Thiophene chloride

Chloro 2 thenyl Chloride 2-Chloromethy > thiophene Chloride (5) or 5 Chloro 2 (chloro methyl) thiophene, C1.C-S-C-CH2C1 ... 

CH3CH2)2S. a colourless liquid with an ethereal odour when pure usually it has a strong garlic-like odour b.p. 92°C. Prepared by the action of KHS on ethyl chloride or potassium ethyl sulphate. When heated at 400-500°C it forms thiophene. 

Upon distilling the mercury compound with concentrated hydrochloric acid, it is readily decomposed into mercuric chloride and pure thiophene. 

By treatment with anhydrous aluminium chloride (Holmes and Beeman, 1934). Ordinary commercial, water-white benzene contains about 0 05 per cent, of thiophene. It is first dried with anhydrous calcium chloride. One litre of the dry crude benzene is shaken vigorously (preferably in a mechanical shaking machine) with 12 g. of anhydrous aluminium chloride for half an hour the temperature should preferably be 25-35°. The benzene is then decanted from the red liquid formed, washed with 10 per cent, sodium hydroxide solution (to remove soluble sulphur compounds), then with water, and finally dried over anhydrous calcium chloride. It is then distilled and the fraction, b.p. 79-5-80-5°, is collected. The latter is again vigorously shaken with 24 g. of anhydrous aluminium chloride for 30 minutes, decanted from the red liquid, washed with 10 per cent, sodium hydroxide solution, water, dried, and distilled. The resulting benzene is free from thiophene. 

Benzoic acid and naphthoic acid are formed by the oxidative carbonylation by use of Pd(OAc)2 in AcOH. t-Bu02H and allyl chloride are used as reoxidants. Addition of phenanthroline gives a favorable effect[360], Furan and thiophene are also carbonylated selectively at the 2-position[361,362]. fndole-3-carboxylic acid is prepared by the carboxylation of 1-acetylindole using Pd(OAc)2 and peroxodisulfate (Na2S208)[362aj. Benzoic acid derivatives are obtained by the reaction of benzene derivatives with sodium palladium mal-onate in refluxing AcOH[363]. 

Pd(II) salts promote the carbonylation of organomercury compounds. Reaction of phenylmercury chloride and PdCh under CO pressure affords benzophenone (429)[387]. Both esters and ketones are obtained by the carbonylation of furylmercury(Il) chloride in alcohol[388]. Although the yields are not satisfactory, esters are obtained by the carbonylation of aryl- and alkylmercuryfll) chlorides[389,390]. One-pot catalytic carbonylation of thiophene, furan, and pyrrole (430) takes place at the 2-position via mercuration and transmetallation by the use of PdCb, Hg(N03), and CuCl2[391]. 

Sulfonated styrene—divinylbensene cross-linked polymers have been appHed in many of the previously mentioned reactions and also in the acylation of thiophene with acetic anhydride and acetyl chloride (209). Resins of this type (Dowex 50, Amherljte IR-112, and Permutit Q) are particularly effective catalysts in the alkylation of phenols with olefins (such as propylene, isobutylene, diisobutylene), alkyl haUdes, and alcohols (210) (see Ion exchange). Superacids. 

Acylation. To achieve acylation of thiophenes, acid anhydrides with phosphoric acid, iodine, or other catalysts have been widely used. Acid chlorides with AlCl, SnCl, ZnCl2, and BF also give 2-thienylketones. AH reactions give between 0.5 and 2.0% of the 3-isomer. There has been much striving to find catalyst systems that minimize the 3-isomer content attempting to meet to customer specifications. The standard procedure for formylation is via the Vil smeier-H a ack reaction, using phosphoms o xycbl o ri de / /V, / V- dim e tb yl fo rm a m i de (POCl /DMF) or /V-m ethyl form an i1 i de. 

Manufacture of 2-acetylthiophenes involves direct reaction of thiophene or alkylthiophene with acetic anhydride or acetyl chloride. Preferred systems use acetic anhydride and have involved iodine or orthophosphoric acid as catalysts. The former catalyst leads to simpler workup, but has the disadvantage of leading to a higher level of 3-isomer in the product. Processes claiming very low levels of 3-isomer operate with catalysts that are proprietary, though levels of less than 0.5% are not easily attained. 

The reactivity of five-membered rings with one heteroatom to electrophilic reagents has been quantitatively compared in a variety of substitution reactions. Table 2 shows the rates of substitution compared to thiophene for formylation by phosgene and iV,AT-dimethylfor-mamide, acetylation by acetic anhydride and tin(IV) chloride, and trifluoroacetylation with trifluoroacetic anhydride (71AHC(13)235). 

