Y-Cyclodextrin

Triton X-100 and y-cyclodextrin, and subsequent charge separation via reductive quenching Chem. Phys. Lett. 223 511-16... 

Optical properties of cyanines can be usefiil for both chiral substituents/environments and also third-order nonlinear optical properties in polymer films. Methine-chain substituted die arbo cyanines have been prepared from a chiral dialdehyde (S)-(+)-2-j -butylmalonaldehyde [127473-57-8] (79), where the chiral properties are introduced via the chiral j -butyl group on the central methine carbon of the pentamethine (die arbo cyanine) chromophore. For a nonchiral oxadicarbocyanine, the dimeric aggregate form of the dye shows circular dichroism when trapped in y-cyclodextrin (80). Attempts to prepare polymers with carbocyanine repeat units (linked by flexible chains) gave oligomers with only two or three repeat units (81). However, these materials... 

Purification of C q from a C(,q/C-,q mixture was achieved by dissolving in an aqueous soln of y (but not p) cyclodextrin (0.02M) upon refluxing. The rate of dissolution (as can be followed by UV spectra) is quite slow and constant up to lO M of C o- The highest concn of C o in H2O obtained was 8 x 10 M and a 2 y-cyclodextrin C q clathrate is obtained. C ) is extracted from this aqueous soln by toluene and C oof >99 purity is obtained by evaporation. With excess of y-cyclodextrin more C g dissolves and the complex precipitates. The ppte is insol in cold H2O but sol in boiling H2O to give a yellow soln. [J Chem Soc, Chem Commun 604 7922.]... 

One of the latest resolutions of the anesthetic enflurane (8) has been performed by preparative GC on a y-cyclodextrin CSP, the process later being scaled-up via SMB [109] (Fig. 1-4). This is the first GC-SMB separation described. 

In this equation, AG°CS is taken to be negligible for p- and y-cyclodextrin systems and to be constant, if there is any, for the a-cyclodextrin system. The AG W term is virtually independent of the kind of guest molecules, though it is dependent on the size of the cyclodextrin cavity. The AG dw term is divided into two terms, AG°,ec and AGs°ter, which correspond to polar (dipole-dipole or dipole-induced dipole) interactions and London dispersion forces, respectively. The former is mainly governed by the electronic factor, the latter by the steric factor, of a guest molecule. Thus, Eq. 2 is converted to Eq. 3 for the complexation of a particular cyclodextrin with a homogeneous series of guest molecules ... 

Cyclic oligosaccharides composed of a single type of oligosaccharide unit may be named semisystematically by citing the prefix cyclo , followed by terms indicating the type of linkage [e.g. malto for a-(l—>4)-linked glucose units], the number of units (e.g. hexa for six) and the termination -ose . The trivial names a-cyclodex-trin (a-CD) for cyclomaltohexaose, (i-cyclodextrin ((i-CD) for cyclomaltoheptaose and y-cyclodextrin (y-CD) for cyclomaltooctaose are well established. 

The theory and development of a solvent-extraction scheme for polynuclear aromatic hydrocarbons (PAHs) is described. The use of y-cyclodextrin (CDx) as an aqueous phase modifier makes this scheme unique since it allows for the extraction of PAHs from ether to the aqueous phase. Generally, the extraction of PAHS into water is not feasible due to the low solubility of these compounds in aqueous media. Water-soluble cyclodextrins, which act as hosts in the formation of inclusion complexes, promote this type of extraction by partitioning PAHs into the aqueous phase through the formation of complexes. The stereoselective nature of CDx inclusion-complex formation enhances the separation of different sized PAH molecules present in a mixture. For example, perylene is extracted into the aqueous phase from an organic phase anthracene-perylene mixture in the presence of CDx modifier. Extraction results for a variety of PAHs are presented, and the potential of this method for separation of more complex mixtures is discussed. 

Figure 2. Total-luminescence contour plots of an anthracene-perylene mixture prior to extraction (a) and following extraction (b) with y-cyclodextrin.

Figure 34 Chemical formula of y-cyclodextrin consisting of eight glucose molecules with adamantane as the guest entrapped within its hydrophobic cavity. Structures of a- and P-cyclodextrins will be similar but made up of six and seven (n = 6, 7) glucoses,...

Reaction conditions 0.1 g of the zeolite Y modified catalyst, tested in a conventional glass microreactor with racemic butan-2-ol (7.35 x 10" mol h-1), prevaporized in a nitrogen diluent (6.2 -6.7 x 10" mol h-1). Products were analyzed using on-line GC with a 40m capillary y- cyclodextrin colimm with trifluoroacetyl stationary phase, temperature programmed from 25-70 "C with a split ratio of 120 1. 

Miniaturized columns have provided a decisive advantage in speed. Uracil, phenol, and benzyl alcohol were separated in 20 seconds by CEC in an 18 mm column with a propyl reversed phase.29 A19 cm electrophoretic channel was etched into a glass wafer, filled with a y-cyclodextrin buffer, and used to resolve chiral amino acids from a meteorite in 4 minutes.30 A 6 cm channel equipped with a syringe pump to automate sample derivatization was used to separate amino acids modified with fluorescein isothiocyanate.31 Nanovials have been used to perform tryptic digests on the 15 nL scale for subsequent separation on capillary Electrophoresis.32 A microcolumn has also been used to generate fractions representing time-points of digestion from a 40 pL sample.33 A disposable nanoelectrospray emitter has been... 

Glutamic acid PO Cig y-Cyclodextrin (Cyclobond II) Yes Rundlett and Armstrong, 1994... 

Ekgorg-Ott et al. (1997). An interesting trend was discovered when considering the relative amount of D-theanine present in the samples. The teas of the highest grades consistently contained the lowest amounts of D-theanine. The theanine achiral-chiral system configuration included a C18 column operated in the reverse-phase mode and a y-cyclodextrin CSP in the polar organic mode. 

The formation of complexes of the fluorescent tracer dye ammonium 1-phenyl-aminonaphthalene-8-sulphonate (10.41) with cyclodextrins has been investigated with favourable results, especially in environmental studies [33]. The ability of this dye to complex with cyclodextrins has been exploited mainly as an analytical tool in the study of cyclodextrin applications, since its fluorescence is easily measured. The interaction of a-, P-and y-cyclodextrins with azo acid dyes containing alkyl chains of different lengths has been reported [36,37]. The formation and isolation of solid complexes between P-cyclodextrin and Cl Acid Red 42, Cl Acid Blue 40 or Erionyl Bordeaux 5BLF (Ciba) have been reported [29]. 

Cl Disperse Yellow 42 Cl Disperse Orange 11 Cl Disperse Orange 29 Cl Disperse Violet 1 Cl Disperse Violet 31 Cl Disperse Blue 56 Cl Disperse Blue 165 Resolin Red FRL (DyStar) Resolin Yellow 5GL (DyStar) With y-cyclodextrin Cl Disperse Orange 11... 

The formation and isolation of solid complexes between cyclodextrins and reactive dyes have been reported, but no dyeing results were presented [29]. Complexes were formed between P-cyclodextrin and Cl Reactive Orange 16, Violet 5, Blue 38 or Blue 114 and between y-cyclodextrin and Cl Reactive Blue 38 or Blue 114. 

---