Spectroscopy benzene derivatives

Table 7.9 Electronic Absorption Bands for Representative Chromophores Table 7.10 Ultraviolet Cutoffs of Spectrograde Solvents Table 7.11 Absorption Wavelength of Dienes Table 7.12 Absorption Wavelength of Enones and Dienones Table 7.13 Solvent Correction for Ultraviolet-Visible Spectroscopy Table 7.14 Primary Bands of Substituted Benzene and Heteroaromatics Table 7.15 Wavelength Calculation of the Principal Band of Substituted Benzene Derivatives...

Nuclear Magnetic Resonance Spectroscopy. Nmr is a most valuable technique for stmeture determination in thiophene chemistry, especially because spectral interpretation is much easier in the thiophene series compared to benzene derivatives. Chemical shifts in proton nmr are well documented for thiophene (CDCl ), 6 = 7.12, 7.34, 7.34, and 7.12 ppm. Coupling constants occur in well-defined ranges J2-3 = 4.9-5.8 ... 

Treatment of ethyl 2,7-di-/ert-butylthiepin-4-carboxylate (24) with 3-chloroperoxybenzoic acid at — 78 °C results in the benzene derivative 25 only, and no sulfur-oxidized products 80 however, the stable 2,7-di-ter/-butylthiepin (26) can be oxidized with 0-benzyl 00-hydrogen monoper-oxycarbonate at — 78 °C to give the corresponding S-oxide 27, which was monitored by HNMR spectroscopy at — 40°C. At —15 C, sulfoxide 27 was converted, via extrusion of sulfur monoxide, with a half-life of 5.5 hours to the benzene derivative 28.87 The oxidation reaction of 26 with excess of the monoperoxycarbonate did not proceed to the S,S-dioxide, even though the parent thiepin 1,1-dioxide is known to be stable at room temperature.15... 

A molecular structure, similar to that of hexasilylated benzene derivative 229, was obtained from tetracyclic hexasilylbenzene 230 by Kira, Sakurai and coworkers, where the six silicon centres are incorporated in three five-membered ring systems (Scheme 80) °. In dimetalated compound 231, two lithium centres, coordinated by a quinuclidine ligand each, are capping the phenyl ring plane from both sides in the solid state. Moreover, it could be found that compound 231 has a thermally accessible triplet state, investigated by temperature-dependent ESR spectroscopy °°. 

M n Part II we spend a lot of time and pages on aromatic systems, starting with benzene. You examine benzene s structure, its resonance stabilization, and its stability. Next you study benzene derivatives and heterocyclic aromatic compounds, and then we address the spectroscopy of these aromatic compounds. And in Chapters 7 and 8 we introduce you to aromatic substitution by both electrophiles and nucleophiles, and you get to see a lot of reactions and a lot of examples. In this part you also start working with many more named reactions. 

This section is concerned with the quantitative correlation of reaction rates and equilibria of organic reactions with the structure of the reactants. We will restrict the discussion to benzene derivatives. The focus is on a remarkably simple treatment developed by L. P. Hammett in 1935, which has been tremendously influential. Hammett s correlation covers chemical reactivity, spectroscopy and other physical properties, and even the biological activity of drugs. Virtually all quantitative treatments of reactivity of organic compounds in solution start with the kinds of correlations that are discussed in this section. 

PhCH2=Ru(PCy3)2Cl2 catalyses the cyclooligomerization of trienes (143) to benzene derivatives (144) via a cascade of four metathesis reactions (Scheme 54).273 Isocyanate cyclotrimerization catalysed by dimethylbenzylamme-phenyl glycidyl ether-phenol has been studied by IR and PMR spectroscopy.274... 

Nuclear Magnetic Resonance Spectroscopy. Nmr is a most valuable technique for structure determination in thiophene chemistry, especially because spectral interpretation is much easier in the thiophene series compared to benzene derivatives. Chemical shifts in proton nmr are well documented for thiophene (CDC13), 6 = H2 7.12, H3 7.34, H4 7.34, and H5 7.12 ppm. Coupling constants occur in well-defined ranges J2 3 = 4.9-5.8 J3 4 = 3.45-4.35 J2 4 = 1.25-1.7 and J2 5 = 3.2-3.65 Hz. The technique can be used quantitatively by comparison with standard spectra of materials of known purity. 13C-nmr spectroscopy of thiophene and thiophene derivatives is also a valuable technique that shows well-defined patterns of spectra. 13C chemical shifts for thiophene, from tetramethylsilane (TMS), are C2 127.6, C3 125.9, C4 125.9, and C5 127.6 ppm. 

Before spectroscopy was invented, Komer s absolute method was used to determine whether a disubstituted benzene derivative was the ortho, meta, or para isomer. Komer s method involves adding a third group (often a nitro group) and determining how many isomers are formed. For example, when o-xylene is nitrated (by a method shown in Chapter 17), two isomers are formed. 

Although the valence ji-ji excitation spectra of benzene derivatives have been extensively studied over the past 65 years both experimentally and theoretically, much less is known about that of phenol, apart from its lowest excited state. In general, absorption and fluorescence spectroscopy of a benzene ring can be used to detect its presence in a larger compound and to probe its environment. While the relative constancy of the valence jt-n excitation spectrum allows a qualitative identification of spectral bands by a correspondence with those in free benzene, detailed quantitative differences could indicate the nature of substituents, ligands or medium. Key information on substituted benzene includes the excitation energies, transition moments and their direction, and electrostatic... 

As mentioned earlier, benzene adsorption into molecular sieves, especially into faujasite-type zeolites, was extensively studied via IR spectroscopy by Barthomeijf and colleagues [792,793]. IR investigations of adsorption of benzene and especially simple benzene derivatives (toluene, ethylbenzene, xylenes) on zeolites were largely related to problems of diffusion (cf. Sect. 5.6.4) and catalytic reactions such as alkylation and isomerization (see Sect. 5.6.3). 

Examples of IR investigations of the type discussed earlier, i.e., of interactions of benzene derivatives with zeoHte catalysts, where the aromatic ring of the reactants is involved, are also given by the studies of xylene isomerization [898,899]. In fact, here are features of sorption and diffusion involved (cf. Sect 5.6.4). Similarly, isomerization ofp-ethyltoluene (band at 1515 cm" ) to m-ethyltoluene (band at 1491 cm" ) was observed via in-situ FTIR spectroscopy by Zikanova et al. [900]. 

However, another type of reactions of benzene derivatives was studied by in-situ IR spectroscopy as well, viz. the side-chain alkylation of alkylbenzenes, for instance of toluene, over basic zeolite catalysts such as M -X zeolites (M=Na, K, Rb, Cs) [901,902]. The intermediate conversion of methanol to formaldehyde turned out to be crucial for the side-chain alkylation as well as a strong polarization of the methyl group of toluene, the preferential adsorption of toluene, and a sufficient basicity, i.e., base strength of the catalyst. Related to these IR studies of side-chain alkylation of toluene were in-situ IR spectroscopic investigations of the decomposition of methanol over basic zeolites (M+-X, M =Na+, K+, Rb, Cs+ Na-ZSM-5 and Cs-ZSM-5 [903]). It was shown that over weakly basic zeolites (Na-ZSM-5, Cs-ZSM-5) dimethyl ether was formed from methanol, whereas over more strongly basic X-type zeolites formaldehyde was produced, which is an indispensable intermediate for the side-chain reaction (vide supra). 

---