Body water

The stocking of ponds, lakes, and reservoirs to increase the production of desirable fishes that depend on natural productivity for their food supply and are ultimately captured by recreational fishermen or for subsistence is another example of extensive aquaculture. Some would consider such practices as lying outside of the realm of aquaculture, but since the practice involves human intervention and often employs fishes produced in hatcheries, recreational or subsistence level stocking is associated with, if not a part of aquaculture. Similarly, stocking new ponds or water bodies which have been drained or poisoned to eliminate undesirable species prior to restocking, can lead to increased production of desirable species. 

Thermal effects on aquatic organisms have been given critical scientific review. Annual reviews of the thermal effects Hterature have been pubUshed beginning in 1968 (12). Water temperature criteria for protection of aquatic life were prepared by the NAS in 1972, and these criteria have formed the basis of the EPA recommendations for estabUshing water temperature standards for specific water bodies (13,14). 

Fig. 6. Approaches to minimising entrapment and impingement of fish and large aquatic invertebrates, eg, blue crabs, on trash screens at intakes, (a) An inlet pump house with vertical traveling screens mounted flush with a river shoreline to minimise obstmctions to animal movements (b) parallel flow to direct fish to a recovery chamber that returns to the water body (c) a velocity cap atop a vertical, offshore inlet induces a horizontal flow which fish avoid...

The places from which pollutants emanate are called sources. There are natural as well as anthropogenic sources of the permanent gases considered to be pollutants. These include plant and animal respiration and the decay of what was once living matter. Volcanoes and naturally caused forest fires are other natural sources. The places to which pollutants disappear from the air are called sinks. Sinks include the soil, vegetation, structures, and water bodies, particularly the oceans. The mechanisms whereby pollutants... 

Different areas of the earth s surface react quite differently to heating by the sun. For example, although a sandy surface reaches fairly high temperatures on a sunny day, the heat capacity and conductivity of Scmd are relatively low the heat does not penetrate more than about 0.2-0.3 m and little heat is stored. In contrast, in a body of water, the sun s rays penetrate several meters and slowly heat a fairly deep layer. In addition, the water can move readily and convection can spread the heat through a deeper layer. The heat capacity of water is considerably greater than that of sand. All these factors combine to allow considerable storage of heat in water bodies. 

Figure 8. Shows effect of large water bodies on pollutant transport.

Enter the applicable letter code for the receiving stream or water body from Section 3.10 of Part I of the form. Also, enter the total annual amount of the chemical released from all discharge points at the facility to each receiving stream or water body. Include process outfalls such as pipes and open trenches, releases from on-site wastewater treatment systems, and the contribution from stormwater runoff, if applicable (see instructions for column C below). Do not include discharges to a POTW or other off-site wastewater treatment facilities in this section. These off-sife transfers must be reported in Pari III, Section 6 of the form. 

---