The Institution of Mechanical Engineers

Figure 4-17. Power demand for flooded screw compressors using slide valve and suction throttling [1]. (Reprinted by permission of the Councii of the institution of Mechanical Engineers from The Place of the Screw Compressor in Refrigeration )...

Laing, P. O., The Place of the Screw Compressor in Refrigeration, a paper presented to the Institution of Mechanical Engineers at Grimsby, March 1068... 

Figure 10-4. Test results from different gases. [9] Reprinted by permission of The Institution of Mechanical Engineer ...

Wong, W., Acceptance Testing of Centrifugal Compressors and the Application of ASME Power Test Code PTC 10-1965, 1. Mech. Conference Publication 1978-1, Mechanical Engineering Publications, Ltd., for the Institution of Mechanical Engineers, 1978, pp, 123-129. 

Golburn, A. P, Problems in Design and Research on Gon-densers of Vapours and Vapour Mixtures, James Glayton lecture, delivered Sept. 12, (1951), pub. General Discussions of Heat Transfer, The Institution of Mechanical Engineers and ASME, p. 448. 

As a further consideration of the overall system design, it is necessary to examine the choice of the number of pumps installed. In the petrochemical and process industries availability is an important factor in plant operation. The Institution of Mechanical Engineers suggests several classes of pumps linked to availability ... 

Figure 3.12. Reformed gas waste-heat boiler arrangement of vertical U-tube water-tube boiler (Reprinted by permission of the Council of the Institution of Mechanical Engineers from the Proceedings of the Conference on Energy Recovery in the Process Industries, London, 1975.)...

Chen, L., Sun, F., and Wu, C., Cooling and heating rate limits of a reversed reciprocating Ericsson cycle at steady state. Proceedings of the Institute of Mechanical Engineers, Part A, Journal of Power and Energy, 214, 75-85, 2000. 

Pease H.S. Taylor, Editors, "Combustion Researches , in Vol 2 of "High Speed Aerodynamics and Jet Propulsion , Princeton Univ Press, Princeton, N.J.(1956) l8)The Institution of Mechanical Engineers(London) ... 

P. T. Williams S. Besler and D. T. Taylor, The batch pyrolysis of tyre waste - fuel properties of the derived pyrolytic oil and overall plant economics. Proceedings of the Institution of Mechanical Engineers Part A. Journal of Power and Energy, 207, 55-63 (1993). 

Alamdari, F., Edwards, S. C., and Hammond, S. P., Microclimate performance of an open atrium office building A case study in thermo-fluid modeling. In Computational Fluid Dynamics for the Environmental and Building Services Engineer—Tool or Toy , The Institution of Mechanical Engineers, London, 1991, p- 81. 

Proc. Inst. Mech. Eng. Proceedings of the Institution of Mechanical Engineers, London. 

H. Hampson aitd N. Ozi ik. An Investigation into the Condensation of Steam. Proceedings of the Institute of Mechanical Engineers, London IB (1952), pp. 282-294. 

Proceedings of the Institution of Mechanical Engineers—Part H—Journal of Engineering in Medicine. London Professional Engineering Publishing. ISSN 0954-4119. 

Giffen, E. and Crang, T.F. (1946). Steam flow in nozzles velocity coefficient at low steam speeds. Proceedings of the Institution of Mechanical Engineers, 155, 83-92. 

C. de Boer and J. A. Jeyes, The Interaction of Fuel Economy and Emission Control in Europe - A Literature Study, Paper G422/84, The Institution of Mechanical Engineers, 1984. 

Carvalho, M. G., and Lockwood, F. C. "Mathematical Simulation of an End-Port Regenerative Glass Furnace." Proceedings of the Institution of Mechanical Engineers 199, no.2 (1985) 113-20. 

---