Solubilization coefficient

Thus, for the effective charge separation in micellar systems, the most convenient location of the reactants is at the interface, and after the reaction, one of the products should exit into the bulk phase. This product should have a very small solubilization coefficient. The other charge carrier produced should move towards the micelle nucleus. If one aims to obtain very long relaxation times, it is possible to overcome the difficulties of obtaining a very strong change of the solubilization coefficient due to... 

Table 4.1.9. Solubilization coefficient Ku for a number of organic solutes in different micelles ...

Calculations usirig this value afford a partition coefficient for 5.2 of 96 and a micellar second-order rate constant of 0.21 M" s" . This partition coefficient is higher than the corresponding values for SDS micelles and CTAB micelles given in Table 5.2. This trend is in agreement with literature data, that indicate that Cu(DS)2 micelles are able to solubilize 1.5 times as much benzene as SDS micelles . Most likely this enhanced solubilisation is a result of the higher counterion binding of Cu(DS)2... 

Lysol consists of a mixture of the three cresol isomers solubilized using a soap prepared from linseed oil and potassium hydroxide, to form a clear solution on dilution. Most vegetative pathogens, including mycobacteria, are killed in 15 minutes by 0.3—0.6% lysol. Lysol has a phenol coefficient of 2. Bacterial spores are very resistant. Lysol is also the name of a proprietary product, the formula of which has changed over the years other phenols have been substituted for the cresols. 

The solubilization of amino acids in AOT-reversed micelles has been widely investigated showing the importance of the hydrophobic effect as a driving force in interfacial solubihzation [153-157]. Hydrophilic amino acids are solubilized in the aqueous micellar core through electrostatic interactions. The amino acids with strongly hydrophobic groups are incorporated mainly in the interfacial layer. The partition coefficient for tryptophan and micellar shape are affected by the loading ratio of tryptophan to AOT [158],... 

A detailed descriphon of octanol-water distribuhon coefficient measurements by shake-flask can be found in publications by Dearden [2] and Hansch [24], The method usually involves the following solubilization of the compound in a mixture of mutually presaturated buffered water and octanol, agitation unhl equilibrium has been reached, careful separation of octanol and aqueous phases, and direct measurement of the solute concentration in both phases. Although seemingly simple, the method has a number of caveats making it inappropriate for some compounds. 

Two hypotheses have been proposed to explain how phenolic acids directly increase membrane permeability. The first is that the compounds solubilize into cellular membranes, and thus cause a "loosening" of the membrane structure so that minerals can leak across the membrane (28-30, 42). Support for this hypothesis comes from the fact that the extent of inhibition of electrical potentials correlates with the log P (partition coefficient of a compound between octanol and water) for various benzoic and cinnamic acid derivatives (Figure 5). 

An alternative method to overcome the solubility problem mentioned in the last section is to use bile salts to solubilize lipophilic molecules in the donor wells. Figure 7.51 shows a plot of relative permeability (Pe without bildPe with bile) versus membrane retention, which is related to lipophilicity (Section 7.7.2). As the plot shows, the most lipophilic molecules (carvedilol, propranolol, and verapamil) have attenuated permeabilities (by a factor of 3 in the case of carvedilol). The effective partition coefficient between the PAMPA membrane phase and the aqueous phase containing bile salt micelles [577] is expected to be lower for lipophilic molecules, which should result in lower Pe values. This is evident in the figure. 

Higher phytoextraction coefficients indicate higher metal uptake. The effectiveness of phytoextraction can be limited by the sorption of metals to soil particles and the low solubility of the metals however, metals can be solubilized through the addition of acids or chelating agents and so allow uptake of the contaminant by the plant. Ethylene diamine tetra-acetic acid (EDTA), citric acid, and ammonium nitrate have been reported to help in the solubilization of lead, uranium, and cesium... 

Fluorescence quenching studies in micellar systems provide quantitative information not only on the aggregation number but also on counterion binding and on the effect of additives on the micellization process. The solubilizing process (partition coefficients between the aqueous phase and the micellar pseudo-phase, entry and exit rates of solutes) can also be characterized by fluorescence quenching. 

An indirect indication of the presence of interactions between micellar phase and drugs is given by molecular and dynamic parameters of the drug and the micelles (ionic mobility, diffusion coefficient, hydrodynamic radius, apparent molecular mass), which are altered by the solubilization of lipophilic substances in a significant manner. 

---