Voltage measurement apparent

Randomness.—The word random is used frequently to describe erratic and apparently unpredictable variations of an observed quantity. The noise voltage measured at the terminals of a hot resistor, the amplitude of a radar signal that has been reflected from the surface of the sea, and the velocity measured at some point in a turbulent air flow are all examples of random or unpredictable phenomena. 

I When the system voltage is linear (an ideal condition that would seldom exist) but the load is non-linear The current will be distorted and become non-sinusoidal. The actual current /, (r.m.s.) (equation (23.2)) will become higher than could be measured by an ammeter or any other measuring instrument, at the fundamental frequency. Figure 23.13 illustrates the difference between the apparent current, measured by an instrument, and the actual current, where / = active component of the current... 

Apparent power is the total power of a circuit and is measured in VA or kVA (1,000 VA). It is obtained by multiplying voltage and current. 

Figure 1.5 The slope of E ath versus log /orr through the fuel-cell-relevant potential range has an apparently constant value near RT/F (measured current density, here designated i, is corrected for hydrogen crossover current, designated i and the measured cell voltage is ir-corrected to provide the cathode potential E) [Neyerlin et al., 2006].

As far as conductometry is concerned, there remain a few complications caused by processes at the electrodes, e.g., electrolysis above the decomposition voltage of the electrolyte with some liberation of decomposition products at the electrode, or apparent capacitance and resistance effects as a consequence of polarization of the electrode and exchange of electrons at its surface. In order to reduce these complications the following measures are taken ... 

Although the literature on electrodeposited electroactive and passivating polymers is vast, surprisingly few studies exist on the solid-state electrical properties of such films, with a focus on systems derived from phenolic monomers, - and apparently none exist on the use of such films as solid polymer electrolytes. To characterize the nature of ultrathin electrodeposited polymers as dielectrics and electrolytes, solid-state electrical measurements are made by electrodeposition of pofy(phenylene oxide) and related polymers onto planar ITO or Au substrates and then using a two-electrode configuration with a soft ohmic contact as the top electrode (see Figure 27). Both dc and ac measurements are taken to determine the electrical and ionic conductivities and the breakdown voltage of the film. 

Because of the force and deformation, the displacement measured by the voltage applied on the z piezo may different from the true tip-sample distance. We will denote it as the apparent displacement whenever it appears. 

---