Acetals neutral conditions

Alkynyl anions are more stable = 22) than the more saturated alkyl or alkenyl anions (p/Tj = 40-45). They may be obtained directly from terminal acetylenes by treatment with strong base, e.g. sodium amide (pA, of NH 35). Frequently magnesium acetylides are made in proton-metal exchange reactions with more reactive Grignard reagents. Copper and mercury acetylides are formed directly from the corresponding metal acetates and acetylenes under neutral conditions (G.E. Coates, 1977 R.P. Houghton, 1979). 

Six protective groups for alcohols, which may be removed successively and selectively, have been listed by E.J. Corey (1972B). A hypothetical hexahydroxy compound with hydroxy groups 1 to 6 protected as (1) acetate, (2) 2,2,2-trichloroethyl carbonate, (3) benzyl ether, (4) dimethyl-t-butylsilyl ether, (5) 2-tetrahydropyranyl ether, and (6) methyl ether may be unmasked in that order by the reagents (1) KjCO, or NH, in CHjOH, (2) Zn in CHjOH or AcOH, (3) over Pd, (4) F", (5) wet acetic acid, and (6) BBrj. The groups may also be exposed to the same reagents in the order A 5, 2, 1, 3, 6. The (4-methoxyphenyl)methyl group (=MPM = p-methoxybenzyl, PMB) can be oxidized to a benzaldehyde derivative and thereby be removed at room temperature under neutral conditions (Y- Oikawa, 1982 R. Johansson, 1984 T. Fukuyama, 1985). 

The oxidation of higher alkenes in organic solvents proceeds under almost neutral conditions, and hence many functional groups such as ester or lac-tone[26,56-59], sulfonate[60], aldehyde[61-63], acetal[60], MOM ether[64], car-bobenzoxy[65], /-allylic alcohol[66], bromide[67,68], tertiary amine[69], and phenylselenide[70] can be tolerated. Partial hydrolysis of THP ether[71] and silyl ethers under certain conditions was reported. Alcohols are oxidized with Pd(II)[72-74] but the oxidation is slower than the oxidation of terminal alkenes and gives no problem when alcohols are used as solvents[75,76]. 

Allylic acetates are widely used. The oxidative addition of allylic acetates to Pd(0) is reversible, and their reaction must be carried out in the presence of bases. An important improvement in 7r-allylpalladium chemistry has been achieved by the introduction of allylic carbonates. Carbonates are highly reactive. More importantly, their reactions can be carried out under neutral con-ditions[13,14]. Also reactions of allylic carbamates[14], allyl aryl ethers[6,15], and vinyl epoxides[16,17] proceed under neutral conditions without addition of bases. 

Allylation under basic conditions. Allylation can be carried out under basic conditions with allylic acetates and phosphates, and under neutral conditions with carbonates and vinyloxiranes. The allylations under neutral conditions are treated separately in Section 2.2.2.1 from those under basic conditions. However, in some cases, allylations of the same substrates are carried out under both basic and neutral conditions to give similar results. These reactions are treated together in this section for convenience. Allylic acetates are widely used for Pd-catalyzed allylation in the presence of bases tertiary amines or NaH are commonly used[6,7,4l]. As a base, basic alumina or ICF on alumina is conveniently used, because it is easy to remove by filtration after the reaction[42]. Allyl phosphates are more reactive than acetates. The allylation with 40 proceeds stepwise. At first allylic phosphate reacts with malonate and then allylic acetate reacts with amine to give 41(43]. 

Wylation under neutral conditions. Reactions which proceed under neutral conditions are highly desirable, Allylation with allylic acetates and phosphates is carried out under basic conditions. Almost no reaction of these allylic Compounds takes place in the absence of bases. The useful allylation under neutral conditions is possible with some allylic compounds. Among them, allylic carbonates 218 are the most reactive and their reactions proceed under neutral conditions[13,14,134], In the mechanism shown, the oxidative addition of the allyl carbonates 218 is followed by decarboxylation as an irreversible process to afford the 7r-allylpalladium alkoxide 219. and the generated alkoxide is sufficiently basic to pick up a proton from active methylene compounds, yielding 220. This in situ formation of the alkoxide. which is a... 

