Alkyl dibromides

In an analogous manner, the selectively obtained exo mono-benzylated isosorbide [58] was alkylated by reaction with alkyl dibromides to afford new ethers from dian-hydrohexitols moieties separated by ether functions (Eq. 39 and Tab. 5.16) [59]. 

The immobilization of an active species into a conducting polymer layer allows one to obtain active electrodes for the reduction of various organic halides. Polypyrrole containing viologen electrodes appear to be active for the reduction of alkyl dibromide [177] or hexachloroacetone [178], Cobalt-bipyridyl-polypyrrole films are active electrodes for the reduction of alkyl chloride [107], The mechanism of this reaction is similar to that observed in the homogeneous phase. This confinns one of the major interests of the modified conductive polymer electrodes, i,e. the possibility of performing catalytic reactions with smaller amounts of active catalyst in comparison to homogeneous catalysis, and then to avoid problems related to the separation of products from the solution which contains this catalyst. 

The synthesis of linear polyethers from either isosorbide or isoidide and alkyl dibromides or dimethanesulfonates using microwave irradiation under solid-liquid PTC conditions was described by Loupy et al. (Scheme 14.19) [47, 48]. 

Coche, L., Deronzier, A., and Moutet, J. C., An attempt al the preparative alkyl dibromide reduction using electrodes coated by a polypyrrole film containing the viologen (4,4 -bipyridinium) system, J. Electroanal. Chem., 198, 187-193 (1986). Grimshaw, J., and Perera, S. D., Redox behaviour of a polypyrrole modified electrode where the pyrrole has N-substituted 9-cyanoanthracene groups, J. Electroanal. Chem., 265, 335-339 (1989). 

Polymer-modified electrodes were used for alkyl dibromide reduction (Eq. 14)) 86-88)... 

In the absence of inserted metal particles, other electrocatalytic reactions such as the reduction of alkyl dibromide from poly(3) could be performed [200]. Nevertheless, inhibition of the catalytic activity caused by a loss of the film permeability was observed. 

B. A. Frontana-Uribe and J. Heinze. 2006. Efficient route for the synthesis of 3,4-cycloalkoxy-2,5-diethoxycarbonyl-thiophenes obtained with bulky alkyl dibromides using trialkylamines as base-solvent. Tetrahedron Lett 47(27) 4635-4640. 

Place a mixture of 0-5 g. of finely powdered thiourea, 0-5 g. of the alkyl halide and 5 ml. of alcohol in a test-tube or small flask equipped with a reflux condenser. Reflux the mixture for a j)eriod depending upon the nature of the halide primary alkyl bromides and iodides, 10-20 minutes (according to the molecular weight) secondary alkyl bromides or iodides, 2-3 hours alkyl chlorides, 3-5 hours polymethy lene dibromides or di-iodides, 20-50 minutes. Then add 0 5 g. of picric acid, boil until a clear solution is obtained, and cool. If no precipitate is obtained, add a few drops of water. RecrystaUise the resulting S-alkyl-iso-thiuronium picrate from alcohol. 

Addition. Addition reactions of ethylene have considerable importance and lead to the production of ethylene dichloride, ethylene dibromide, and ethyl chloride by halogenation—hydrohalogenation ethylbenzene, ethyltoluene, and aluminum alkyls by alkylation a-olefms by oligomerization ethanol by hydration and propionaldehyde by hydroformylation. 

Triphenyl phosphine dibromide [1034-39-5] M 422.1, m 23.5 , 245-255 (dec). Recrystd from MeCN-Et20. Although it has been recrystd from EtOH, this is not recommended as it converts alcohols to alkyl bromides. It deteriorates on keeping and it is best to prepare it afresh. [Anderson and Freenor J Am Chem Soc 86 5037 1964 Homer et al. Justus Liebigs Ann Chem 626 26 1959.]... 

The alkylation of 3-methyl-2-cyclohexenone with several dibromides led to the products shown below. Discuss the course of each reaction and suggest an explanation for the dependence of the product structure on the identity of the dihalide. 

The most demanding test of cesium carbonate as base was with 2,3-dihydroxypyridine (3-hydroxypyridone). The cesium salt was found to be fairly unstable, apparently oxidizing quite rapidly. Model reactions suggested that alkylation would occur 1,3 (N, 0) to give the substituted pyridone. Nevertheless, on the basis of UV and H-nmr analysis, the product of reaction between 2,3-dihydroxypyridine and tetraethylene glycol dibromide was assigned as the pyridocrown (23% yield, mp 77—78.5°) as shown in Eq. (3.60). 

