Borohydride, sodium reaction with acid chlorides

Primary amines are transformed into amides by substitution reactions of acid chlorides, and to imines by condensation with an aldehyde in the presence of an acid catalyst. Both amides and imines may be reduced to amines amides need LiAlH4, while imines may be reduced by sodium borohydride, sodium cyanoborohydride, or hydrogenation over a palladium catalyst. 

Isomannide (80) was the core for a hexahydrofurofuran library." Primary amines were loaded onto solid-support by reductive amination and acylated with bromoacetic acid to give bromides 79 (Scheme 7.16). Alkylation of bromides 79 on solid-support with isomannide (80) gave the solid-supported alcohols 81. A Mitsunobu reaction with phthalimide (82) proceeded to furnish amines 83 in excellent yield and purity after removal of the protecting group." " Support-bound primary amines 83 were converted to secondary amines by stepwise imine formation with aldehydes 84 and reduction with sodium borohydride." The hindered secondary amines 85 were acylated with acid chlorides, sulfonyl chlorides, isocyanates, and isothiocyanates to yield 87 after cleavage from solid-support. 

Aniline 77 was converted into its diazonium salt with nitrous acid and this was followed by reduction with stannous chloride to afford the corresponding arylhydrazine 78. Condensation of 78 with 3-cyanopropanal dimethylacetal 79 gave the arylhydrazone 80. Treatment of 80 with PPE resulted in cyclization to indole 81. The nitrile group was then reduced to the primary amine by catalytic hydrogenation. Reaction of the amine with excess formalin and sodium borohydride resulted in Imitrex (82). 

The key intermediate 21 is in principle accessible in any of several ways. Thus reaction of thiophenecarbox-aldehyde with amninoacetal would lead to the Schiff base 20 treatment with acid would result in formation of the fused thiophene-pyridine ring (21). Alkylation of that intermediate with benzyl chloride gives the corresponding ternary imini urn salt 23. Treatment with sodium borohydride leads to reduction of the quinolinium ring and thus formation of ticlopidine (24). ... 

Intermediate 10 must now be molded into a form suitable for coupling with the anion derived from dithiane 9. To this end, a che-moselective reduction of the benzyl ester grouping in 10 with excess sodium borohydride in methanol takes place smoothly and provides primary alcohol 14. Treatment of 14 with methanesulfonyl chloride and triethylamine affords a primary mesylate which is subsequently converted into iodide 15 with sodium iodide in acetone. Exposure of 15 to tert-butyldimethylsilyl chloride and triethylamine accomplishes protection of the /Mactam nitrogen and leads to the formation of 8. Starting from L-aspartic acid (12), the overall yield of 8 is approximately 50%, and it is noteworthy that this reaction sequence can be performed on a molar scale. 

As second example for the scale-up of solid-phase reactions directly on solid support, we chose an arylsulfonamido-substituted hydroxamic acid derivative stemming from the matrix metalloproteinase inhibitor library (MMP) of our research colleagues (Breitenstein et al. 2001). In this case, there was already a solution-phase synthesis available for comparison (see Scheme 4). The synthesis starts with the inline formation of a benzaldehyde 18 with the glycine methyl ester, which is then reduced to the benzylamine 20 using sodium borohydride in methanol/ THF (2 1). The sulfonamide formation is carried out in dioxane/H20 (2 1) with triethylamine as the base and after neutralisation and evaporation the product 21 can be crystallised from tert. butylmethyl ether. After deprotection with LiOH, the acid is activated by treatment with oxalyl chloride and finally converted into the hyroxamic acid 23 in 33.7% yield overall. 

One-pot conversions of 2-hydroxy(acylbenzenes) with anhydrides or acid chlorides to produce coumarins [52-54] and flavones [54-58] under mild liquiddiquid or solidtliquid two-phase conditions via a Baker-Venkataraman type reaction (Scheme 6.19) are catalysed by quaternary ammonium salts. 3-Substituted coumarins are produced from salicylaldehyde and malonodinitrile, or substituted acetonitriles, in high yield (>85%) in a one-pot catalysed sequential aldol-type reaction and cycliza-tion in the absence of an added organic solvent [59]. When 2 -hydroxychalcones are reduced under catalytic two-phase conditions with sodium borohydride, 2,4-cis-flavan-4-ols are produced [60] (see Section 11.3). 