Hydroxylysine (328) was synthesized by chemoselective reaction of (Z)-4-acet-oxy-2-butenyl methyl carbonate (325) with two different nucleophiles first with At,(9-Boc-protected hydroxylamine (326) under neutral conditions and then with methyl (diphenylmethyleneamino)acetate (327) in the presence of BSA[202]. The primary allylic amine 331 is prepared by the highly selective monoallylation of 4,4 -dimethoxybenzhydrylamine (329). Deprotection of the allylated secondary amine 330 with 80% formic acid affords the primary ally-lamine 331. The reaction was applied to the total synthesis of gabaculine 332(203]. 

Phenols arc highly reactive 0-nucleophiles and allylated easily with allylic carbonates under neutral conditions. EWGs on phenols favor the reac-tion[213]. Allylic acetates are used for the allylation of phenol in the presence of KF-alumina as a base[214]. 

The decarboxylation of allyl /3-keto carboxylates generates 7r-allylpalladium enolates. Aldol condensation and Michael addition are typical reactions for metal enolates. Actually Pd enolates undergo intramolecular aldol condensation and Michael addition. When an aldehyde group is present in the allyl fi-keto ester 738, intramolecular aldol condensation takes place yielding the cyclic aldol 739 as a main product[463]. At the same time, the diketone 740 is formed as a minor product by /3-eIimination. This is Pd-catalyzed aldol condensation under neutral conditions. The reaction proceeds even in the presence of water, showing that the Pd enolate is not decomposed with water. The spiro-aldol 742 is obtained from 741. Allyl acetates with other EWGs such as allyl malonate, cyanoacetate 743, and sulfonylacetate undergo similar aldol-type cycliza-tions[464]. 

No reaction of soft carbon nucleophiles takes place with propargylic acet-ates[37], but soft carbon nucleophiles, such as / -keto esters and malonates, react with propargylic carbonates under neutral conditions using dppe as a ligand. The carbon nucleophile attacks the central carbon of the cr-allenylpal-ladium complex 81 to form the rr-allylpalladium complex 82, which reacts further with the carbon nucleophile to give the alkene 83. Thus two molecules of the a-monosubstituted /3-keto ester 84, which has one active proton, are... 

N-Alkylations, especially of oxo-di- and tetra-hydro derivatives, e.g. (28)->(29), have been carried out readily using a variety of reagents such as (usual) alkyl halide/alkali, alkyl sulfate/alkali, alkyl halide, tosylate or sulfate/NaH, trialkyloxonium fluoroborate and other Meerwein-type reagents, alcohols/DCCI, diazoalkanes, alkyl carbonates, oxalates or malon-ates, oxosulfonium ylides, DMF dimethyl acetal, and triethyl orthoformate/AcjO. Also used have been alkyl halide/lithium diisopropylamide and in one case benzyl chloride on the thallium derivative. In neutral conditions 8-alkylation is observed and preparation of some 8-nucleosides has also been reported (78JOC828, 77JOC997, 72JOC3975, 72JOC3980). 

A benzylidene acetal is a commonly used protective group for 1,2- and 1,3-diols. In the case of a 1,2,3-triol the 1,3-acetal is the preferred product. It has the advantage that it can be removed under neutral conditions by hydrogenolysis or by acid hydrolysis. Benzyl groups and isolated olefins have been hydrogenated in the presence of 1,3-benzylidene acetals. Benzylidene acetals of 1,2-diols are more susceptible to hydrogenolysis than are those of 1,3-diols. In fact, the former can be removed in the presence of the latter. A polymer-bound benzylidene acetal has also been prepared." ... 

MeOH, LaCl3, (MeO)3CH, 25°, 10 min, 80-100% yield/ Dimethyl acetals can be prepared efficlenlly under neutral conditions by catalysis with lanthanoid halides, but the results of the reaction with ketones are unpredictable. 

The positions of substitution, orientation, and configuration of the stable form are determined by a balance between opposing steric and dipole ef-fects. There is less agreement regarding the factors influencing kinetically controlled reaction (see below). Essentially neutral conditions, such as provided by an acetate or pyridine buffer, are required to avoid isomerization. Frequently, however, bromination will not proceed under these conditions, and a compromise has been used in which a small amount of acid is added to start and maintain reaction, while the accumulation of hydrogen bromide is prevented by adding exactly one equivalent of acetate... 

