Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Binary acids defined

The basicity of the molten carbonate is defined as equal to -log (activity of O ) or -log aM20, where a is the activity of the alkali metal oxide M2O. Based on this definition, acidic oxides are associated with carbonates (e g., K2CO3) that do not dissociate to M2O, and basic oxides are formed with highly dissociated carbonate salts (e.g., U2CO3). The solubility of NiO in binary carbonate melts shows a clear dependence on the acidity/basicity of the melt (18,19). In relatively acidic melts, NiO dissolution can be expressed by... [Pg.136]

This designed construct, as such, may not influence subsequent steps of transamination due to loss of the strong association between the coenzyme and the synthetic peptide after amino acid binding. However, the selectivity of the peptide for pyridoxal phosphate reveals the potential power of peptide design and the importance of secondary binding interactions for defining the formation of specific binary complexes. [Pg.9]

It will be observed that the F, N curves for such binary mixtures follow the same course—a rapid followed by a more gentle rise of F as iV increases to a well defined maximum followed by a drop and an asymptotic fall in the F value. In the case of alcohol water mixtures F ax. is obtained at about 0 3A. To find an adequate explanation for the complete F, N curve is by no means an easy matter. It is clear that the first portion of the curve may be taken to represent an increasing surface concentration of alcohol and this proceeds to a limiting value—an observation first made by Milner (Phil. Mag. xill. 96, 1907), who showed that for relatively strong solutions of acetic acid the surface tension of the solutions could be expressed as a function of the concentration of the acetic acid in the following form ... [Pg.41]

In a similar approach, a pretuned glass encased microchip set to emit a unique binary code is placed in a polypropylene tea bag loaded with polystyrene beads. Using a modified split synthesis approach, a 125-membered tripeptide library N-capped as the /r-carboxy-cinnamic acid amide was prepared on Rink resin. Each porous reactor contained a radio frequency transporter which successfully defined the structure of two inhibitors of protein tyrosine phosphatase [37],... [Pg.295]

In the following, the strategy presented before will this time be applied for developing a process for the esterification of lauric acid with methanol. All the thermodynamic data for pure components and binary mixtures are available in Aspen Plus. A residue curve map of the reactive mixture at equilibrium can be computed as described in Appendix A. A useful representation can be done in reduced coordinates defined by Xx = water + add and X2 = add + ester. The diagram displayed... [Pg.251]

These deviations were accounted by Strey et al.,8 who carried out experiments with the binary water—C12E5 system, by noting that the amplitude of the thermal undulations increased with the repeat distance d. If one considers the total area of the interface a constants which depends only on the number of surfactant molecules, the projection So of the total area on a plane perpendicular to d will decrease with increasing d. Hence, the apparent area per surfactant molecule, which is defined as the ratio between So and the total number of surfactant molecules, decreases with increasing d, while the ideal dilution law implies that the apparent area per surfactant molecule is a constant. The excess area, defined as AS = S — So, was related to the bending modulus of the interface,8 and the experimental results for the deviations from the ideal dilution law were used to determine. Kc-3,11 However, it should be noted that there are binary systems for which the deviations from the ideal dilution law occur in the opposite directions. For instance, in the binary systems of fatty acid alkali soaps/water, the apparent area per headgroup increases with water dilution, because of the incorporation of water in the interface.1... [Pg.314]

To answer this question one must think in terms of fundamental thermodynamic principles. Thus, it can be expected that the reaction between a strong acid and a strong base should be highly exothermic (releasing a lot of heat), while that between a weak acid and a weak base is little exothermic. If a constant a is defined as a measure of the tendency of a binary oxide to accept an O2- ion (i.e., its acidity in terms of Lux and Flood), it would be reasonable to expect that for a reaction between an acidic oxide, A, and a basic oxide, B, the A B of the reaction between A and B to produce an oxysalt, C (i.e., A + B = C), is proportional to their difference in acidity. [Pg.24]

Advantages and disadvantages of the titration technique are discussed in detail elsewhere(26) It suffices here to state that the surface acid group distributions on the white reference solids are sufficiently well defined by the experiment to provide a gauge by which to measure the interaction of carbon black with the white solids in binary mixtures. [Pg.202]

Finally, carbamazepine tetracarboxylic acid-adamantane [115] represents one of the few examples of clearly defined and predictable 3-D motif observed in a hydrogen-bond-based binary co-crystal. [Pg.225]

More recently, flow titrations have been implemented in multi-commuted flow systems. With these systems, the exact amounts of the solutions involved can be modified in real time according to a concentration-oriented feedback mechanism. The flow titration really mimics a true titration because an analytical curve is not needed. A flow system exploiting a binary search to define the end point of an acid—base titration [324] is a good example of this approach. Stream directing solenoid valves were used to modify the sample and titrant volumes after every measurement via a feedback mechanism. Samples with concentrations within a range of two orders of magnitude could be titrated without modifying the flow manifold. [Pg.401]

Oxides can be defined as binary compounds formed between various elements and oxygen, while phosphates can be defined as salts based formally on phosphorus (V) oxoacids and in particular salts of phosphoric (V) acid, H3PO4. Both oxides and phosphates are among the most important classes of inorganic compounds. For example, silicon dioxide (Si02) is the main compound in the Earth s crust, and apatite, a complex mineral form of calcium phosphate, Ca5(P04)3 (OH, F, Cl) is the main compound on the enamel of teeth [1-3],... [Pg.2]

Many binary, ternary and quaternary mixtures of these acids were also examined and it was found that the viscosity of these mixtures fall/on the same line as that of the components, provicpd that an average chain length is defined... [Pg.352]


See other pages where Binary acids defined is mentioned: [Pg.31]    [Pg.31]    [Pg.661]    [Pg.213]    [Pg.413]    [Pg.406]    [Pg.132]    [Pg.233]    [Pg.118]    [Pg.103]    [Pg.316]    [Pg.72]    [Pg.843]    [Pg.5]    [Pg.197]    [Pg.220]    [Pg.48]    [Pg.130]    [Pg.645]    [Pg.106]    [Pg.354]    [Pg.360]    [Pg.113]    [Pg.119]    [Pg.392]    [Pg.106]    [Pg.65]    [Pg.237]    [Pg.144]    [Pg.110]   
See also in sourсe #XX -- [ Pg.144 ]




SEARCH



Acids defined

© 2024 chempedia.info