Alcohols reaction mechanisms

In aqueous solution at 100° the change is reversible and equilibrium is reached when 95 per cent, of the ammonium cyanate has changed into urea. Urea is less soluble in water than is ammonium sulphate, hence if the solution is evaporated, urea commences to separate, the equilibrium is disturbed, more ammonium cyanate is converted into urea to maintain the equilibrium and evfflitually the change into urea becomes almost complete. The urea is isolated from the residue by extraction with boiling methyl or ethyl alcohol. The mechanism of the reaction which is generally accepted involves the dissociation of the ammonium cyanate into ammonia and cyanic acid, and the addition of ammonia to the latter ... 

The procedures to be described m the remainder of this chapter use either an alkane or an alcohol as the starting material for preparing an alkyl halide By knowing how to prepare alkyl halides we can better appreciate the material m later chapters where alkyl halides figure prominently m key chemical transformations The preparation of alkyl halides also serves as a focal point to develop the principles of reaction mechanisms... 

Direct oxidation yields biacetyl (2,3-butanedione), a flavorant, or methyl ethyl ketone peroxide, an initiator used in polyester production. Ma.nufa.cture. MEK is predominandy produced by the dehydrogenation of 2-butanol. The reaction mechanism (11—13) and reaction equihbtium (14) have been reported, and the process is in many ways analogous to the production of acetone (qv) from isopropyl alcohol. 

Effect of Structure. The rate at which different alcohols and acids are esterified as weU as the extent of the equiHbrium reaction are dependent on the stmcture of the molecule and types of functional substituents of the alcohols and acids. Specific data on rates of reaction, mechanisms, and extent of reaction are discussed in the foUowing. More details concerning stmctural effects are given in References 6, 13—15. 

The reaction takes place extremely rapidly, and if D2O is present in excess, all the alcohol is converted to ROD. This hydrogen-deuterium exchange can be catalyzed by either acids or bases. If D30 is the catalyst in acid solution and DO the catalyst in base, write reasonable reaction mechanisms for the conversion of ROH to ROD under conditions of (a) acid catalysis and (b) base catalysis. 

FIGURE 25.32 A reaction mechanism for HMGCoA reductase. Two successive NADPH-dependent reductions convert the thioester, HMGCoA, to a primary alcohol. 

We said in Section 17.4 that carboxylic acids are reduced by L1AIH4 to give primary alcohols, but we deferred a discussion of the reaction mechanism at that time. In fact, the reduction is a nucleophilic acyl substitution reaction in which —H replaces -OH to give an aldehyde, which is further reduced to a primary alcohol by nucleophilic addition. The aldehyde intermediate is much more reactive than the starting acid, so it reacts immediately and is not isolated. 

Although the actual reaction mechanism of hydrosilation is not very clear, it is very well established that the important variables include the catalyst type and concentration, structure of the olefinic compound, reaction temperature and the solvent. used 1,4, J). Chloroplatinic acid (H2PtCl6 6 H20) is the most frequently used catalyst, usually in the form of a solution in isopropyl alcohol mixed with a polar solvent, such as diglyme or tetrahydrofuran S2). Other catalysts include rhodium, palladium, ruthenium, nickel and cobalt complexes as well as various organic peroxides, UV and y radiation. The efficiency of the catalyst used usually depends on many factors, including ligands on the platinum, the type and nature of the silane (or siloxane) and the olefinic compound used. For example in the chloroplatinic acid catalyzed hydrosilation of olefinic compounds, the reactivity is often observed to be proportional to the electron density on the alkene. Steric hindrance usually decreases the rate of... 

Fluoboric acid is also an efficacious promoter of cyclic oxo-carbenium ions (Scheme 4.24) bearing an activated double bond which, in the presence of open-chain and cyclic dienes, rapidly undergo a Diels-Alder reaction [91]. Chiral a, -unsaturated ketones bearing a -hydroxy substituents, protected as acetals, react with various dienes in the presence of HBF4, affording Diels-Alder adducts that were isolated as alcohols by hydrolysis of the acetal group by TsOH. Some examples of reactions with isoprene are reported in Table 4.23. The enantios-electivity of the reaction is dependent on the size of the substituent R on the of-carbon high levels of asymmetric induction were observed with R = z-Pr (90 1) and R = t-Bu (150 1) and low levels with R = Me (2.7 1) and R = Ph (3.0 1). Scheme 4.24 shows the postulated reaction mechanism. 

In this section we deal with reactions in which in one step, formally an O-H bond activation, is involved. Although the precise reaction mechanisms have not been elucidated, some of these reactions are considered to proceed by nucleophilic attack of water, an alcohol, etc. to a substrate activated by a transition metal. We choose to emphasize examples coming from our own research activities in this field. 