Alcoholic potassium hydroxide or sodium hydroxide are normally used to convert the halohydrins to oxiranes. Other bases have also been employed to effect ring closure in the presence of labile functional groups such as a-ketols, e.g., potassium acetate in ethanol, potassium acetate in acetone or potassium carbonate in methanol.However, weaker bases can lead to solvolytic side reactions. Ring closure under neutral conditions employing potassiunT fluoride in dimethyl sulfoxide, dimethylformamide or A-methyl-pyrrolidone has been reported in the patent literature. 

Acetal formation is similar to the hydration reaction discussed in Section 19.5. Like water, alcohols are weak nucleophiles that add to aldehydes and ketones only slowly under neutral conditions. Under acidic conditions, however, the reactivity of the carbonyl group is increased by protonation, so addition of an alcohol occurs rapidly. 

With acetic acid as solvent 68 is still the major product (Scheme 32). The minor product (69) probably forms in preference to the 3,5-isomer because the quinoline free base is reacting the high yield of 68 can be rationalized in terms of a 1,4- or 1,2-addition product that is rapidly bromi-nated at C-3. The 6- and 8-positions substitute more slowly [62JCS283, 62JCS291 77HC(32-1)319]. Both the 6- and the 8-bromoquinolines were 3-brominated under neutral conditions (62JOC1318). 

Another synthesis, described in detail in Scheme 12, was devised specifically for the introduction of deuterium at both ends of l-deoxy-D-t/ireo-pentulose.21,22 Stannylene methodology was used twice, first for glycol splitting with phenyliodonium diacetate, under strictly neutral conditions (necessary to preserve the benzylidene acetal), and secondly to convert the sequence -CHOH-CD3 to CO-CD3 by brominolysis. The final, labeled pentulose was l-deo y-D-threo-(1-2H3, 5-2H)pentulose. 

Transesterification is catalyzed by acids or bases, or performed under neutral conditions. It is an equilibrium reaction and must be shifted in the desired direction. In many cases, low-boiling esters can be converted to higher boiling ones by the distillation of the lower boiling alcohol as fast as it is formed. Reagents used to catalyze transesterification include In/l2, Montmorillonite KlOclay, Ti(OEt)4, Cu(N03)2, which with ethyl acetate is elective for primaiy alcohols, ... 

Nitroimidazoles substituted by an aromatic ring at the 2-position are also active as antitrichomonal agents. Reaction of p-fluorobenzonitrile (83) with saturated ethanolic hydrogen chloride affords imino-ether 84. Condensation of that intermediate with the dimethyl acetal from 2-aminoacetaldehyde gives the imidazole 85. Nitration of that heterocycle with nitric acid in acetic anhydride gives 86. Alkylation with ethylene chlorohydrin, presumably under neutral conditions, completes the synthesis of the anti-... 

Recent papers have disclosed that Pd(0) catalyzed allylic alkylations under neutral conditions are not limited to allylic carbonates or epoxides but also can be extended in many cases to the more popular allylic acetates (Eq. 5.58).sla... 

As shown in Eq. 6.59, Rapoport has prepared sinefungin, nucleoside antibiotics, via nitro-aldol reaction, dehydration, and reduction with Zn in acetic add.115a [i-Nitrostyrenes are selectivity reduced to the corresponding oximes by indium metal in aqueous methanol under neutral conditions.11515... 

The palladium-catalyzed cross-coupling reaction featured in this procedure occurs under neutral conditions in the presence of many synthetically useful functional groups (e.g. alcohol, ester, nitro, acetal, ketone, and aldehyde). The reaction works best in N,N-dimethylformamide with bis(triphenylphosphine)palladium(ll) chloride, PdCI2(PPh3)2, as the catalyst. Lithium chloride is added to prevent decomposition of the catalyst.143 13 It is presumed that conversion of the intermediate aryl palladium triflate to an aryl palladium chloride is required for the transmetallation step to proceed.9... 

The acylation of 3-arylsydnones (Section 5.03.5.2.4) at position C4 occurs under neutral conditions and in satisfactory yield, in the presence of acetic anhydride and l,3-dibromo-5,5-dimethylhydantoin as an efficient promoter <2007JHC467>. 

---