To contain

The reactor effluent is thus likely to contain hydrogen, methane, benzene, toluene, and diphenyl. Because of the large differences in volatility of these components, it seems likely that partial condensation will allow the effluent to be split into a vapor stream containing predominantly hydrogen and methane and a liquid stream containing predominantly benzene, toluene, and diphenyl. 

Olefins are uncommon in crude oils due to the high chemical activity of these compounds which causes them to become saturated with hydrogen. Similarly, acetylene is virtually absent from crude oil, which tends to contain a large proportion of the saturated hydrocarbons, such as the alkanes. 

In order to contain normal or abnormal pressures, a pressure seal must be present. In hydrocarbon reservoirs, there is by definition a seal at the crest of the accumulation, and the potential for abnormal pressure regimes therefore exists. 

Storage tanks should always be closely surrounded by bund walls to contain crude in the event of a spillage incident, such as a ruptured pipe or tank, and to allow fire fighting personnel and equipment to be positioned reasonably close to the tanks by providing protected access. 

Often the divergence in costs shown in Figure 14.11 does occur, and must be managed. The objective is to maintain production in a safe and environmentally responsible manner, while trying to contain or reduce costs. The approach to managing this problem is through reviewing... 

A traditional abandonment process begins with a well killing operation in which produced fluids are circulated out of the well, or pushed ( bull headed ) into the formation, and replaced by drilling fluids heavy enough to contain any open formation pressures. Once... 

To get an equation for/(r,v,0, we take a region 5r5v about a point (r,v), that is large enough to contain a lot of particles, but small compared with the range of variation of/... 

Temary and quaternary semiconductors are theoretically described by the virtual crystal approximation (VGA) [7], Within the VGA, ternary alloys with the composition AB are considered to contain two sublattices. One of them is occupied only by atoms A, the other is occupied by atoms B or G. The second sublattice consists of virtual atoms, represented by a weighted average of atoms B and G. Many physical properties of ternary alloys are then expressed as weighted linear combinations of the corresponding properties of the two binary compounds. For example, the lattice constant d dependence on composition is written as ... 

If more than one electronic state is involved, then the electronic wave function is free to contain components from all states. For example, for non-adiabatic systems the elecbonic wave function can be expanded in the adiabatic basis set at the nuclear geometry R t)... 

The monomers are electron pair acceptors, and donor molecules are often able to split the dimeric halide molecules to form adducts thus, whilst the dimeric halides persist in solvents such as benzene, donor solvents such as pyridine and ether appear to contain monomers since adduct formation occurs. Aluminium halides, with the one exception of the fluoride, resemble the corresponding boron halides in that they are readily hydrolysed by water. 

A salt originally called sodium hexametaphosphate, with n believed to be 6, is now thought to contain many much larger anion aggregates. It has the important property that it sequesters , i.e. removes, calcium ions from solution. Hence it is much used as a water-softener. 

The solution obtained when sulphur dioxide dissolves in water has long been thought to contain unionised sulphurous acid, H2SO3, but more probably contains hydrated sulphur dioxide (cf. NHj solution, p. 217). The solution behaves as a dibasic acid, i.e. 

Anhydrous titanium dioxide is only soluble with difficulty in hot concentrated sulphuric acid dilution allows the crystallisation of a sulphate of formula T10S04.H20, but it is doubtful if the titanyl cation TiO actually exists, either in solution or the solid. Certainly [TifHjOIn] does not exist, and solutions of titanyl salts may best be considered to contain ions [Ti(0H)2(H204)] . Titanium... 

After some experience, an able student will find that it is frequently unnecessary to carry out all the Tests A—L. If, for example, the substance is found to contain only carbon and hydrogen, and chars on ignition giving a smell of burnt sugar, then confirmatory tests (given in... 

The Problem. Suppose that the total serum cholesterol level in normal adults has been established as 200mg/100mL (mg%) with a standard deviation of 25 mg%, that is, p = 200 and ct = 25. (Please distinguish between mg% and % probability.) A patient s serum is analyzed for cholesterol and found to contain 265 mg% total cholesterol. 

To set up the problem for a microcomputer or Mathcad, one need only enter the input matrix with a 1.0 as each element of the 0th or leftmost column. Suitable modifications must be made in matrix and vector dimensions to accommodate matrices larger in one dimension than the X matrix of input data (3-56), and output vectors must be modified to contain one more minimization parameter than before, the intercept otq. 

