Ammonium economic importance

Sewage treatment has both ecological and economical importance. Ammonium and phosphate ions are the primary inorganic contaminants in municipal wastewater and these ionic compounds are responsible for the phenomenon of eutrophication. In common sewage treatment, ammonium is removed by biological denitrification and phosphates are precipitated with the help of aluminum and iron salts [56], However, the use of low-cost natural zeolites has been found promising for... 

An appreciable amount of NH3 volatilizes from soil. In some fields, up to 50% of the added ammonium-N volatilizes. In addition to the economic importance of this nitrogen loss, there is also environmental importance. In industrialized regions of the world, NH3 in the atmosphere approaches concentrations high enough to cause toxicity effects on forests. 

If the cations are hydrogen ions (see Section 3.2.4.), guest molecules may add to them to give, for example, hydronium, ammonium, oxonium, or carbenium cations. The latter two may rearrange, and then decompose or dissociate to give product(s) which can leave the zeolite. Oxonium ions in particular are central to the most economically important processes of petrochemical industry. In simpler words, hydrogen zeolites are very important catalysts. 

Although NF3 has been known since 1928, it first became of commercial interest in the late 1950s. Only two processes are of technical and economic importance for the large-scale production of NF3 (1) the electrolysis of molten ammonium hydrogen difluoride, and (2) the direct fluorination of ammonia in the presence of molten ammonium hydrogen difluoride. The electrolytic process has also been recommended and widely used for the preparation of NF3 in the laboratory. 

Phosphate-polymer control, in industrial water treatment, 26 132-133 Phosphate recognition, 16 794 Phosphate refractory dental dies, compressive strength, 8 289t Phosphate rock, 11 119, 120 minerals in, 19 5, 14 recovery of fluoride from, 14 12-13 U.S. imports for consumption of, 19 15t U.S. production of, 19 17 Phosphates, 18 814-863 19 19. See also Phosphate Polyphosphates aluminum acid, 18 839 ammonium, 11 487 18 835-836 analysis of, 18 851-852 calcium, 18 836-839 condensed, 18 841-852 crystalline, 18 839 dispersants, 8 710t economic aspects of, 18 859-860... 

There is extensive research ongoing for new synthesis processes which are economically favourable due to less expensive reactants or easier processes. One very important point is the avoidance of the production of a large amount of ammonium sulfate, which can be achieved by the prevention of the formation of any salt or by the replacement of ammonium sulfate by another ammonium salt with increased economical value. Recently, studies of Beckmann rearrangement of cyclohexanone oxime in friendly enviionment conditions have received special attention . ... 

Borazine, B3N3H6, was first prepared by thermolysis of the diborane ammonia adduct [(BH2)(NH3)2] [BH4] . More convenient procedures for the laboratory preparation of this important ring system in multigram quantities involve either (a) the decomposition of ammonia- borane [eqn (9.1)] or (b) the reaction between ammonium sulfate and sodium borohydride [eqn (9.2)]. The latter method provides a convenient and economical synthesis of borazine. 

Finally, one of the first continuous ion-exchange plants installed used a weak-acid resin to recover copper from rayon-fibre spinning solutions. In the Bemberg or copper(II) ammonium process,357 the spinning takes place in an addic copper sulfate solution, and the fibre is then washed in ammonia solution. The wash water contains as much as 30% of the copper required for the spinning operation and its recovery is important in economic and environmental terms. The copper is extracted as the cationic amine complex by the weak-acid resin, and is then stripped from the resin with the acidic spinning solution. Zinc is recovered in a similar manner from vicrose rayon-spinning operations. 

The other important aspect of the development of the succinic acid market is the chemical conversion of succinic acid to other products. Selective and low-cost catalyst development is needed to enable lower-cost economics. The chemistry of succinic acid catalysis has been reviewed by Varadarajan and Miller (1999), and the summary of the various derived products that follow is from that work. Succinic acid can be readily converted into alkyl esters that have uses as industrial solvents and paint removers. Succinic acid, its anhydride or its esters, can be hydrogenated to the product family of 1,4-butanediol however, this conversion has not been as well studied as the hydrogenation of maleic acid or anhydride. A third important product family that can be derived from ammonium succinate, succinimide, or succinic acid is based on 2-pyrroHdinones. They are used for polyvinylpyrrolidone (PVP) production, which has an estimated minimum market value of 150 million per year. Other uses for 2-pyrrolidinones include solvents and plasticizers. The commercial production depends upon petrochemical-based... 

---