor of the (7S)-enantiomer (Table 12.1). Taken together, these results clearly indicate that the subunit composition of ZHRS controls not only cis/trans selectivity but also enantioselectivity in hinokiresinol formation (Fig. 12.3). This provides a novel example of enantiomeric control in the biosynthesis of natural products. Although the mechanism for the cis/trans selective and enantioselective reaction remains to be elucidated, for example by x-ray crystallography, the enantioselective mechanism totally differs from the enantioselectivity in biosynthesis of lignans, another class of phenylpropanoid compounds closely related to norlignans in terms of structure and biosynthesis. [Pg.184]


See other pages where Control, cis/trans is mentioned: [Pg.155]    [Pg.135]    [Pg.155]    [Pg.135]    [Pg.273]    [Pg.214]    [Pg.159]    [Pg.766]    [Pg.303]    [Pg.71]    [Pg.126]    [Pg.209]    [Pg.192]    [Pg.245]    [Pg.240]    [Pg.182]    [Pg.158]    [Pg.165]    [Pg.219]    [Pg.357]    [Pg.795]    [Pg.11]    [Pg.258]    [Pg.628]    [Pg.495]    [Pg.255]    [Pg.129]    [Pg.171]    [Pg.194]    [Pg.22]    [Pg.224]    [Pg.194]    [Pg.108]    [Pg.48]    [Pg.239]   


SEARCH



© 2024 chempedia.info