Catalyst Inoue

Finally, it is appropriate to close this chapter with an example from the roots of fine chemicals the dyestuff, indigo. Manufacture of indigo involves chemistry (see Fig. 2.15) which has hardly changed from the time of the first commercial synthesis more than a hundred years ago (see earlier). Mitsui Toatsu has developed a two-step process in which indole is produced by vapour-phase reaction of ethylene glycol with aniline over a supported silver catalyst (Inoue et al., 1994). Subsequent liquid-phase oxidation of the indole, with an alkyl hydroperoxide in the presence of a soluble molybdenum catalyst, affords indigo. 

Fig. 5.14 Inoue et al. carried out a systematic study of the photocatalytic reduction of CO2 by different semiconductor powders in aqueous suspensions. Shown here is the energy correlation between semiconductor catalysts and redox couples in water, as presented in their paper. In principle, the solution species with more positive redox potential with respect to the conduction band level of the semiconductor is preferably reduced at the electrode. Photoexcited electrons in the more negative conduction band certainly have greater ability to reduce CO2 in the solution. (Reproduced from [240])...

OH adsorption on Ru is a key factor that makes this metal the major component of various bimetallic catalysts for anode reactions. Ru-OH causes a signihcant inhibition of the ORR [Inoue et al., 2002]. In situ SXS data for the oxidation of Ru(OOOl) in acid... 

Zhang, P. W. Inoue, K. Tsuyama, H. Recovery of metal values from spent hydrodesulfurization catalysts by liquid-liquid extraction. Energy Fuels 1995, 9, 231-239. 

The work discussed above by Snapper, Hoveyda, and co-workers (27) illustrates the power of a parallel approach to catalyst development. The authors took a basic ligand type that had been reported by Inoue and co-workers (25) for the catalysis of cyanohydrin synthesis and optimized the system for two other reactions and a number of substrates. 

Obviously, in such cases the CD is acting as a true catalyst in esterolysis. The basic cleavage of trifluoroethyl p-nitrobenzoate by a-CD occurs by both pathways approximately 20% by nucleophilic attack and approximately 80% by general base catalysis (GBC) (Komiyama and Inoue, 1980c). The two processes are discernible because only the former leads to the observable p-nitrobenzoyl-CD. For the ester, Ks = 3.4 mM and kjka = 4.4 for the GBC route (1.25 for the nucleophilic route), and so KTS = 0.77 mM. For reaction within the ester CD complex [28], it was estimated that the effective molarity of the CD hydroxyl anion was 21-210 m (for Br0nsted /3 = 0.4 to 0.6 for GBC). Such values are quite reasonable for intramolecular general base catalysis (Kirby, 1980). 

For unsaturated lactones containing an endocyclic double bond also the two previously described mechanisms are presumably involved and the regio-selectivity of the cyclocarbonylation is governed by the presence of bulky substituents on the substrate. Inoue and his group have observed that the catalyst precursor needs to be the cationic complex [Pd(PhCN)2(dppb)]+ and not a neutral Pd(0) or Pd(II) complex [ 148,149]. It is suggested that the mechanism involves a cationic palladium-hydride that coordinates to the triple bond then a hydride transfer occurs through a czs-addition. Alper et al. have shown that addition of dihydrogen to the palladium(O) precursor Pd2(dba)3/dppb affords an active system, in our opinion a palladium-hydride species, that coordinates the alkyne [150]. 

Takahashi, M Nakatani, T Iwamoto, S Watanabe, T Inoue, M. Effect of the composition of spinel-type Ga203-Al203-Zn0 catalysts on activity for the CH4-SCR of NO and optimization of catalyst composition, Ind. Eng. Chem. Res., 2006, Volume 45, Issue 10, 3678-3683. 

Oi and Inoue recently described the asymmetric rhodium-catalyzed addition of organosilanes [35]. The addition of aryl- and alkenyltriaUcoxysilanes to u,y9-unsaturated ketones takes place, in the presence of 4 mol% of a cationic rhodium catalyst generated from [Rh(COD)(MeCN)2]BF4 and (S)-B1NAP in dioxane/H20 (10 1) at 90°C, to give the corresponding conjugate addition products (Eq. 3). The enantioselectivity is comparable to that observed with the boronic acids, as the same stereochemical pathway is applicable to these reactions (compare Scheme 3.7). 

