Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Benzene hexyl

The solutes were benzene, ethyl benzene, butyl benzene, hexyl benzene, octyl benzene and decyl benzene and it is seen that the silica could easily resolve any two solute pairs having a difference of only two methylene groups. In fact, solutes having only one methylene group difference would have been discerned as two peaks. The disadvantage of the system can be seen from the time scale. The separation took over 10 hours to complete and this extensive time period was necessary even when using the maximum inlet pressure available of 6,000 p.s.i. [Pg.37]

Prepare a Grignard reagent from 24 -5 g. of magnesium turnings, 179 g. (157 ml.) of n-heptyl bromide (Section 111,37), and 300 ml. of di-n-butyl ether (1). Cool the solution to 0° and, with vigorous stirring, add an excess of ethylene oxide. Maintain the temperature at 0° for 1 hour after the ethylene oxide has been introduced, then allow the temperature to rise to 40° and maintain the mixture at this temperature for 1 hour. Finally heat the mixture on a water bath for 2 hours. Decompose the addition product and isolate the alcohol according to the procedure for n-hexyl alcohol (Section 111,18) the addition of benzene is unnecessary. Collect the n-nonyl alcohol at 95-100°/12 mm. The yield is 95 g. [Pg.254]

Carbamic acid, hexyl-, methyl ester, 40 CARBODIIMIDF, POLYMERIC [BENZENE, DIETHENYL-, POLYMER WITH ETHF.NYLBFNZFNE, [[[(<1-METHYLETHYL)IMINO ] METHYLENE] AMINO] METHYL] DERIV.],... [Pg.139]

Using other alkylated benzene hydrocarbons, e.g., amyl-, hexyl-, octyl-, or nonylbenzene, similar surface-active phosphinic acids are formed by reaction with PC13 in the presence of anhydrous aluminum trichloride. The resulting alkylarylphosphinic acids form stable salts with primary, secondary, or tertiary hydroxy amines or aromatic amines [166,171]. [Pg.587]

Ethyl benzene Ethyl bromide 2-Ethyl butyl acrylate Ethyl chloride Ethyl ether Ethyl formate 2-Ethyl hexyl acrylate Ethyl iodide Ethyl propionate Ethyl propyl ether Ethyl sulfide Ethylene bromide Ethylene chloride Ethylene glycol Ethylidebe chloride Fluorobenzene Formic acid Freon-11 Freon-12 Freon-21 Freon-22 Freon-113 Glycerol, 100%... [Pg.484]

Example The base peak in the El mass spectrum of (3-methylpentyl)-benzene is formed by McLafferty rearrangement of the molecular ion (Fig. 6.28). As long as pentene loss may occur, there is not much difference to spectra of other isomers such as 2-methylpentyl-, 4-methylpentyl, or n-hexyl. Reference spectra are needed to distinguish those isomers, because differences are mainly due to peak intensities, whereas only minor peaks might appear or vanish depending on the isomer. [Pg.271]

Benzene, 1, 3-Bis (l,l-dimethylethyl)-5-methyl-2,4,6-trinitro Benzene, 3-(l,l-dimethylethyl)-l-fluoro-5-methyl-2, 4, 6-trinitro Benzene, 2-hexyl-4-methyl-l, 3, 5- trinitro Benzene, 2-methyM- (l-methylethyl)-l, 3, 5-trinitro Benzene, l-(l,l-dimethylethyl)-2-ethoxy-3, 5-dinitro Benzene, l-(l,l-dimethylethyl)-2-ethoxy-4 ethyl 3, 5-dinitro Benzene, l-(l,l-dimethylpropyl)-4 ethyl-2-methoxy- 3, 5-dinitro Benzene, 1,3-Bis (l,l-dimethylethyl)-4-methoxy-6-methyl-2,... [Pg.409]

In another paper from the Jackson Laboratories of the du Pont Company (Calcott et al., 34) there is reported a repetition of some of the reactions of Simons and Archer, as well as additional ones. Mono-, di-, and 1,2,4,5 tetraisopropylbenzene were obtained from propylene and benzene both l -chloro-i-butylbenzene and di-(l/-chloro)-d-butylben-zene were obtained from 3-chloro-2-methyl-propene-l and benzene p-f-butyltoluene and di-i-butyltoluene were obtained from diisobutylene and toluene tetraisopropylnaphthalene was obtained from propylene and naphthalene naphthyl-stearic acid was obtained from oleic acid and naphthalene mixed isopropyltetrahydronaphthalene was obtained from propylene and tetrahydronaphthalene 2,4,6-triisopropylphenol was obtained from propylene and phenol a mixture of monoisopropylated m-cresols was obtained from propylene and wi-cresol and di-(s-hexyl)-diphenyl oxide was obtained from hexene-3 and diphenyl oxide. [Pg.210]

HEXYLS. Designation for 2,4,6-Trinitro-tris (alkylnitramino) benzenes, to be described under Nitramines... [Pg.95]

UDMH is known to be miscible with the following wafer, benzene, triethyl benzene, toluene, kerosene, ethyl alcohol, isobutyl alcohol, n-butyl ether, n-amyl ether, n-hexyl ether, diethyl ether, petroleum ether, petroleum naphtha, n-heptane, n-hexane, n-octane, n-decane, n-dodecane, n-hexadecane, cyclohexane, 1,2-dimethyl cyclohexane, phenyl cyclohexane, n-tetradecane, trichloroethylene, dichloroethylene, perchloroethylene, 1,1,1-trichloroethane, triethyl amine, ethylenediamine, diethylene triamine, acetonitrile, aniline, cumene, tetra-hydronaphthalene, tetraethylene pentamine, ethylene glycol and hydrazine (Ref 4)... [Pg.203]