The facile homogeneous catalysed reduction of acid chlorides to alcohols has many advantages over reduction with sodium borohydride in hydroxylic solvents where rapid reaction of the acid chloride with the solvent can occur [10]. The procedure has been incorporated into a simple one-pot conversion of aroyl chlorides into the corresponding benzyl chlorides (Scheme 11.1) under liquidrliquid or solid-liquid two-phase conditions [11], The reduction of a limited number of aryl compounds was reported with ca. 70% overall yields, although poorer yields result from the reduction of 4-nitro-, 2-cyano- and 2,4-dichlorobenzoyl chlorides, and the reduction failed completely with terphthaloyl chloride and with its 2,3,5,6-tetrafluoro derivative [11]. 

A boron analog - sodium borohydride - was prepared by reaction of sodium hydride with trimethyl borate [84 or with sodium fluoroborate and hydrogen [55], and gives, on treatment with boron trifluoride or aluminum chloride, borane (diborane) [86. Borane is a strong Lewis acid and forms complexes with many Lewis bases. Some of them, such as complexes with dimethyl sulfide, trimethyl amine and others, are sufficiently stable to have been made commercially available. Some others should be handled with precautions. A spontaneous explosion of a molar solution of borane in tetrahydrofuran stored at less than 15° out of direct sunlight has been reported [87]. 

Two years later, the same group reported a formal synthesis of ellipticine (228) using 6-benzyl-6H-pyrido[4,3-f>]carbazole-5,ll-quinone (6-benzylellipticine quinone) (1241) as intermediate (716). The optimized conditions, reaction of 1.2 equivalents of 3-bromo-4-lithiopyridine (1238) with M-benzylindole-2,3-dicarboxylic anhydride (852) at —96°C, led regioselectively to the 2-acylindole-3-carboxylic acid 1233 in 42% yield. Compound 1233 was converted to the corresponding amide 1239 by treatment with oxalyl chloride, followed by diethylamine. The ketone 1239 was reduced to the corresponding alcohol 1240 by reaction with sodium borohydride. Reaction of the alcohol 1240 with f-butyllithium led to the desired 6-benzylellipticine quinone (1241), along with a debrominated alcohol 1242, in 40% and 19% yield, respectively. 6-Benzylellipticine quinone (1241) was transformed to 6-benzylellipticine (1243) in 38% yield by treatment with methyllithium, then hydroiodic acid, followed... 

Beccalli et al. reported a new synthesis of staurosporinone (293) from 3-cyano-3-(lH-indol-3-yl)-2-oxo propionic acid ethyl ester (1464) (790). The reaction of 1464 with ethyl chlorocarbonate and triethylamine afforded the compound 1465, which, on treatment with dimethylamine, led to the corresponding hydroxy derivative 1466. The triflate 1467 was prepared from 1466 by reaction with trifluoromethanesulfonic anhydride (Tf20) in the presence of ethyldiisopropylamine. The palladium(O)-catalyzed cross-coupling of the triflate 1467 with the 3-(tributylstannyl)indole 1468 afforded the vinylindole 1469 in 89% yield. Deprotection of both nitrogen atoms with sodium ethoxide in ethanol to 1470, followed by photocyclization in the presence of iodine as the oxidizing agent provided the indolocarbazole 1471. Finally, reductive cyclization of 1471 with sodium borohydride-cobaltous chloride led to staurosporinone (293) in 40% yield (790) (Scheme 5.248). 

In aqueous solutions, calcium chloride undergoes double decomposition reactions with a number of soluble salts of other metals to form precipitates of insoluble calcium salts. For example, mixing solutions of calcium chloride with sodium carbonate, sodium tungstate and sodium molybdate solutions precipitates the carbonates, tungstates, and molybdates of calcium, respectively. Similar precipitation reactions occur with carboxylic acids or their soluble salt solutions. CaCb forms calcium sulfide when H2S is passed through its solution. Reaction with sodium borohydride produces calcium borohydride, Ca(BH4)2. It forms several complexes with ammonia. The products may have compositions CaCl2 2NH3, CaCb dNHs, and CaCb SNHs. 

The use of activated anthranihc acid derivatives facUitates the preparation of the amides in those cases where the amines are either umeactive or difficult to obtain. Thus, reaction of (87-1) with phosgene gives the reactive the isatoic anhydride (89-1). Condensation of that with ortho-toluidine leads to the acylation product (89-2) formed with a simultaneous loss of carbon dioxide. This is then converted to the quinazolone (89-3) by heating with acetic anhydride. Reaction with sodium borohydride in the presence of aluminum chloride selectively reduces the double bond to yield the diuretic agent metolazone (89-4) [99]. 

---