Aqueous solutions injectable

Studies in rats have shown that polyvinyl alcohol 5% w/v aqueous solution injected subcutaneously can cause anemia and infiltrate various organs and tissues. " ... 

Sample preparation Prepare an aqueous solution, inject a 200 p,L aliquot. 

Aqueous solutions of ammonium nitrate and a decomposition initiator (sodium nitrite) were injected through separate passages. The aqueous solutions injected into well no. 1242 contained 4 tonnes of the nitrate and 2 tonnes of the initiator. The performance of temperature and pressure sensors was checked in different pH solutions while a nitrate decomposition reaction was taking place in the bore-... 

SPME has been utilized for deterrnination of pollutants in aqueous solution by the adsorption of analyte onto stationary-phase coated fused-siUca fibers, followed by thermal desorption in the injection system of a capillary gas chromatograph (34). EuU automation can be achieved using an autosampler. Eiber coated with 7- and 100-p.m film thickness and a nitrogen—phosphoms flame thermionic detector were used to evaluate the adsorption and desorption of four j -triazines. The gc peaks resulting from desorption of fibers were shown to be comparable to those obtained using manual injection. 

Riboflavin is widely used in the pharmaceutical, food-enrichment, and feed-supplement industries. Riboflavin USP is adininistered orally in tablets or by injection as an aqueous solution, which may contain nicotinamide or other solubilizers. As a supplement to animal feeds, riboflavin is usually added at concentrations of 2—8 mg/kg, depending on the species and age of the animal (see Feeds AND FEED ADDITIVES). 

A flow-injection system with electrochemical hydride generation and atomic absorption detection for the determination of arsenic is described. This technique has been developed in order to avoid the use sodium tetrahydroborate, which is capable of introducing contamination. The sodium tetrahydroborate (NaBH ) - acid reduction technique has been widely used for hydride generation (HG) in atomic spectrometric analyses. However, this technique has certain disadvantages. The NaBH is capable of introducing contamination, is expensive and the aqueous solution is unstable and has to be prepared freshly each working day. In addition, the process is sensitive to interferences from coexisting ions. 

Columns can be washed with solvents and solvent combinations suitable to remove adsorbed contaminants. When considering the adsorption of analytes, think not only of the diol functionality, but also of the adsorption to residual silanols. Often, the injection of small amounts (500 /d) of dimethyl sulfoxide removes contamination that has accumulated on the column. Aqueous solutions of sodium dodecyl sulfate, guanidine hydrochloride, or urea are compatible with Protein-Pak columns. 

Antimony is a metal, in either hydrocarbon or aqueous solution, commonly injected into the fresh feed to passivate nickel. 

Aqueous solutions introduced into the bloodstream by injection must have the same osmotic pressure as blood that is, they must be isotonic with blood. At 25°C, the average osmotic pressure ofblood is 7.7 atm. What... 

To measure the volume of the blood in an animal s circulatory system, the following experiment was performed. A 5.0-mL sample of an aqueous solution containing 1.7 X 105 counts per minute (cpm) of tritium was injected into the bloodstream. After an adequate period of time to allow for the complete circulation of the tritium, a 5.0-mL sample of blood was withdrawn and found to have 1.3 X 103 cpm on the scintillation counter. Assuming that only a negligible amount of tritium has decayed during the experiment, what is the volume of the animals circulatory system ... 

The ion pair extraction by flow injection analysis (FIA) has been used to analyze sodium dodecyl sulfate and sodium dodecyl ether (3 EO) sulfate among other anionic surfactants. The solvating agent was methanol and the phase-separating system was designed with a PTFE porous membrane permeable to chloroform but impermeable to the aqueous solution. The method is applicable to concentrations up to 1.25 mM with a detection limit of 15 pM [304]. 

This section deals with the experimental determination of the rate of oil solubilization in aqueous solutions of AOS and IOS [70]. The experimental method [71] consists of injecting 25 pi of n-hexadecane (containing 5 wt % Dobanol 45-3 as an emulsifier) into 50 ml water this produces a turbid macroemulsion upon vigorous stirring. At the start of the experiment, a concentrated solution of the surfactant under test is injected and the decrease in turbidity is followed with a photometer. The time elapsed to reach 90% of the initial turbidity is recorded (t ) and the pseudo rate constant of oil solubilization is calculated from... 

Solubilizing activity are also used in enhanced oil recovery. Tar and extremely viscous hydrocarbons are recovered by the injection of an aqueous solution of an anionic orthophosphate ester surfactant into a petroleum formation, retaining the surfactant in the formation for about 24 h, and displacing the solubilized hydrocarbons toward a recovery well. The surfactant forms an oil microemulsion with the hydrocarbons in the formation. An anionic monoorthophosphate ester surfactant which is a free acid of an organic phosphate ester was dissolved in water. The input of surfactant solution was 2-25% of the pore volume of the formation [250]. To produce a concentrate for the manufacture... 

Epinephrine is an inherently unstable chemical in aqueous solution, even at a low pH and in the presence of an antioxidant such as sodium metabisulfite, up to 1 mg/ ml. With the passage of time, the epinephrine dose gradually decreases due to degradation into inactive compounds. If the expiry date has passed, the epinephrine dose correlates inversely with the number of months or years past that date, and will likely be lower than the dose stated on the label even if the solution appears clear and colorless. Nevertheless, if this is the only source of epinephrine available for injection, it should be used in preference to not administering epinephrine at all [32]. 

The concentration of the aqueous solution of palytoxin given to the dogs and monkeys was 5.6 A g/tnL, and was injected directly into the exposed femoral vein of each animal. 

Most injections are formulated as aqueous solutions, with Water for Injections BP as the vehicle. The formulation of injections depends upon several factors, namely the aqueous solubility of the active ingredient, the dose to be employed, thermal stability of the solution, the route of injection and whether the product is to be prepared as a multidose one (i.e. with a dose or doses removed on different occasions) or in a singledose form (as the term suggests, only one dose is contained in the injection). Nowadays, most injections are prepared as single-dose forms and this is mandatory for certain routes, e.g. spinal injections such as the intrathecal route and large-volume intravenous infusions (section 2.2). Multidose injections may require the inclusion of a suitable... 

The ammonia is either injected as pure ammonia under pressure or in an aqueous solution at atmospheric pressure. Instead of ammonia, urea can also be used. The challenge of the process is to efficiently remove as much NOx as possible at full conversion of the reductant, as emission of NH3 from the SCR reactor would of course be highly undesirable. 

---