This chapter compares the reaction of gas-phase methylation of phenol with methanol in basic and in acid catalysis, with the aim of investigating how the transformations occurring on methanol affect the catalytic performance and the reaction mechanism. It is proposed that with the basic catalyst, Mg/Fe/0, the tme alkylating agent is formaldehyde, obtained by dehydrogenation of methanol. Formaldehyde reacts with phenol to yield salicyl alcohol, which rapidly dehydrogenates to salicyladehyde. The latter was isolated in tests made by feeding directly a formalin/phenol aqueous solution. Salicylaldehyde then transforms to o-cresol, the main product of the basic-catalyzed methylation of phenol, likely by means of an intramolecular H-transfer with formaldehyde. With an acid catalyst, H-mordenite, the main products were anisole and cresols moreover, methanol was transformed to alkylaromatics. 

Addition of a proton occurs to give the more-substituted carbocation, so addition is regioselective and in accord with Markovnikov s rule. A more detailed discussion of the reaction mechanism is given in Section 6.2 of Part A. Owing to the strongly acidic and rather vigorous conditions required to effect hydration of most alkenes, these conditions are applicable only to molecules that have no acid-sensitive functional groups. The reaction is occasionally applied to the synthesis of tertiary alcohols. 

The solid base catalysed aldol condensation of acetone was performed over a CsOH/Si02 catalyst using a H2 carrier gas. The products observed were diacetone alcohol, mesityl oxide, phorone, iso-phorone and the hydrogenated product, methyl isobutyl ketone. Deuterium tracer experiments were performed to gain an insight into the reaction mechanism. A mechanism is proposed. 

The reaction mechanism is shown in Figure 4 and is adapted from work by Fiego et al. [9] on the acid catalysed condensation of acetone by basic molecular sieves. The scheme has been modified to include the hydrogenation of mesityl oxide to MIBK. The scheme begins with the self-condensation of acetone to form diacetone alcohol as the primary product. The dehydration of DAA forms mesityl oxide, which undergoes addition of an addition acetone to form phorone that then can cyclise, via a 1,6-Michael addition to produce isophorone. Alternatively, the mesityl oxide can hydrogenate to form MIBK. 

Intramolecular oxonium ylide formation is assumed to initialize the copper-catalyzed transformation of a, (3-epoxy diazomethyl ketones 341 to olefins 342 in the presence of an alcohol 333 . The reaction may be described as an intramolecular oxygen transfer from the epoxide ring to the carbenoid carbon atom, yielding a p,y-unsaturated a-ketoaldehyde which is then acetalized. A detailed reaction mechanism has been proposed. In some cases, the oxonium-ylide pathway gives rise to additional products when the reaction is catalyzed by copper powder. If, on the other hand, diazoketones of type 341 are heated in the presence of olefins (e.g. styrene, cyclohexene, cyclopen-tene, but not isopropenyl acetate or 2,3-dimethyl-2-butene) and palladium(II) acetate, intermolecular cyclopropanation rather than oxonium ylide derived chemistry takes place 334 ). 

Table 6.6 lists some reactions of the electron in water, ammonia, and alcohols. These are not exhaustive, but have been chosen for the sake of analyzing reaction mechanisms. Only three alcohols—methanol, ethanol, and 2-propanol—are included where intercomparison can be effected. On the theoretical side, Marcus (1965a, b) applied his electron transfer concept (Marcus, 1964) to reactions of es. The Russian school simultaneously pursued the topic vigorously (Levich, 1966 Dogonadze et al, 1969 Dogonadze, 1971 Vorotyntsev et al, 1970 see also Schmidt, 1973). Kestner and Logan (1972) pointed out the similarity between the Marcus theory and the theories of the Russian school. The experimental features of eh reactions have been detailed by Hart and Anbar (1970), and a review of various es reactions has been presented by Matheson (1975). Bolton and Freeman (1976) have discussed solvent effects on es reaction rates in water and in alcohols. 

The readsorption and incorporation of reaction products such as 1-alkenes, alcohols, and aldehydes followed by subsequent chain growth is a remarkable property of Fischer-Tropsch (FT) synthesis. Therefore, a large number of co-feeding experiments are discussed in detail in order to contribute to the elucidation of the reaction mechanism. Great interest was focused on co-feeding CH2N2, which on the catalyst surface dissociates to CH2 and dinitrogen. Furthermore, interest was focused on the selectivity of branched hydrocarbons and on the promoter effect of alkali on product distribution. All these effects are discussed in detail on the basis... 

In Fischer-Tropsch synthesis the readsorption and incorporation of 1-alkenes, alcohols, and aldehydes and their subsequent chain growth play an important role on product distribution. Therefore, it is very useful to study these reactions in the presence of co-fed 13C- or 14 C-labeled compounds in an effort to obtain data helpful to elucidate the reaction mechanism. It has been shown that co-feeding of CF12N2, which dissociates toward CF12 and N2 on the catalyst surface, has led to the sound interpretation that the bimodal carbon number distribution is caused by superposition of two incompatible mechanisms. The distribution characterized by the lower growth probability is assigned to the CH2 insertion mechanism. 

The most general and comprehensive reaction mechanism of the 1 1 codimerization has been reported by Cramer (4). The results were based on reaction properties measured in an alcoholic medium under relatively mild conditions. 

---