Adams catalyst, hydrogenation with

Adams catalyst, platinum oxide, Pt02 H20. Produced by fusion of H2PtCl6 with sodium nitrate at 500-550 C and leaching of the cooled melt with water. Stable in air, activated by hydrogen. Used as a hydrogenation catalyst for converting alkenes to alkanes at low pressure and temperature. Often used on Si02... 

For more selective hydrogenations, supported 5—10 wt % palladium on activated carbon is preferred for reductions in which ring hydrogenation is not wanted. Mild conditions, a neutral solvent, and a stoichiometric amount of hydrogen are used to avoid ring hydrogenation. There are also appHcations for 35—40 wt % cobalt on kieselguhr, copper chromite (nonpromoted or promoted with barium), 5—10 wt % platinum on activated carbon, platinum (IV) oxide (Adams catalyst), and rhenium heptasulfide. Alcohol yields can sometimes be increased by the use of nonpolar (nonacidic) solvents and small amounts of bases, such as tertiary amines, which act as catalyst inhibitors. 

Cyanohydrin (52b 5 g mp 160-164°) is dissolved in acetic acid (200 ml) and placed in a 2-liter hydrogenation flask. Adams catalyst (0.75 g) is added (for 100 g cyanohydrin use 7.5 gof catalyst) and the mixture is hydrogenated until the theoretical amount of hydrogen is taken up (477 ml). The catalyst is removed by filtration, the filtrate is transferred to a 600 ml beaker provided with a stirrer and thermometer, treated with water (20 ml) and cooled to 0° (ice-salt). A solution of sodium nitrite (10 g) in water (30 ml) is added dropwise with stirring at 0°. The reaction mixture is then stirred for additional 2 hr at room temperature, treated with water (100 ml) and, after standing overnight, the precipitate is collected by filtration. The product is dissolved in ether (50 ml), the ether solution is washed sequentially... 

Hydrogenation with Adams catalyst took place only with the 6-alkyl derivatives. Dioxohexahydrotriazine itself acted as a catalyst poison (in common with 1,3,5-triazine and cyanuric acid ). Dioxo-tetrahydrotriazine as well as its A-alkyl and 6-alkyl derivatives can be readily hydrogenated by using Raney nickel. ... 

Oxidation of the hexahydro to tetrahydro derivatives was mentioned in connection with the synthesis of 3,5-dioxo-l,2,4-triazines (e.g., Section II,B,2,a). The reverse procedure, hydrogenation of the tetrahydro derivatives, was used with 6-azauracil, 6-azathymine, and their iV-methyl derivatives. With all these compounds hydrogenation proceeds smoothly in the presence of Adams catalyst. Only the hydrogenation of l-methyl-6-azathymine was not successful. ... 

Support for this suggestion comes from many quarters. Reduction of the jS-carboline anhydro-bases with sodium and alcohol or with tin and hydrochloric acid gives the 1,2,3,4-tetrahydro derivatives, as does catalytic reduction over platinum oxide in an alkaline medium. On the other hand, catalytic reduction with platinum oxide in acetic acid results in the formation of the 5,6,7,8-tetrahydro-j3-carbolinium derivatives (see Section III,A,2,a). It should be noted, however, that reduction of pyrido[l,2-6]indazole, in which the dipolar structure 211 is the main contributor to the resonance hybrid, could not be effected with hydrogen in the presence of Adams catalyst. 

To 20 g of the above compound dissolved in 300 ml 95% ethanol In a Parr reaction vessel is added 1.5 g Adams catalyst, platinum dioxide, and the mixture shaken under hydrogen at 50 psi for 1 hour at ambient temperature. The mixture Is then filtered and the ethanol removed on a standard rotary evaporator. The resulting oil is dissolved in 200 ml ether and slowly added to 1,200 ml ether with continuous stirring. The product separates as crystals which are removed after 15 to 30 minutes by filtration. The compound melts at 148°C to 147°C and needs no further purification. 

Thus, all five triple bonds in decamethyl[5]pericycline 3 can be completely hydrogenated to yield the corresponding saturated cyclic hydrocarbon 78 under platinum catalysis (Pt02, Adam s catalyst), albeit with some difficulty (Fig. 6). 

Direct hydrogenation of key intermediate 248 over the Adams catalyst and subsequent lithium aluminum hydride reduction yielded the two stereoisomeric alcohols 256 and 257, which were separately transformed to ( )-corynantheal (258) and ( )-3-epicorynantheal (259), respectively, by Moffatt oxidation, followed by Wittig reaction with methyltriphenylphosphonium bromide and, finally, by demasking the aldehyde function (151, 152). 

Reflux 6.9 g triphenylphosphine and 6.6 g lauryl bromide (or equimolar amount of homolog) in 40 ml xylene for 60 hours. Remove solvent and wash residue with 5X20 ml ether (by decanting) to get 11 g lauryl triphenylphosphonium bromide (I). To a stirred suspension of 5.6 g (0.011M)(I) in 50 ml ether add 0.01M butyllithium solution (see Organic Reactions 8,258(1954) for preparation). Stir Vz hour at room temperature and slowly add 1.66 g 3,5-dimethoxybenzaldehyde (preparation given elsewhere here) in 10 ml ether over Vi hour. After 15 hours, filter, wash filtrate with water and dry, evaporate in vacuum. Dilute residue with pentane, filter and remove solvent. Dissolve the residual oil in 25 ml ethyl acetate and hydrogenate over O.lg Adams catalyst at one atmosphere and room temperature for 2 hours. Filter and evaporate in vacuum to get the 5-alkylresorcinol dimethyl ether which can be reciystallized from pentane and demethylated as described elsewhere here. 

