Surface properties cells

Flotation is an important technique in mineral processing, where it is used to separate different types of ores. When used to separate solid-solid mixtures, the material is ground to a particle size small enough to liberate particles of the chemical species to be recovered. The mixture of solid particles is then dispersed in the flotation medium, which is usually water. The mixture is then fed to a flotation cell, as illustrated in Figure 8.12a. Here, gas is also fed to the cell where gas bubbles become attached to the solid particles, thereby allowing them to float to the surface of the liquid. The solid particles are collected from the surface by an overflow weir or mechanical scraper. The separation of the solid particles depends on the different species having different surface properties such that one species is preferentially attached to the bubbles. A number of chemicals can be added to the flotation medium to meet the various requirements of the flotation process ... 

The sole purpose of the filter support and any applied extracellular matrix is simply to provide a surface for cell attachment and thus to provide mechanical support to the monolayer. However, the filter and matrix also can act as serial barriers to solute movement after diffusion through the cell monolayer. The important variables are the chemical composition of the filter, porosity, pore size, and overall thickness. In some cases, pore tortuosity also can be important. It is desired that the filter, with or without an added matrix, provide a favorable surface to which the cells can attach. However, in some cases these properties can also result in an attractive surface for nonspecific adsorption of the transported solute. In these instances, the appearance of the solute in the receiver compartment of the diffusion cell will not be a true reflection of its movement across the mono-layer. Such problems must be examined on a case-by-case basis. 

Martin, R.J., Kusel, J.R. and Pennington, A.J. (1990) Surface-properties of membrane-vesicles prepared from muscle-cells of Ascaris suum. Journal of Parasitology 76, 340-348. 

SEI formation control is the key to good performance and the safety of the whole lithium ion battery, as not only anode operation but also cathode properties are strongly affected by the SEI formation process (the cathode is the lithium cation source of lithium ion cells). Apart from control of the graphite (surface) properties, an appropriate composition of the electrolyte is usually helpful for creation of an effective SEI. 

Water is involved in most of the photodecomposition reactions. Hence, nonaqueous electrolytes such as methanol, ethanol, N,N-d i methyl forma mide, acetonitrile, propylene carbonate, ethylene glycol, tetrahydrofuran, nitromethane, benzonitrile, and molten salts such as A1C13-butyl pyridium chloride are chosen. The efficiency of early cells prepared with nonaqueous solvents such as methanol and acetonitrile were low because of the high resistivity of the electrolyte, limited solubility of the redox species, and poor bulk and surface properties of the semiconductor. Recently, reasonably efficient and fairly stable cells have been prepared with nonaqueous electrolytes with a proper design of the electrolyte redox couple and by careful control of the material and surface properties [7], Results with single-crystal semiconductor electrodes can be obtained from table 2 in Ref. 15. Unfortunately, the efficiencies and stabilities achieved cannot justify the use of singlecrystal materials. Table 2 in Ref. 15 summarizes the results of liquid junction solar cells prepared with polycrystalline and thin-film semiconductors [15]. As can be seen the efficiencies are fair. Thin films provide several advantages over bulk materials. Despite these possibilities, the actual efficiencies of solid-state polycrystalline thin-film PV solar cells exceed those obtained with electrochemical PV cells [22,23]. 

N3. Nicolson, G. L., Cancer metastasis, organ colonization and cell surface properties of malignant cells. Biochim. Biophys. Acta 695, 113-176 (1982). 

---