Tanks, types

On a land site where space and weight are not normally constraints, advantage can be taken of tank type separation equipment such as wash tanks and settling tanks, and batch processing methods. Such equipment is generally cheaper to maintain than continuous throughput vessels, though a combination of both may be required. 

Tanks. Three basic tank types have been used in ore concentration concurrent, where feed slurry moves in the same dHection as the dmm rotates (Fig. 

Chemical Tank type Chemical Tank type... 

Horizontal-Tank Type This type (Fig. ll-56a) is used to transfer heat for melting or cooking diy powdered solids, rendering lard from meat-scrap solids, and drying divided solids. Heat-transfer coefficients are 17 to 85 W/(m °C) [3 to 15 Btu/(h fF °F)] for drying and 28 to 140 W/(m °C) [5 to 25 Btu/(h fF °F)] for vacuum and/or solvent recovery. 

FIG. 11-56 Heat-transfer equipment for fusion of solids, a) Horizontal-tank type. (Coutiesy of Sttxithers Wells Corp. ) (h) Agitated kettle. (Cowtesy of Read-Standard Division, Capital Products Co.) (c) Donble-dnim mill. (Coutiesy of FaiTel-Bitmingham Co.)... 

FIG. 19-34 Drag-tank-type dense-media separatory vessel. (Couttesy of Link-Belt Co.)... 

Medicine Single faucet activated carbon filter or whole-house tank-type activated absorption filter... 

Setz-fehler, m. compositor s error, -kasten, m. settling tank type case, -phiole, /. (flat bottomed) vial, -fiieb, n. jig(ging) screen, jig(ging) sieve, -zapfcn, m. suppository. Seuche, /. contagious or infectious disease, pestilence, epidemic. 

Method for total immersion corrosion test for tank-type aircraft maintenance chemicals Method for total immersion corrosion test for aircraft maintenance chemicals Practice for assessment of compatibility of bio-materials (non-porous) for surgical implants with respect to effect of materials in muscle and bone... 

The principle of the perfectly-mixed stirred tank has been discussed previously in Sec. 1.2.2, and this provides essential building block for modelling applications. In this section, the concept is applied to tank type reactor systems and stagewise mass transfer applications, such that the resulting model equations often appear in the form of linked sets of first-order difference differential equations. Solution by digital simulation works well for small problems, in which the number of equations are relatively small and where the problem is not compounded by stiffness or by the need for iterative procedures. For these reasons, the dynamic modelling of the continuous distillation columns in this section is intended only as a demonstration of method, rather than as a realistic attempt at solution. For the solution of complex distillation problems, the reader is referred to commercial dynamic simulation packages. 

It is assumed that all the tank-type reactors, covered in this and the immediately following sections, are at all times perfectly mixed, such that concentration and temperature conditions are uniform throughout the tanks contents. Fig. 3.10 shows a batch reactor with a cooling jacket. Since there are no flows into the reactor or from the reactor, the total mass balance tells us that the total mass remains constant. 

This type is similar in principle to the tank type, but the cooling surfaces are continually scraped or agitated to prevent the fouling by deposited crystals and to promote heat transfer. They are suitable for processing high-viscosity liquors. Scraped-surface... 

The choice between a tower-type and a tank-type reactor for a fluid-fluid reaction is determined in part by the kinetics of the reaction. As described by the two-film model... 

Tank Type II surface foam application. Foam to Tank NFPA 11-3.2.4 200 330 NFPA 11-3.2.8.2,1 hose, 50... 

Tank through-flow classifier, 22 289, 290 Tank turnovers method, 16 688 Tank type reactor, 17 594 Tanker truck hydrogen delivery, 13 853 Tannate drug complexation, 18 710... 

Selection of storage tank type to minimize potential for fire... 

Table 8-11 (API 2021) provides guidance by tank type on the potential types of fires and some general comments.

Tank Type Potential Type(s) of Fire Comments... 

Water electrolyzer units typically consist of several cells or electrodes arranged in two basic configurations, tank type operated in unipolar configuration, or filter press type operated in bipolar configuration. Tbe most common configuration, see Fig. 2.1, is the unipolar tank type where each electrode has only one polarity and all the electrodes of the same polarity are connected in parallel. The anodes and cathodes are alternately connected, with the... 

It was believed that the mine was designed for anti-invasion purposes to be placed in shallow water against landing craft, vehicles and tanks Type JG Antiboat Land Mine, which existed in 5 modifications, each being actuated by a single chemical horn screwed into the top. The mines were either bell-shaped or of a truncated cone. Each contd 22 lbs of Type 98 Explosive. The mines were fired when chemical horns were broken (pp 222-23, Fig 168)... 

---