The selectivity in favor of the desired monobenzylated product was found to be >99% and the immobilized Pt02 was found to be 4-5 times more active than the commercial Adams catalysts. In solution or in immobilized form, the PtOz colloid is effective in the hydrogenation of carbonyl compounds or of olefins. Recently, the heterogeneous catalytic amination of aryl bromides by immobilized Pd(0) particles has been reported [163], Secondary amines such as piperidine and diethyl amine are used in the amination of aryl bromides and the reaction proceeds with good turnover numbers and regio-control. The catalysts can be reused repeatedly without loss of activity or selectivity after filtration from the reaction mixture. 

Carbon reacts also with other sulfur-containing compounds with resulting fixation of sulfur. Reaction of various forms of carbon with hydrogen sulfide was reported by Baraniecky, Riley, and Streeter (126) and by Polansky, Knapp, and Kinney (128). The reaction of carbon blacks with hydrogen sulfide and with sulfur was studied extensively by Studebaker (86). At 150°, the increase in sulfur content was proportional to the quinone content as measured by catalytic hydrogenation using Adams catalyst (see page 203). 

Conversion of the keto ketoxime 1 to the exo-exo-amino alcohol 2 has been accomplished by hydrogenation over Adams catalyst and by reduction with lithium aluminum hydride. Amino alcohol 2 has also been prepared from 1 by a two-stage process in which selective reduction of the ketone is carried out with sodium borohydride, and the resultant hydroxy oxime is reduced with lithium aluminum hydride or by hydrogenation over Adams catalyst. ... 

It is well established that oxygen in the presence of platinum (Adams catalyst) can achieve specific oxidation of secondary alcohols by a preferential attack upon hydrogen in an equatorial position (25). Catalytic oxidation of methyl a- and /3-D-galactopyranoside (26), fallowed by catalytic reduction with hydrogen, led to the formation of methyl a- and /3-6-deoxy-D-galactopyranoside (D-fuco-pyranoside) in 15% and 35% yield, respectively. This oxidation-reduction sequence with selective oxidation at carbon 4 as the initial step is structurally closely related to the above described pathway for TDPG-oxidoreductase. 

Platinum in a finely divided form is obtained by the in situ reduction of hydrated platinum dioxide (Adams catalyst) finely divided platinum may also be used supported on an inert carrier such as decolourising carbon. Finely divided palladium prepared by reduction of the chloride is usually referred to as palladium black. More active catalysts are obtained however when the palladium is deposited on decolourising carbon, barium or calcium carbonate, or barium sulphate. Finely divided ruthenium and rhodium, usually supported on decolourising carbon or alumina, may with advantage be used in place of platinum or palladium for some hydrogenation reactions. 

An important advance was made when it was observed that photolysis of the (3-enamido ketone 165, which was readily available from the indoline 163 by Birch reduction followed by N-aryloylation, delivered the lactam 168 as the only photoproduct (Scheme 17) (125). Reduction of 168 with LiAlH4 gave ( )-a-anhydrodihydrocaranine (143), which was then converted to ( )--y-lycorane (93) on hydrogenation over Adams catalyst in acetic acid. In a similar fashion, irradiation of the bromo or iodo enaminones 166 (Z = Br, I), which were obtained by alkylation of the intermediate imino ether formed on Birch reduction of 163, afforded a mixture (approximately 3 2) of the lactam 168 together with the photoreduction product 167 (126). 

The bulk of the l-(2,5-dimethoxyphenyl)-2-(t-butylamino)propiophenone was dissolved in methanol and hydrogenated over platinum (Adams catalyst). After removal of the catalyst, the solvent was removed in vacuo and the residual solid was dissolved in water and the solution was washed with ether. 

Piperidine-type metacyclophane alkaloids have four chiral carbon atoms C-3, C-5, C-9, and C-ll. With 96 in hand, Fujita et al. hydrogenated its pyridine ring over Adams catalyst and Raney nickel in order to define the relative stereochemistry of C-5 and C-9. They obtained a single crystalline hexahydro derivative in quantitative yield. Catalytic hydrogenation of substituted pyridines generally results in cis products. Therefore, one can assume the cis relationship of C-5 and C-9 hydrogens in the foregoing... 

Diazomethane reacts with the salts of enamines to yield aziridinium salts.327 327a ThusiV-cyclohexylidenepyrrolidinium perchlorate yields 2,2 -pentamethylene-1,1 -tetramet hyleneaziridinium perchlorate (101). Hydrogenation over Adams catalyst cleaves the bond between the quaternary nitrogen atom and the methylene group to form A-(l-methylcyclohexyl)pyrrolidinium perchlorate (102). 

Experimental Details—A solution of 12.8 g. of 4,6-benzylidene-D-gIucose, m. p. 185-186°, in 150 cc. of 95% ethanol was shaken with hydrogen in the presence of 1.5 g. of platinum oxide (Adams catalyst) at room temperature and an initial pressure of 50 pounds per square inch. The reduction was complete in eighteen hours with the absorption of approximately one mole-equivalent of hydrogen. Concentration of the filtered solution yielded 10.5 g. (82%) of 4,6-benzylidenesorbitol, m. p. 131-134°. Recrystallization from ethanol by the addition of ether yielded the pure compound, m. p. 132-133°. 

---