C base-catalyzed

Mechanism Step (A) Acid Catalyzed (B) Non-Catalyzed (C) Base Catalyzed ... 

Evans, E. A., Sheppard, H. C., Base-Catalyzed Hydrogen Exchange, 16, I. 

Chemoselective C-alkylation of the highly acidic and enolic triacetic acid lactone 104 (pAl, = 4.94) and tetronic acid (pA, = 3.76) is possible by use of DBU[68]. No 0-alkylation takes place. The same compound 105 is obtained by the regioslective allylation of copper-protected methyl 3,5-dioxohexano-ate[69]. It is known that base-catalyzed alkylation of nitro compounds affords 0-alkylation products, and the smooth Pd-catalyzed C-allylation of nitroalkanes[38.39], nitroacetate[70], and phenylstilfonylnitromethane[71] is possible. Chemoselective C-allylation of nitroethane (106) or the nitroacetate 107 has been applied to the synthesis of the skeleton of the ergoline alkaloid 108[70]. 

This reaction is carried out under base-catalyzed conditions and with a formaldehyde/phenol ratio greater than unity. The resulting product is called a C state resin or resite. 

The base-catalyzed reaction of acetaldehyde with excess formaldehyde [50-00-0] is the commercial route to pentaerythritol [115-77-5]. The aldol condensation of three moles of formaldehyde with one mole of acetaldehyde is foUowed by a crossed Cannizzaro reaction between pentaerythrose, the intermediate product, and formaldehyde to give pentaerythritol (57). The process proceeds to completion without isolation of the intermediate. Pentaerythrose [3818-32-4] has also been made by condensing acetaldehyde and formaldehyde at 45°C using magnesium oxide as a catalyst (58). The vapor-phase reaction of acetaldehyde and formaldehyde at 475°C over a catalyst composed of lanthanum oxide on siHca gel gives acrolein [107-02-8] (59). 

Chemical Properties. The hydrolysis of PET is acid- or base-catalyzed and is highly temperature dependent and relatively rapid at polymer melt temperatures. Treatment for several weeks in 70°C water results in no significant fiber strength loss. However, at 100°C, approximately 20% of the PET tenacity is lost in one week and about 60% is lost in three weeks (47). In general, the hydrolysis and chemical resistance of copolyester materials is less than that for PET and depends on both the type and amount of comonomer. 

The most recent, and probably most elegant, process for the asymmetric synthesis of (+)-estrone appHes a tandem Claisen rearrangement and intramolecular ene-reaction (Eig. 23). StereochemicaHy pure (185) is synthesized from (2R)-l,2-0-isopropyhdene-3-butanone in an overall yield of 86% in four chemical steps. Heating a toluene solution of (185), enol ether (187), and 2,6-dimethylphenol to 180°C in a sealed tube for 60 h produces (190) in 76% yield after purification. Ozonolysis of (190) followed by base-catalyzed epimerization of the C8a-hydrogen to a C8P-hydrogen (again similar to conversion of (175) to (176)) produces (184) in 46% yield from (190). Aldehyde (184) was converted to 9,11-dehydroestrone methyl ether (177) as discussed above. The overall yield of 9,11-dehydroestrone methyl ether (177) was 17% in five steps from 6-methoxy-l-tetralone (186) and (185) (201). 

It is carried out in the Hquid phase at 100—130°C and catalyzed by a soluble molybdenum naphthenate catalyst, also in a series of reactors with interreactor coolers. The dehydration of a-phenylethanol to styrene takes place over an acidic catalyst at about 225°C. A commercial plant (50,51) was commissioned in Spain in 1973 by Halcon International in a joint venture with Enpetrol based on these reactions, in a process that became known as the Oxirane process, owned by Oxirane Corporation, a joint venture of ARCO and Halcon International. Oxirane Corporation merged into ARCO in 1980 and this process is now generally known as the ARCO process. It is used by ARCO at its Channelview, Texas, plant and in Japan and Korea in joint ventures with local companies. A similar process was developed by Shell (52—55) and commercialized in 1979 at its Moerdijk plant in the Netherlands. The Shell process uses a heterogeneous catalyst of titanium oxide on siHca support in the epoxidation step. Another plant by Shell is under constmction in Singapore (ca 1996). 

Deuteration of C-methyl protons in simple methylpyrimidines and their amino and hydroxy derivatives has been studied under acidic and basic conditions. The exchange is acid/base catalyzed with, for example, a minimal rate at pH 4 for 1,4,6-trimethylpyrimidin-2(lH)-imine (67JCS(B)171). 

Dioxopiperazines have been converted into the corresponding dihydroxypyrazines by base catalyzed isomerization of the corresponding arylidene derivatives (Scheme 64) (70JCS(C)980), although this reaction appears to be limited to the synthesis of benzyl- or aryl-substituted benzylpyrazines. 

Two disadvantages are associated with the use of S-acetyl or 5-benzoyl derivatives in peptide syntheses (a) base-catalyzed hydrolysis of 5-acetyl- and 5-benzoylcys-teine occurs with /S-elimination to give olefinic side products, CH2=C-(NHPG)CO—(b) the yields of peptides formed by coupling an unprotected amino group in an 5-acylcysteine are low because of prior S-N acyl migration. ... 

Use of the trapping agent is recommended as the most efficient method for running acyloin condensations for many reasons. Among them are (a) the work-up is very simple filter and distil (b) the bis-(silyloxy)olefin is usually easier to store than the free acyloin and is readily purified by redistillation (c) unwanted base-catalyzed side reactions during reduction are completely avoided and (d) the bis-(silyloxy)olefin can be easily converted directly into the diketone by treatment with 1 mole of bromine in carbon tetrachloride.Other reactions are described in Riihlmann s review and in Organic Reactions ... 

Chapters 1 and 2. Most C—H bonds are very weakly acidic and have no tendency to ionize spontaneously to form carbanions. Reactions that involve carbanion intermediates are therefore usually carried out in the presence of a base which can generate the reactive carbanion intermediate. Base-catalyzed condensation reactions of carbonyl compounds provide many examples of this type of reaction. The reaction between acetophenone and benzaldehyde, which was considered in Section 4.2, for example, requires a basic catalyst to proceed, and the kinetics of the reaction show that the rate is proportional to the catalyst concentration. This is because the neutral acetophenone molecule is not nucleophihc and does not react with benzaldehyde. The much more nucleophilic enolate (carbanion) formed by deprotonation is the reactive nucleophile. 

---