In the early 1930 s, when the prime research aim was the commercial synthesis of the sex hormones (whose structures had just been elucidated), the principal raw material available was cholesterol extracted from the spinal cord or brain of cattle or from sheep wool grease. This sterol (as its 3-acetate 5,6-dibromide) was subjected to a rather drastic chromic acid oxidation, which produced a variety of acidic, ketonic and hydroxylated products derived mainly by attack on the alkyl side-chain. The principal ketonic material, 3j -hydroxyandrost-5-en-17-one, was obtained in yields of only about 7% another useful ketone, 3 -hydroxypregn-5-en-20-one (pregnenolone) was obtained in much lower yield. The chief acidic product was 3j -hydroxy-androst-5-ene-17j -carboxylic acid. All three of these materials were then further converted by various chemical transformations into steroid hormones and synthetic analogs ... 

Cyclization of the two pendant alkyl side chains on barbiturates to form a spiran is consistent with sedative-hypnotic activity. The synthesis of this most complex barbiturate starts by alkylation of ethyl acetoacetate with 2-chloropentan-3-one to give 152. Hydrolysis and decarboxylation under acidic conditions gives the diketone, 153. This intermediate is then reduced to the diol (154), and that is converted to the dibromide (155) by means of hydrogen bromide. Double Internal alkylation of ethyl... 

A not uncommon side effect observed with morphine and some of the other narcotic analgesics is constipation due to decreased motility of the gastrointestinal tract. It proved possible to so modify pethidine as to retain the side effect at the expense of analgesic activity. Relief of diarrhea, it will be realized, is a far from trivial indication. Alkylation of the anion from diphenylacetonitrile (95) with ethylene dibromide gives the intermediate, 96. Alkylation of normeperidine (81) with that halide... 

Finally the aminoquinoline bearing a primary amine at the terminal carbon atom of the side chain is itself an effective antimalarial drug. Ring opening of 2-methyltetrahydrofuran by bromine gives the dibromide, 99. The primary halide is sufficiently less hindered so that reaction with potassium phthalimide affords exclusively the product of displacement of that halogen (100). Alkylation of the aminoquinoline with lOO affords the secondary amine, 101. Removal of the phthalimide group by means of hydrazine yields primaquine (102). ... 

TolyIsulfonyl)dihydroisoindole has been prepared by alkylation of /Moluenesulfonamide with o-xylylene dibromide in the presence of sodium methoxide in ethanol.2 3... 

Ji-Toldaldehyde, 2-bromo-, 46,13 />-ToJuenesult onamide, alkylation with o-xylylene dibromide, 47, 111 -Toluenesulfonvlbromide, 45, 88 -Toluenesulfonyl chloride m prepara tion of methvl isocyanide, 46,... 

Palladium-mediated catalysis has only been exploited relatively recently in the synthesis of substituted PPV derivatives. The use of aryl dibromides as monomers is particularly useful as it allows the synthesis of PPVs substituted with alkyl rather than alkoxy sidechains. The Suzuki [53, 54], Heck [55], and Stille [56] reactions have been used in the synthesis of new PPV derivatives, but attaining high molecular weight PPV derivatives by these methodologies has proved problematic. A phenyl-subslilutcd PPV material PPPV 31 was synthesized by a Suzuki coupling (Scheme 1-10) of dibromoethene and fo/.v-boronic acid 30. Its absorption (2ni ix=385 nm) and emission (2max=475 nm) maxima were strongly... 

The reduction ofsec-, and /-butyl bromide, of tnins-1,2-dibromocyclohexane and other vicinal dibromides by low oxidation state iron porphyrins has been used as a mechanistic probe for investigating specific details of electron transfer I .v. 5n2 mechanisms, redox catalysis v.v chemical catalysis and inner sphere v.v outer sphere electron transfer processes7 The reaction of reduced iron porphyrins with alkyl-containing supporting electrolytes used in electrochemistry has also been observed, in which the electrolyte (tetraalkyl ammonium ions) can act as the source of the R group in electrogenerated Fe(Por)R. ... 

The cyanohydrin acetonide method has been a valuable tool in natural product synthesis. The first reported demonstration of this strategy was the total synthesis of (-)-roxaticin [29]. In this approach, treatment of cyanohydrin 57 with an excess of the C2-symmetrical dibromide 58 provided 59, without overalkylation (Scheme 6). A second alkylation involving cyanohydrin 60 gave 61 in excellent yield. (-)-Roxaticin was accessed in ca. 10 steps from tetraacetonide 62. 

---