The crude bromide contains a little unchanged alcohol and is said to contain some n-butyl ether (b.p. 141°). The former is removed by washing with concen. trated hydrochloric acid and this purification process is satisfactory for most purposes. Both the alcohol and the ether are removed by washing with 11-12 ml. of concentrated sulphuric acid the butyl bromide is not affected by this reagent. 

The liquid phosphorus oxychloride, b.p. 107°, is a by-product and is removed by fractional distillation under normal pressure. Unless the b.p. of the acid chloride differs very considerably (say, <] 100°) from that of the phosphorus oxychloride, the acyl halide is liable to contain traces of the latter. In such circumstances it is preferable to use thionyl chloride for the preparation of the acid chloride. 

The residue in the flask is said to contain 4-amino- and 2 6-diamino-pyridine, YY dipyridyl and aa -dipyridylamine in varying amounts. 

Prepare the zinc powder - sodium carbonate mixture by grinding together in a dry, clean mortar 25 g. of A.R. anhydrous sodium carbonate and 50 g. of the purest obtainable zinc powder. The reagent is unlikely to contain nitrogen, but traces of sulphur and halogens may be present. It is therefore essential to carry out a blank or control test for sulphur and halogens with every fresh batch of the mixture. 

Sodium test. Treat 1 ml. of the compound with a amall thin slice of freshly cut sodium (handle with the tonga or with a penknife) in a small, dry test-tube (75 X 10 mm. or 100 X 12 mm.). Observe whether hydrogen is evolved and the sodium reacts. (If the compound is suspected to contain water, dry it first with a little anhydrous calcium or magnesium sulphate.)... 

Acidify the aqueous solution (60-76 ml.)= prepared from (a) 6-10 g. of the solid mixture, ( >) from 6-10 g. of the liquid residue (fJ) after distillation from a boiling water bath, or (c) from sufHcient of original aqueous solution to contain 6-10 g. of solute) with 20% E fSOf and distil. 

Graphite exists in two forms alpha and beta. These have identical physical properties, except for their crystal structure. Naturally occurring graphites are reported to contain as much as 30% of the rhombohedral (beta) form, whereas synthetic materials contain only the alpha form. The hexagonal alpha type can be converted to the beta by mechanical treatment, and the beta form reverts to the alpha on heating it above lOOOoC. 

Gallium is often found as a trace element in diaspore, sphalerite, germanite, bauxite, and coal. Some flue dusts from burning coal have been shown to contain as much 1.5 percent gallium. 

Cesium, an alkali metal, occurs in lepidolite, pollucte (a hydrated silicate of aluminum and cesium), and in other sources. One of the world s richest sources of cesium is located at Bernic Lake, Manitoba. The deposits are estimated to contain 300,000 tons of pollucite, averaging 20% cesium. 

Krypton is present in the air to the extent of about 1 ppm. The atmosphere of Mars has been found to contain 0.3 ppm of krypton. Solid krypton is a white crystalline substance with a face-centered cubic structure which is common to all the "rare gases."... 

Materials —------Separatory funnel (2x volume to contain) Simple... 

Because six membered rings are normally less strained than five membered ones pyranose forms are usually present m greater amounts than furanose forms at equilib rium and the concentration of the open chain form is quite small The distribution of carbohydrates among their various hemiacetal forms has been examined by using H and NMR spectroscopy In aqueous solution for example d ribose is found to contain the various a and p furanose and pyranose forms m the amounts shown m Figure 25 5 The concentration of the open chain form at equilibrium is too small to measure directly Nevertheless it occupies a central position m that mterconversions of a and p anomers and furanose and pyranose forms take place by way of the open chain form as an inter mediate As will be seen later certain chemical reactions also proceed by way of the open chain form... 

If there is a choice between components of the same size containing the same number and kind of heteroatoms, choose as the base component that one with the lower numbers for the heteroatoms before fusion. When a fusion position is occupied by a heteroatom, the names of the component rings to be fused are selected to contain the heteroatom. 

Glassware designed to contain a specific volume of solution when filled to its calibration mark. 

Pipets and volumetric flasks provide a more accurate means for measuring volume. When filled to its calibration mark, a volumetric flask is designed to contain a specified volume of solution at a stated temperature, usually 20 °C. The actual vol-... 

---