An important extension of these reactions is the Mannich reaction, in which aminomethyl-ation is achieved by the combination of formaldehyde, a secondary amine and acetic acid (Scheme 24). The intermediate immonium ion generated from formaldehyde, dimethyl-amine and acetic acid is not sufficiently reactive to aminomethylate furan, but it will form substitution products with alkylfurans. The Mannich reaction appears to be still more limited in its application to thiophene chemistry, although 2-aminomethylthiophene has been prepared by reaction of thiophene with formaldehyde and ammonium chloride. The use of A,iV-dimethyf (methylene) ammonium chloride (Me2N=CH2 CF) has been recommended for the iV,iV-dimethylaminomethylation of thiophenes (83S73). 

Mercury(II) acetate tends to mercurate all the free nuclear positions in pyrrole, furan and thiophene to give derivatives of type (74). The acetoxymercuration of thiophene has been estimated to proceed ca. 10 times faster than that of benzene. Mercuration of rings with deactivating substituents such as ethoxycarbonyl and nitro is still possible with this reagent, as shown by the formation of compounds (75) and (76). Mercury(II) chloride is a milder mercurating agent, as illustrated by the chloromercuration of thiophene to give either the 2- or 2,5-disubstituted product (Scheme 25). 

Thiophenes have been observed to undergo aluminum chloride-catalyzed [2 + 2] cyclo-addition with dicyanoacetylene (Scheme 55) (82JOC967, 82JOC972). 

Thiophene-2-sulfonic acid is a strong acid, similar to benzenesulfonic acid. It forms a sulfonyl chloride with phosphoryl chloride which on reduction with zinc yields thiophene-2-sulfinic acid. 

The direct combination of selenium and acetylene provides the most convenient source of selenophene (76JHC1319). Lesser amounts of many other compounds are formed concurrently and include 2- and 3-alkylselenophenes, benzo[6]selenophene and isomeric selenoloselenophenes (76CS(10)159). The commercial availability of thiophene makes comparable reactions of little interest for the obtention of the parent heterocycle in the laboratory. However, the reaction of substituted acetylenes with morpholinyl disulfide is of some synthetic value. The process, which appears to entail the initial formation of thionitroxyl radicals, converts phenylacetylene into a 3 1 mixture of 2,4- and 2,5-diphenylthiophene, methyl propiolate into dimethyl thiophene-2,5-dicarboxylate, and ethyl phenylpropiolate into diethyl 3,4-diphenylthiophene-2,5-dicarboxylate (Scheme 83a) (77TL3413). Dimethyl thiophene-2,4-dicarboxylate is obtained from methyl propiolate by treatment with dimethyl sulfoxide and thionyl chloride (Scheme 83b) (66CB1558). The rhodium carbonyl catalyzed carbonylation of alkynes in alcohols provides 5-alkoxy-2(5//)-furanones (Scheme 83c) (81CL993). The inclusion of ethylene provides 5-ethyl-2(5//)-furanones instead (82NKK242). The nickel acetate catalyzed addition of r-butyl isocyanide to alkynes provides access to 2-aminopyrroles (Scheme 83d) (70S593). 

The replacement of rhodium from a wide range of rhodacycles to form condensed furans, thiophenes, selenophenes, tellurophenes and pyrroles has been widely explored and a range of examples is shown in Scheme 97. The rhodacycles are readily generated from the appropriate dialkyne and tris(triphenylphosphine)rhodium chloride. Replacement of the rhodium by sulfur, selenium or tellurium is effected by direct treatment with the element, replacement by oxygen using m-chloroperbenzoic acid and by nitrogen using nitrosobenzene. 

Benzo[b]thiophene-2-carbonyl chloride, 3-chloro-synthesis, 4, 870, 889... 

Styryl sulfonyl chloride Friedel-Crafts cyclization benzo[h]thiophenes from, 4, 873 Succinic anhydrides polymers, I, 277 mass spectrometry, 4, 585 structure, 4, 552... 

Thiophene-2-sulfonic acid, 5-acetamido-synthesis, 4, 932 Thiophene-3-sulfonic acid synthesis, 4, 932 Thiophene-2-sulfonyl chloride, synthesis, 4, 932... 

Thiophene-2-sulfonyl chloride, 4-nitro-synthesis, 4, 923 Thiophene-3-sulfonyl chloride synthesis, 4, 932 Thiophenetetracarboxylic acids esters... 

---