Letcher, T.M. and Reddy, R, Ternary liquid-liquid equilibria for mixtures of l-hexyl-3-methylimidazolium (tetrafluoroborate or hexafluoroborate) + benzene + an alkane at T = 298.2 K and 1 atm, /. Chem. Thermodyn., 37, 415,2005. [Pg.68]

I, //-hexane 2. benzene 3, pyridine 4, acetone 5, diethyl ether 6, ethyl acetate 7, nitromethane 8, methyl alcohol 9, n-hexyl alcohol 10. bromine 11. 50% chromic acid 12, Nain liq. NR, 13, stannic chloride 14, sulfur chloride. [Pg.85]

The synthesis of penams has been reported to be conveniently prepared from Meldrum s acid [55] and thiazoline [56]. The substrates were reacted in dry benzene containing dry HC1 (gas) at reflux to afford a series of penam derivatives with aryl, n-hexyl. and cyclohexyl substituents (Scheme 9), [57]. [Pg.109]

Table 4. Micellar parameters in benzene and carbontetrachloride. BAP (butyl-), HAP (hexyl-), OAP (octyl-), DeAP(decyl-), DAP (dodecyl-) ammonium propionates. [Faraday Trans. I, 68, 280 (1973))... Table 4. Micellar parameters in benzene and carbontetrachloride. BAP (butyl-), HAP (hexyl-), OAP (octyl-), DeAP(decyl-), DAP (dodecyl-) ammonium propionates. [Faraday Trans. I, 68, 280 (1973))...
Methanol, Chem. Lett., 1913-1916. e) Toda, F., Kai, A., Yagi, M., and Mak, T. C. W. (1987) Inclusion Properties of the New Host Compound 1,2,4,5-Tetra- (morpholinocarbonyl)benzene and X-Ray Crystal Structure of Its 1 4 Complex with Water, Chem. Lett., 1025-1028. f) Toda, F., Kai, A., Tagami, Y., and Mak, T. C. W. (1987) A Novel Host Compound with High Inclusion Ability, N,N,N,/V-Tetracyclo- hexyl-2,2 -biphenyldicarboxamide, and Crystal Structure oflts 1 1 Phenol Complex, Chem. Lett., 1393-1396. [Pg.44]

The characteristics of the water pool of reverse micelles has been explored by H, 23Na, 13C, 3IP-NMR spectroscopy. Since the initial association process in RMs is not totally understood, and because of the low CMC, aggregation studies from NMR are rather scarce. Direct determination of a CMC in the diethyl hexyl phosphate /water/benzene system (at Wo = 3.5) was possible because the chemical shift of 31P in phosphate groups is very sensitive to hydration effects. The structure and state of water in RMs and particularly at low water content has received considerable attention. The proton chemical shifts have been explored in AOT/water/heptane, methanol, chloroform, isooctane and cyclohexanone. The water behavior in small reverse micelles is close to that of the corresponding bulk ionic solution. Until now, the effect of a solute on micellar structure was not well... [Pg.78]

Endres et al. [82] have demonstrated the suitability of an air- and water-stable ionic liquid for the electropolymerization of benzene. This synthesis is normally restricted to media such as concentrated sulfuric acid, liquid SO2 or liquid HF as the solution must be completely anhydrous. The ionic liquid used, l-hexyl-3-methylimidazolium tris(pentafluoroethyl)trifluorophosphate, can be dried to below 3 ppm water, and this ionic liquid is also exceptionally stable, particularly in the anodic regime. Using this ionic liquid, poly(para-phenylene) was successfully deposited onto platinum as a coherent, electroactive film. Electrochemical quartz crystal microbalance techniques were also used to study the deposition and redox behavior of the polymer from this ionic liquid (Section 7.4.1) [83]. [Pg.191]

Alkylbenzene Linear alkylb (saturated) Branched alkylb (saturated) Linear alkylb (unsaturated) Alkylphenyl (branched) Polyoxypropylene Polysiloxane Linear dodecyl-benzene n-dodecyl 2-ethyl hexyl Oleyl Nonylphenyl CH3(CH2)5CH(C6H4)(CH2)4CH3a CH3(CH2)10CH2-CH3(CH2)3CH—ch2—(CH2CH3) (c/s-)CH3(CH2)7=CH(CH2)CH2-C9H 9(br inclied isomers)C6H4 — [OCH2CH(CH3)l — (CH3)3Si[OSi(CH3)l OSi(CH3)3 I... [Pg.3]


See other pages where Benzene hexyl is mentioned: [Pg.107]    [Pg.51]    [Pg.1502]    [Pg.118]    [Pg.882]    [Pg.107]    [Pg.51]    [Pg.1502]    [Pg.118]    [Pg.882]    [Pg.253]    [Pg.309]    [Pg.55]    [Pg.334]    [Pg.478]    [Pg.478]    [Pg.253]    [Pg.317]    [Pg.48]    [Pg.170]    [Pg.285]    [Pg.556]    [Pg.80]    [Pg.232]    [Pg.210]    [Pg.62]    [Pg.253]    [Pg.130]    [Pg.250]    [Pg.6]    [Pg.831]    [Pg.133]    [Pg.468]    [Pg.381]    [Pg.253]    [Pg.382]   
See also in sourсe #XX -- [ Pg.919 ]




SEARCH



Hexyl

© 2024 chempedia.info