The polymer stereosequence distributions obtained by NMR analysis are often analyzed by statistical propagation models to gain insight into the propagation mechanism [Bovey, 1972, 1982 Doi, 1979a,b, 1982 Ewen, 1984 Farina, 1987 Inoue et al., 1984 Le Borgne et al., 1988 Randall, 1977 Resconi et al., 2000 Shelden et al., 1965, 1969]. Propagation models exist for both catalyst (initiator) site control (also referred to as enantiomorphic site control) and polymer chain end control. The Bemoullian and Markov models describe polymerizations where stereochemistry is determined by polymer chain end control. The catalyst site control model describes polymerizations where stereochemistry is determined by the initiator. 

Inoue s cyclic dipeptide 17 had been shown to catalyze the addition of HCN to aldehydes to form optically active cyanohydrins [70]. Lipton found that this same catalyst was unable to catalyze the mechanistically related Strecker reaction... 

Early-on it was discovered that these Salen compounds, and the related six-coordinate cations [6], were useful as catalysts for the polymerization of oxiranes. These applications were anticipated in the efforts of Spassky [7] and in the substantial work of Inoue [8]. Subsequently, applications of these compounds in organic synthesis have been developed [9]. Additional applications include their use in catalytic lactide polymerization [10], lactone oligomerization [11], the phospho-aldol reaction [12], and as an initiator in methyl methacrylate polymerization [13]. 

Makoto Yamashita Makoto Yamashita, born in 1974 in Hiroshima, received his Ph.D. from Hiroshima University in 2002 under the guidance of Professor Yohsuke Yamamoto and Professor Kin-ya Akiba. He spent two years as a JSPS research fellow under the supervision of Professor John F. Hartwig at Yale University and Professor Takayuki Kawashima at The University of Tokyo. He started his current appointment as a research associate with Professor Kyoko Nozaki at The University of Tokyo in 2004. His current research interests are organometallic chemistry, organome-tallic catalyst, polymer chemistry, and main group chemistry. He has been awarded Inoue Research Award for Young Scientist (2005) and Takeda Pharmaceutical Company Award in Synthetic Organic Chemistry, Japan (2005). 

Inoue,S., Tsukuma.I., Kawaguchi,M., Tsuruta,T. Synthesis of optically active polymers by asymmetric catalysts. VI. Behavior of organozinc catalyst systems in the stereoselective polymerization of propylene oxide. Makromol. Chem. 103,151 (1967). 

In the wake of this report, many chiral iron(III)- and Mn(III)-porphyrin complexes have been synthesized and applied to the epoxidation of styrene derivatives [20]. Because these asymmetric epoxidations are discussed in the first edition of this book [21], the discussion on metalloporphyrin-catalyzed epoxidation here is limited to some recent examples. Most chiral metallopor-phyrins bear chiral auxi Maries such as the one derived from a-amino acid or binapthol. Differing from these complexes is complex 6, which has no chiral auxiliary but is endowed with facial chirality by introducing a strap and has been reported by Inoue et al. [20f]. Epoxidation of styrene by using only 6 as the catalyst shows low enantioselectivity, but the selectivity is remarkably enhanced when the reaction is performed in the presence of imidazole (Scheme 6B.11). This result can be explained by assuming that imidazole coordinates to the unhindered face of the complex and the reaction occur on the strapped face [20f. ... 

The transfer of a carbamate moiety to olefins has been documented only in very few cases, using activated unsaturated substrates. For example, Yoshida and Inoue reported the selective (100%) formation of 1-ethoxyethyl N,N-dialkylcarbamate esters by the reaction of C02 (5 MPa) with ethyl vinyl ether and secondary amines R2NH (R = Me, Et) in the absence of any catalyst (Equation 6.11) [85]. 

The first report of the copolymerization of an epoxide, namely, ethylene oxide and C02 is contained in a patent by Stevens [6]. However, this process, when carried out in the presence of polyhydric phenols, provided polymers which were viscous liquids or waxes possessing copious polyether linkages with only a few incorporated C02 units. The earliest metal-catalyzed copolymerization of epoxides and C02 was reported in 1969 by Inoue and coworkers, who employed a heterogeneous catalyst system derived from a 1 1 mixture of diethylzinc and H20 [7, 8], Subsequently, Kuran and coworkers investigated a group of related catalysts prepared from diethylzinc and di- and triprotic sources such as pyrogallol, with a slight improvement over Inoue s system for the production of polypropylene carbonate) from PO and C02 [9],... 

---